Question about 1992 Buick Riviera

1 Answer

How do i pull up the error codes? Using the climate control?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

On the climate control hold the warmer and off button together at the same time the check engine light will start flash and the dash should beep at you or something i believe that's how it works in my 86

Posted on Jan 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the vaccume color code


That would be in the factory service manual. We do not have any manuals. You can access the manual for a small fee here. www.alldatadiy.com

Apr 11, 2012 | Cars & Trucks

1 Answer

Aircondition system wont work although parts are new


Your system air condition is controled by a climate control.The panel will be at fault,You can pull a code using a scan tool that reads MBZ climate control,The solution for the fix is the climate control this is a module

Mar 08, 2012 | 2003 Mercedes-Benz E-Class

2 Answers

CHECK ENGINE LIGHT COMES ON . RAN DIAGNOSTIC CHECK THROUGH CLIMATE CONTROL. NO CODES COME UP.


DID YOU SIMULTANEOUSLY PRESS THE OFF AND WARMER BUTTONS ON THE CLIMATE CONTROL PANEL.IF THIS DONT WORK TAKE CAR TO AUTO ZONE THEY WILL USE A SCANNER TO PULL UP THE TROUBLE CODE.THEY WILL DO IT FREE.

Jun 12, 2010 | 1995 Cadillac DeVille

1 Answer

Replaced the climate control and blower wont work


f that just put power to the blower moter and see it it runs if you pull the relay jump a wire across the terminals with it out and add a ground wire to the case of the blower to another spot on the chasis if it still does not run your blower switch may be bad dont worry just run a toggle switch to a good blower moter

Feb 28, 2010 | 1998 Pontiac Grand Prix

1 Answer

The a/c sounds like it is blowing but no air is coming out of the vents only happens on long drives


This paticular climate control system uses stepper motors unstead of vacuum elements to control the blend door positions. The best way to diagnose this problem is to have the climate control computer scanned for codes and then you will have a beter idea of which component is failing. You can pull codes riht from the climate control head unit but you would need to purchase a factory manual to explain how to do this and what the codes mean.

Jul 13, 2009 | 2001 Mercedes-Benz C-Class

1 Answer

Ac switch light


Illumination Bulbs — A/C Switch
Removal
  1. Disconnect the battery ground cable (14301).
  1. Remove the shift console panel. Refer to Section 01-12 for the removal and installation procedure.
  1. Remove the three climate control assembly screws.
  1. Disconnect the climate control assembly electrical connector.
  1. Depress the tabs on the air door shafts and remove the three climate control cable ends. Pull the climate control assembly from the vehicle.
  1. Remove the A/C switch electrical connector.
  2. Depress the tabs on the A/C switch and remove the A/C switch from the climate control assembly.Twist and pull out to remove the A/C switch miniature bulb from the A/C switch.

Jan 09, 2009 | 1997 Ford Aspire

2 Answers

A/c climate control


DISCONNECT THE BATTERY FOR 10 MINUTES OR SO, THIS WILL ERASE THE CODES, BE ADVISED IF THE PROBLEM THAT SET THE CODES IS UN-REPAIRED WILL BE SET AGAIN.

PLEASE RATE THIS SOLUTION, THANKS .

Oct 22, 2008 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

2 Answers

Error Codes


These may have been set by the battery change and are what GM calls phamtom codes, clear the codes with the following.
Try this and see if the codes go away.

1. Re-enter diagnostics via the climate control panel and after all the codes appear you will see .7.0

2. Simultaneously push and hold the OFF and HI (^) buttons on the climate control panel until you see E.0.0 and release both buttons.

3. Turn ignition key OFF, Wait 15 seconds and re-enter diagnostics and see if the codes reappear. If they do NOT reappear, You are good to go.
After you have done this try starting the engine and see what codes re-appear, also run and OBD 2 test of the system at the diagnostic connector, this will give P codes that we are better able to find definitions for, the E codes are unique to just a few GM cars.

Oct 13, 2008 | 1993 Cadillac DeVille

1 Answer

Electrical Problem with 90' Cadillac Sedan Deville


the climate control is intergrated through the pcm and ecm i would advise you to take the vehicle to the service shop they have a diagnostic scanner that will access the ecm and either clear a code that prevents the climate control from working or find a more severe problem that requires you to replace the hole unit. please rate this solution. thank you and good luck.

Aug 29, 2008 | 1990 Cadillac Deville

Not finding what you are looking for?
1992 Buick Riviera Logo

Related Topics:

314 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...