Question about 1996 Chevrolet K1500

2 Answers

Went to turn on fan knob to position 3 it ran for a few seconds then it stop .then I tried all other position the only one that work was 5th position

Posted by on

2 Answers

Replace the blower motor resistor, which is located behind the glove box.

Posted on Oct 23, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Replace switch

Posted on Aug 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fan speed control knob works sometimes and doesnt work at others. No definite reason why. What would cause this and how would i replace it?


Sounds like a loose wire or bad connection. Try accessing the rear of the knob and make sure all cables are securely fixed (it may be a spade fitting or a soldered connection). If you can follow the wires back to the fan check these as well paying particular attention to any connector block that you come across.
It is possible the knob itself is faulty and the circuit/connection makes and breaks randomly, in which case the only option is to replace it

Nov 10, 2015 | 2005 Kia Sedona

1 Answer

I ran out of gas, I tried to pump the air line by pushing in the knob valve to release the air in the gas line, not sure if this is the right valve, it's a 2002 grand am, do you have a picture where the...


Just turn the key on, wait for a few seconds, turn it off. Turn it on again, wait for a few seconds, and repeat this about 5 or six times. Then turn the engine over and see if it will start. When you first turn the key to the "run" position, you should be able to hear the fuel pump cut in for a couple of seconds, and then stop. Listen at the gas cap if you can't hear it from leaning under the car.

Jan 09, 2011 | 1999 Pontiac Grand Am GT

2 Answers

Car has set for a year, but was working fine before it began to sit. Now when I try to start it it wont start. Changed the battery and sprayed starter fluid in the carburetor, it started for a moment then...


This may be a fuel injected engine. On some vechicles when they run out of gas you have to turn the key, but not try to start the car. Give it a few seconds for the gas to feed back through the gas line. Once you turn the key, the fuel pump will start pumping the gas to the engine for the carburator. If that does not work, then give it a little gas, no too much or you could flood the carburator. Try to start the car again.

Nov 27, 2010 | 1999 Lincoln Continental

1 Answer

We have a 2000 dodge avenger with what we believe is an after market security system. It belongs to our son. He left an interior light on and ran the battery down. He jump started it and drove it for 30...


Hi,

Make sure that the battery is not DEAD. Now, to be precise , there is no hard and fast rule. You could use the tricks below but if that would not work, you need to tow the vehicle to dealer. Unfortunately, there is nothing much a customer can do in this case.

First of all unplug all battery connection and then reconnect them after few minutes. Check, if that could improve the situation.Secondly, take first key, turn the ignition to the run position. Let sit for 3 seconds. Remove key.Take second key. Turn the run position. Let it sit for 3 seconds. Remove key.Wait for 1o seconds and then try it.

What i have seen on few models, if that's a dealer installed alarm, there should be a valet or reset switch under the driver's dash that you will switch with the ignition key in the ON position to disarm the alarm. You could also try turning the switch to ON, and then installing the battery cable. Be sure you are installing the positive cable first and the negative cable last as well.

There is one more way, you could try. Turn off the ignition key, close all the doors .Wait for app. 90 seconds Unlock the door with remote ( whether door locked or not ) and open door. ( Only if you have a remote key entry ).

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Nov 01, 2009 | Dodge Avenger Cars & Trucks

1 Answer

Front heater/ac blower in 2004 Grand Caravan does not work at all


the heat or cold adjustment control in my 2002 grand caravan will only work on maximum adjustment, if you try to reduce the speed of the blower by turning the control knob 1 knot, 2, 3 and 4 down it won't work it only work at the last position which is the 5th or last turn of the control knob. please let me know what could be the problem. thanks.

Oct 03, 2009 | 2002 Dodge Grand Caravan

1 Answer

The ac stop blowing. I LOOKED AT THE FANS WHEN I


a/c knob inside the car is the first place i'd check

Sep 14, 2009 | 2003 Chevrolet Impala

1 Answer

Blower fan only works on the 4th and 5th position on my GMC Envoy


Probably need a new fan switch. They are not real hard to change.

Jul 28, 2009 | 1999 Chevrolet Express

1 Answer

Suburban 1999 abs light on dash on and doesn't work the a/c fan


If it is happening when you change the AC and Defroster Modes as Stated above, You have a Wire inside the Dash in this Location that has Shorted and is Grounding itselt to the Housing for the HVAC Controls. This could cause a fire. I would pull the HVAC Unit and try and Locate the Faulty wire Behind it.

Jan 24, 2009 | 1999 GMC Suburban

1 Answer

1998 Camry GLI temp is not stable


Does fan come on even when heater is off ? Try it in heat mode, not defrost & see if it still stays on. If yes, you need to find the relay for the fan. There may be a few that look the same, but when you pull the right one out with key on you'll know as fan will stop. If fan stops, replace the relay.Check owners manual & fuse panel , as well as under hood.

Jan 04, 2009 | 1997 Toyota Camry

1 Answer

Heater not working


The problem is probably the blower motor resistor. I'm not sure where yours is located exactly. They can be on the firewall under the hood or some are near the blower motor under the dash.

Dec 23, 2008 | 2006 GMC Sierra 1500 2WD

Not finding what you are looking for?
1996 Chevrolet K1500 Logo

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...