Question about 2002 Ford Crown Victoria

1 Answer

Adjusting headlights on 2002 Crown vic

My headlights point downward and I need to adjust but don't know how???

Posted by on

  • 1 more comment 
  • Anonymous Apr 23, 2009

    I have a 2004 Crown Vic, and one headlight is pointing toward the ground the other in ther air, the three screws that are in the back, which one does what?

  • Anonymous Mar 25, 2014

    low beam doesnot go out far enough

  • Anonymous Mar 25, 2014

    idle is too low n wont

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I noticed this is 6 months old so I don't know if you have figured it out yet but heres an answer for you. On the back of the headlights there are 3 plastic heads, they turn but spray some wd40 or something on them first. You might have to take the headlights assembly out to get a good bite on them.

Posted on Dec 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Headlights need adjusting


supposed to be pointed away from oncoming traffic
will be adjusters on them you just turn to bring them up or down shine lights on wall or door as you adjust

Oct 07, 2012 | 2002 Chrysler Town & Country

1 Answer

Need to adjust the low beams on my '02 Hyundai


Headlight adjustment is fairly straight forward, you will need to park the car on a level surface with a fence or wall 25 feet away and a reference point for measurements to the right or left of the car. First measure from the reference point to the center line of the car then transfer that to the wall, second, measure from the center of the car to the center of the headlights and transfer those to the wall, third, measure from the ground to the center of the headlights and transfer that to the wall. Once all of the reference points have been transferred, adjust the left (driver's side) headlight so that the most intense part of the beam is 2 inches below and 2 inches to the right of the left mark, the right (passenger side) headlight should be adjusted so that it will be 2 inches below and 1 inch to the left of the mark. If done correctly, you will have very good night vision without blinding oncoming traffic.

P.S. Please note that any heavy objects in the car will be a factor in correct headlight adjustment, have the car loaded as it will be normally used.

Aug 20, 2011 | 2002 Hyundai Accent

1 Answer

2001 VW Jetta Headlight adjustment. Headlights


sometimes the headlights stick to the adjusters,just pull/push(wiggle it)to free it, then try setting beams.

Apr 14, 2010 | 2001 Volkswagen Jetta TDI

1 Answer

On adjusting headlight on 08 tundra does clockwise


clock wise should pull light up. counter clock wise should tilt down

Mar 07, 2010 | 2008 Toyota Tundra

1 Answer

I need to know how to set the timing on a 2002 crown vic 281 interceptor motor


being that it'a a 2002...you can't.
It's all in the computer, so you'd hafta reprogram the computer.

Feb 04, 2010 | 2002 Ford Crown Victoria

2 Answers

Headlights point down in son's 2002 audi TT...need to adjust them. Any tips on doing this successfully? No audi dealer near us here in rural nebraska. Thank you.


Hi, are the headlamps Zenon? If they are you will need to take the car to a dealer. If they are normal halogen lamps then you can adjust them with a 6mm hex key. If you look vertically downwards at the rear of the lamp unit you'll see the adjuster about halfway down facing up at you. simply turn with the hex key until you reach the required adjustment.
Hope that helps Matt..

Nov 15, 2009 | 2002 Audi TT

1 Answer

Just a simple question.which screws lower the beam on the headlights on a 1999 crown vic?


Don't remember if you need to remove outside cover to get to it (some trim frames have an access notch) but there is one adjustment in the center top of the light frame (up/down and one on the outer edge of frame L/R) you need to adjust both because as lamp changes position it pivots slightly on the other adjustment.

Mar 28, 2009 | 1999 Ford Crown Victoria

1 Answer

Headlights need adjusting


The headlights will have small rods or adjusting screws located near the headlight mounting points. Will probably need a torx socket or screwdriver to adjust. Torx is a 6 point type screw.

Feb 18, 2009 | 1997 Pontiac Grand Prix

1 Answer

2002 crown vic


you need to jack that side of the engine up. take the right side motor mount bolt loose then jack the engine up from underneath. be sure to use a block of wood or somthing so you dont bust the oil pan

Jul 22, 2008 | 2002 Ford Crown Victoria

Not finding what you are looking for?
2002 Ford Crown Victoria Logo

717 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...