Question about 2004 Jeep Grand Cherokee

1 Answer

Jack Location for Tire Change

Where do I place the Jack on a 2004 Jeep Grand Cherokee to lift the Jeep for changing a Tire.
I lost my manual

Posted by on

  • 1 more comment 
  • Anonymous Mar 12, 2014

    change tire placing the jack

  • Anonymous Mar 18, 2014

    where do I place tire stands to rotate tires on a 2012 equinox

  • Anonymous Apr 01, 2014

    what more do ya need to know then that need to know the steps to change the clutch cable so how do you change the dumb dam thing do ya need more then that ,what sockets do I need to have do i need to take off the tire ? uh, should I jack up the car on jacks? well ??

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Under the back seats, jack is under the driver's side backseat, tire iron & rods are under passenger's side backseat.

Posted on Aug 24, 2008

  • joe121212 Aug 24, 2008

    nevermind...missed that one obviously

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Height of a factory jack for a jeep grand cherokee laredo 2004. I recently discovered the jack was missing - how high must the replacement jack go (scizzor or Bottle) necessary to thange a tire


If dont remember bad, at '02 came with scissors, after '03 and upper came with bottle.

This is my suggest, 6-21" lift, seems like a good size for the WJ. Moderately priced.
Michelin 2½-Ton Jack $89.99 (CDN)
* Hydraulic Speedy Lift is a patented design - the fastest way to reach car chassis
* 6" - 21" maximum height is ideal for SUVs
* Wider jack stance increases overall stability of the jack
* Unique design combines aesthetics and strength in the overall jack design
* Universal joint ensures smooth release and secure valve operation from any pumping angle
* Storage tray is ideal for keeping track of small parts or hardware
* Saddle pad helps prevent damage to vehicle during lifting

Keep in mind the use that your Jeep is very important, also if your like to practice off-road tours.

Hope this helps.

Apr 16, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Can't find the jack stowage on my '06 Jeep Grand Cherokee


It is underneath the donut tire. 1st you have to lift up the carpet in the back, then the "door". Now pull out the donut tire and the Tire Jack is underneath. We had to do a search and rescue on ours years ago and had a terrible time finding it too!!

Nov 28, 2010 | 2006 Jeep Grand Cherokee

1 Answer

Where do i place a jack stand on a 1995 Jeep Grand Cherokee?


Hope this helps and please don't forget to rate...thanks!

Jacking points on all Jeep vehicles



c17hydro_1.gif

Your Jeep was supplied with a jack for emergency road repairs. This jack is fine for changing a flat tire or other short-term procedures not requiring you to go beneath the vehicle. Do not attempt to use the jack on any portions of the vehicle other than specified by the vehicle manufacturer. Always block the diagonally opposite wheel when using a jack.



c17hydro_2.gif

Placing a floor jack under the front frame rail



c17hydro_3.gif

Placing a floor jack under the rear frame rail at the leaf spring shackle. It may be necessary to place a block of wood between the frame rail and the jack



c17hydro_4.gif

Supporting the front of the vehicle with jack stands placed under each frame rail


A more convenient way of jacking is the use of a garage or floor jack. You may use the floor jack at the specified points in following the illustrations.

Never place the jack under the radiator, engine or transmission components. Severe and expensive damage will result when the jack is raised. Additionally, never jack under the floorpan or bodywork; the metal will deform



c17hydro_5.gif

Support the rear of the vehicle using jack stands placed underneath each side of the rear differential (inset photo)

Nov 04, 2010 | 1995 Jeep Grand Cherokee

1 Answer

How do I change tire on 2006 jeep


The owner manual will tell you the jack location and the jacking points. Loosen the lugnuts half a turn before you jack it up. Jack it up and remove the nuts. Put on the spare, and reinstall the nuts and run them down. Lower the car and tighten the nuts as tight as you can get them. Then drive the car to a tire shop. The spare is a temporary spare.

May 16, 2010 | 2006 Jeep Grand Cherokee

1 Answer

Where is a tire jack located in a jeep grand cherokee


in the back fold the rear seats down there is a small cover flip it up they r stored in there

Oct 25, 2009 | 2004 Jeep Grand Cherokee

1 Answer

How do you change a back tire with the standard jack on a 2007 jeep cherokee


with tires blocked, transmission in park emergency brake on, vehicle off the road, you first break loose the lug nuts slightly then raise the jeep and remove the lug nuts, reversing the procedure after replacing the tire.

Oct 22, 2009 | 2007 Jeep Grand Cherokee Overland

1 Answer

What are the best jack points for my '94 Jeep grand cherokee?


Best place for jack is under the end of the axle tube, just before trailing arm attachment point. This will lift axle and tire without extending the suspension. This also depends upon what the ground is like where vehicle is parked. If ground under axle is soft, you can place the jack under the chassis to avoid having the jack fall over or sinking in. Or, if you can, move to more solid ground. What's more important is where not to put the jack...never place it where a suspension arm is attached, on a suspension arm that will change angle as it is going up, on a floorboard or anywhere it will crush a brake or fuel line. If you travel where ground is usually soft, carry a 1" thick 20x20 square of plywood (I carry same made from 1/2" steel. Use it under the jack to spread the load). Though "factory" jack will do the job, I suggest you invest in a halfway decent floor jack with a locking pin (a bit more reliable and safer)

Jul 18, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Jack position to change rear tire 98 pontiac grand prix


factory jack to be placed in front of tire inbetween notches on seem. A manual floor jack can be used placing it under center connection bracket for rear wheels. Be shure to block front tires when using floor jack and have car in gear if a manual or park if automatic transmision.

Mar 31, 2009 | 2002 Pontiac Grand Prix

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

914 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...