Today while driving my radio turned off (no lights or anything), then almost all of my warning lights came on, when I pushed the gas pedal it just sputtered, then when I pushed it again, it went back to normal and the lights went off and the radio back on. After about 1/2 mi the same thing happened again and continued to happen about every 1/2 to 1 mile.

https://www.theglobeandmail.com/globe-drive/culture/commuting/the-easiest-way-to-turn-off-your-cars-check-engine-light/article14223025
How to Reset the Warning Light Gas Cap That Is Loose or Missing

1. Turn off your vehicle's engine. Push button to unlock the gas cap door, if your vehicle is equipped with a locking gas cap door. ...
2. Step to the gas cap door. Open the door. ...
3. Replace the gas cap. ...
4. Close the gas cap door. ...
5. Use an OBD-II code scanner if the warning light does not disappear. ...
6. Continue driving the vehicle.

drive, until the engine seizes?
open glove box, take out operators guide.
and what does it say on all cars made? RTM !
"get it servicee now."
CEL lamp on some are called SES
service engine soon.
the today , this means (ANYTHING can be bad, get it serviced)

my car can even send me RADIO failure codes, not just engine.
scan it.

check your throttle pedal position switch and your throttle position sensor

I’m happy to assist further over the phone at https://www.6ya.com/expert/brock_d67526d2a834c47e

You may just need to reset your throttle sensor. There is no hard connection between the gas pedal and the engine its electronic. To reset :

All auxiliary systems must be off (radio, lights.aircon, etc) no electrical drains or CAN signals can be triggered during the process.

Turn the Key to the "on" position (the position right before you start your engine)

Press and hold your gas pedal down for 5-10 seconds

Turn Key to "off" position (dont remove the key) and then release the gas pedal. than wait 2 minutes, for the system to reset. Again without touching anything or having anything on.

Thats should do it. When you replace the battery you usually have to do the radio code, yaw steering sensor, throttle and sometimes transmission. On my last battery just had to do the radio but was expecting to do all.

Most likely a shift solenoid in the transmission.

broken ground wire on the chassy

Sounds like your transmisson is going, i had the same problem.

You need to reset your change oil warning light. To do this, turn the ignition key to on but do not turn over the engine. Then rapidly push down the gas pedal three times. This will reset the system and turn off the blinking light. Then when you drive another 3000 miles, that light will once again tell you it is time to have your oil changed. J.

make sure the oil level is up to full. sorta sounds like its low and when you go around a corner the oil sloshes away from the pickup tube

The oil warning light indicates no oil pressure, changing the oil would not affect the light. You should not drive the car if this light is on, because if it is operating correctly, you will ruin your engine. The car should be checked immediately, and not driven until the cause of the light being on is determined.
good luck, and let me know the outcome. countrycurt0