Question about 2007 Scion tC Coupe

1 Answer

Fog Lights I bought an after market fog light kit and cannot find where to plug the lights into underneath the hood. Had no problem plugging in the switch inside the car.

Posted by on

  • as1982 Aug 18, 2008

    I looked but no luck. I have looked all over and can not find a plug. The aftermarket lights have one plug and one wire to go to ground.Is there a seperate fuse for these lights? Any other insight would be a great help.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

You should see two plugs hanging in the area of the lower radiator support for them lites.

Posted on Aug 17, 2008

  • Herman Gonzalez Aug 18, 2008

    If the car had a option for fog lights when new the harness is there.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003. Why don't the fog lights turn on?


The pigtails(connector plugs) that plug into the fog lights could be corroded.Unplug them at lights check for corrosion if so you may not be able to find the plugs I believe it comes in a kit now it's the little prongs you have to replace. Best thing to do if plugs are corroded is to just cut them off and run wires directly get wire shrink connectors. You slide the wires in them, crimp and heat up and it seals the wires I did it with my fog lights works like a charm now.

Jun 09, 2015 | Pontiac Grand Am Cars & Trucks

2 Answers

2010 jeep grand cherokee laredo fog lights


If it didn't come with fog lights, it may also have not included a fog light relay and/or fuse. Check the owner's manual for fuse and relay locations, and then check if the necessary parts are there.

Apr 21, 2014 | 2010 Jeep Grand Cherokee

1 Answer

Looking for fuse for fog lights on a 2008 dodge charger. we installed a fog light kit. the car is pre-wired for them. we replaced the head light switch with the one from the kit. fog lights arent...


Check your instructions with the fog lamps, I believe you will need to take your car to a dealer to have them activate the fog lamp driver in the Totally Integrated Power Module.

Jan 23, 2011 | 2008 Dodge Charger

1 Answer

How do you replace the fog light bulb on 2008 avalanche


    • 1 Open the hood and reach down into the engine bay for the fog light assembly. If you cannot reach the fog light assembly from the top you may need to get underneath the truck to reach it. Remove the electrical plug running to the fog light ballast.
    • 2 Remove the bulb. Unlock the fog light bulb by turning it counterclockwise and pulling it straight out of the assembly.
    • 3 Slide a new bulb into the fog light assembly. The part number you will need for the new bulb will be located on the ballast or base of the old bulb.
    • 4 Turn the bulb clockwise to lock it into the fog light housing.
    • 5 Reconnect the electrical connector to the bulb ballast.

Jan 23, 2011 | 2007 Chevrolet Avalanche LTZ

1 Answer

HOW DO YOU CHANGE THE BULBS OF THE FOG LIGHTS?


The fog lights on most vehicles sit directly underneath the headlight bulbs. The ballast and wiring work just like the headlights, so changing them takes not much time. The procedure to change the fog light is as follows:-- 1) Open the hood and reach down underneath the headlights to unplug the electrical plug from the fog light assembly. Squeeze the top of the release tab and pull the connection off the bulb's ballast. 2)Turn the fog light counterclockwise to remove it from the fog light housing. 3)Install the new fog light bulb.Then connect electrical plugs properly. 4) Test the fog lights by turning it ON. Thanks. you can rate this solution and show your appreciation.

May 20, 2010 | 2002 GMC Yukon XL

1 Answer

How do u change a bulb in the fog lights on a


The fog lights on most vehicles sit directly underneath the headlight bulbs. The ballast and wiring work just like the headlights, so changing them takes not much time. The procedure to change the fog light is as follows:-- 1) Open the hood and reach down underneath the headlights to unplug the electrical plug from the fog light assembly. Squeeze the top of the release tab and pull the connection off the bulb's ballast. 2)Turn the fog light counterclockwise to remove it from the fog light housing. 3)Install the new fog light bulb.Then connect electrical plugs properly. 4) Test the fog lights by turning it ON. Thanks. you can rate this solution and show your appreciation.

May 20, 2010 | 2003 Ford Focus

1 Answer

Wiring of fog lights on 95 Mustang


If you bought the fog lights from Ford and they plugged into factory plugs at the front bumper, then I suspect you need the headlight switch that came optional for your car. You will need to install a relay into the fuse box. Check for any fuses for that circuit. I did one on a Ford f-150 and the switch came with the lights from Ford.Usually the fog lights are not on until you push a button or turn the switch.

Mar 15, 2009 | 1995 Ford Mustang

1 Answer

2001 Ford explorer sport fog lamps are not working. I just bought 2 brand new ones and they worked for two days then both went out at the same time. Also the button on the interior does not illuminate...


The light on your interior button should only come on when the lights are on, so I wouldn't worry about that until the lights are fixed. There should be a relay for your fog lights. I would check your underhood fuse relay box. switch that relay with another, such as fuel pump. I lights come on and now vehicle won't start, you know that it is the relay you have now put in your fuel pump circuit from your fog lamp circuit.

Dec 16, 2008 | 2001 Ford Explorer Sport

1 Answer

No fog lights on 92 talon non turbo, FWD


Yes you can have fog lights. You will need to buy the Haynes Manual and it will show you where to attach the wires underneath the harness under the hood. The easist way to do this is the biggy back the fog lights onto the main running lights circuit. NOT THE HEAD LIGHTS CIRCUIT. That way when you turn on the running lights the fog lights come on automatically and the fuse is strong enough to power both, and you could bump up the fuse about 10-15amps, but no more.

Hope that helps!

Thanks,

Mark

Dec 05, 2008 | 1992 Eagle Talon

1 Answer

Need wiring shematic for fog lights 2005 toyota corolla


im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Sep 04, 2008 | 2005 Toyota Corolla

Not finding what you are looking for?
2007 Scion tC Coupe Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Brad Brown

Level 3 Expert

13561 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...