Question about 1995 Ford F250

1 Answer

Dying while braking or down shifting at low rpm

Won't start without ether. problem has been for a while. recent, though, when down shifting at low rpm or braking, truck will die. changed filter and started, of course, with ether, and it ran fine shifting and braking until went to station to get gas and it died while braking to pull into parking lot. I have no experience with diesel engines but am not mechanically dumb. Any suggestions would be greatly appreciated. Thank you.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

STARTING HARD SHOULD BE A BAD GLOW PLUG AND DIEING OUT WHEN DOWN SHIFTING OR BRAKING ON THE PASS SIDE FRONT BOTTOM OF BLOCK THIER IS A LOW PRESSURE MECHANICEL FUEL PUMP WITH A PIECE OF RUBBER HOSE IF IT IS KINKED OR BAD IT WILL CAUSE THAT

Posted on Aug 26, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I recently purchased a 1987 toyota celica gt-s. I am dealin with an idle problem/loss of power. Just recently it started acting up. At first it was only happening when i was shifting into second. Shifted...


Check for code there is a small electric boxe may be 1 inch by 1.5 inch you have to jump 2 wire to get code at dash (long blink digit and fast blink unit)

May 04, 2014 | Cars & Trucks

1 Answer

When putting car in R or D car dies


fuel issue possibly MAP sensor or tps sensor? any check engine light?? transmission not shifting??

Feb 18, 2014 | Chrysler Voyager Cars & Trucks

1 Answer

When putting car in reverse or drive car dies


sounds like your automatic transmission is stuffed, take it to a mechanic for a second opinion but it seems to me like you'll need to either rebuild or replace the transmission

Feb 18, 2014 | Chrysler Voyager Cars & Trucks

1 Answer

I have a 2001 honda civic ex 1.7 liter, and when I have to brake suddenly the car idles down really low like its wanting to die. Is this the timing


I doubt it very much. The engine slowing down under brakes indicates that the gears are not down shifting in relation to the engine rpm and road speed. run fault codes and look for a TCM sensor problem

Sep 11, 2013 | Cars & Trucks

1 Answer

44re 1999 durango won't start from start easily. High RPM and SLOW start (like not in 1st)


the second code is govener pressure sensor. the pressure is to low. the first code is sensor voltage to low, i would check the wiring where it plugs into trans for corrosion. also make sure the kick down cable on the throttle is connected and not broke because this cable controls the line pressure.

Mar 12, 2013 | 1999 Dodge Durango

1 Answer

Hi, I have a 1999 Mercury Villager with the 3.3 Litre Nissan motor. Just recently my cousin replaced the timing belt, and distributor. When we got the van back it was having transmission problems. When you...


I would start by making sure the Trans Fluid level is correct. If the level is good, it sounds like your internal pressures are leaking down, and that is why it slips out of gear. Which means you have internal trans issue which would require the trans to be most likely removed and repaired.

Thanks Jay!

Jul 09, 2011 | 1999 Nissan Quest

2 Answers

I HAVE A 1998 CADILLAC CATERA V6 AUTOMATIC ENGINE DIES IN DRIVE


Yes, most likely a fault in the auto transmission, and the car has shut itself off to prevent further damage.

Aug 03, 2009 | 1997 Cadillac DeVille

1 Answer

I have a 2006 jeep grand cherokee 4x4 5.7L HEMI. I took in the vehicle for the 30k service a few weeks ago (spent $1,000) dollars, and now i notice the following issues: when i start the vehicle, have the...


It sounds like the technician ether unplugged or damaged your idle air speed sensor. I would return the cherokee and file a complaint. Armed with the knowledge of the possible problem you may come out of this with the job done correctly. Hope this helps. Good luck cj2176.

Jul 25, 2009 | 2006 Jeep Grand Cherokee

2 Answers

Car won't shift from P to R auto trans in Nissan Pathfinder 2008


With the ac, sounds like you definitely have a short with the ac electrical wires. Have a mechanic check that out. 2. The wiring for the dashboard gauges may have tears or something is causing high resistance in them or you may need a new dashboard itself. Have that checked too.

As far as the brakes when you trying to change gears, what do you mean brake lock wont open? Finally with the RPM, I dont think your dashboard gauge is working correctly so you may need that replaced also.

Jun 18, 2009 | 2005 Nissan Pathfinder

Not finding what you are looking for?
1995 Ford F250 Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

64286 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...