Question about 2007 Jeep Amc

1 Answer

Power jack aquired used cb from yard sale no power jack need to know dc polarity at sockit. Midland mod 77-001 mfg 1982. + & - left to right ? or photo would be perfict. Thank you David Johnson

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

Center point is posative....outer ring is ground...

Posted on Jan 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the procedure for removing the power steering pump


1982 Chrysler New Yorker Power Steering Belt Removal ...

? 0:35
www.youtube.com/watch?v=vZD17F_ao-o
Jan 18, 2015 - Uploaded by Kerman 559 Sanchez
1982 Chrysler New Yorker Power Steering Belt Removal ...1990 Chrysler New Yorker Fifth Avenue Start Up, Engine, and In Depth Tour ...

1990 chrysler new yorker 3.3 power steering pump change ...

www.fixya.com/cars/t15056742-1990_chrysler_new_yorker_3_3_power
Nov 18, 2012 - SOURCE: 1990 new yorker alternator replacement. You are right aboutremoving the motor mount. You have to support the engine with a jack.
images for 1990 Chrysler New Yorker remove power

Oct 20, 2015 | 1990 Chrysler New Yorker

1 Answer

Left turn signal will not work. Right signal works fine.


You need to replace the sockit where the bulb goes. Not expensive at all. Ebay has them. See ya. RC

Oct 06, 2014 | 1998 Jeep Cherokee

3 Answers

Why does my midland cb radio whine when I crank and rev the motor up


you midland cb is picking up interference from the other electronics in your car/truck(ecu) etc, it helps to connect power source directly to the battery or you can buy an inline noise reducer that goes onto your power line

Dec 27, 2012 | Cars & Trucks

1 Answer

I want to install a aftermarket stero cd player in 1998 zx2 ford escort


Car stereo cd player are 12 volt you can connect polarity to battery line1 positive(+) and line 2 negative(-) need a fuse 2 ampere for line 1 protection for continue use and the speaker are left and right at the back or RCA jack red and white color or either.

Oct 21, 2012 | Ford Escort Cars & Trucks

1 Answer

Need to wire sockit on toebar need help with wire colour aliment


green, right turn /right brake yellow(or red with really old stuff) left turn/brake, brown, running lights(GOES TO BOTH SIDES) and usually what's left is white, which would be your ground. Good luck

Mar 10, 2011 | Toyota Highlander Cars & Trucks

4 Answers

What is the firing order for a 1984 ford bronco 2


1-4-2-5-3-6
Now you need to know which cylinder is which. If you stand at the front of the truck looking at the engine, the number 1 cylinder is on the left closest to you. The left bank has cylinders 1-3-5 and the right bank has 2-4-6. So number 1 is at the left front and number 6 is at the right rear.

Jan 25, 2010 | 1984 Ford Bronco II

2 Answers

The driver seat heater just quit. all fuses are good. how do you tell if the relay is good?


Swap it with a relay you know to be good and see if it works again,pick a relay that is not important to the function of your car.

Nov 01, 2009 | 2004 Cadillac SRX

1 Answer

We need a new seatbelt for the rear right seat. Patrick Smith pses_smith@juno.com


it takes a one inch sockit take them off go to the auto junk yard 20$ it is ez

Aug 14, 2009 | 1992 Pontiac Trans Sport

1 Answer

Wiring Trailer hook ups on truck


  • 4 way flat connector
  • brwn-tail lights
  • yellow-left turn
  • green right turns
  • white ground
  1. 5 way connector
  2. brwn tail light
  3. yellow left
  4. green right
  5. white grnd
  6. blue back up for surge brakes
i know of some more kinds but the 4 and 5 flat are the most used on trailers...word!

Mar 26, 2009 | 1982 Ford F 250

2 Answers

Cb radio


Usually red is for switched power and orange is constant power.
Orange will go directly to 12V constant supply. This retains memory.
Red will go to switched (ignition) 12Vsupply. this turns it on and off with the car.
Black is ground.

Jan 09, 2009 | 2000 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...