How to replace stop light bulb in 2010 dodge caliper

It is literally called a rear brake caliper tool. You should be able to find one at any part store like Pep Boys, Autozone, or Oreillys.

Have you recently replaced the bulbs?

front or rear cause ya may not have to remove any screws on headlight assembly's ya have to get to the back where the wires hook up and twist the socket to get to the bulb same on tail lights but ya have to go through the trunk

This info is in your owners manual. For the rear lamp assembly, you open the trunk, pull trunk liner back a little from lamp assembly, remove two wing-nuts, pull on the lamp assembly and push on the wing nut studs to remove lamp assembly. The bulb socket twists out of the lamp assemble. Replace the bulbs. replace lamp assembly.

Replace the bulb in the front lens to get the mirror and marker to work. Replace the the bulb for the reverse light also. Both are on seperate circuuits.

did you take the bulb assembly out, open the trunk,on either side behind the light there are two wing nuts, remove them and the assembly comes out, unplug the light and remove the bulbs, they will un clip from the back,two receptacle, id replace both bulbs, and keep the good one for a spare, put it back together takes about 30 minutes, Matt

fuse or chang the head light bulb

Only the rust lip on the rotor holding it on

Sand down some of the outer edge or just
pull the caliper toward you, to compress the piston

Those rotors will need machining

Try the Raybestos Ceramic Pads

You have to rent the tool from autozone about 60 dollars refundable. The tool will reset the caliper by turning it in, the front you can use a C-clamp. Be very careful to turn the caliper in the correct way. Inquire clockwise or counter clockwise at the counter of autozone or rental auto supply store.

there should be a fixture in the boot/trunk that holds the lights,that clips into a panel, find the clips that hold it in and release the lights fixture then you can change the bulb, clip fixture back in