At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
actually i went under the steering wheel and found the turn signal wire harness to be loose unbelivable all is working nicely nowactually i went under the steering wheel and found the turn signal wire harness to be loose unbelivable all is working nicely now
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Tes the brake light switch, to do this go under the dash and locate the switch, ues a 12 volt test light, (avail at any auto part store), you should have power into the switch and out with the brake pedal depressed.
A bad ground on the middle lights could cause the brake light to go out. Also, a bad ground on the brake light would cause it to go out. Check all your grounds.
A lack of power to the 2 middle lights shouldn't cause that problem. See if the wires to the middle lights tie onto wires for other lights and check right there for voltage.
Check your fuse, if the fuse is good, go on back from there to the lights that aren't working.
That's how I'd do it, anyway. Garcuda
1) Check your rear lamps to see if they are burnt. 2) There is a brake light switch behind the brake pedal. you may have a broken wire or the switch may need to be replaced.
I believe you are referring to the "Elevated Brake Light". These lights are mounted in various places depending on the vehicle. Most cars have them mounted on the back deck but it appears yours is mounted inside the trunk lid. In most states, a car must have all lights(including the elevated brake light) functioning to pass vehicle inspection.
Check your fuses of course,you probably did.Listen your not going to believe this,the wire at the brake light switch can be bad.sometines the wire can break inside the vinyl cover just a milameter.use a test light for presence of voltage at the switch and check a few inches back to see it voltage is present. MAKE SURE YOU HAVE VOLTAGE AT THE SWITCH!
Replace the turn signal switch. If you want to prove this have someone stand behind the car with your foot on the brake. Then wiggle the turn signal lever. The brake lights should blink. This is a real common problem with W body. I have replaced two on my cutlass plus tons more at my shop.
actually i went under the steering wheel and found the turn signal wire harness to be loose unbelivable all is working nicely now
×