Question about 1990 Oldsmobile Cutlass Supreme Conv

1 Answer

Fule pouring out

No i only took off the short pressure line from the filter to the tank .
i did not take the tank completely out just dropped the font end of it
so i could get to the line. before i put the tank back up i started the car to make sure there were no leaks and it ran fine. so i bolted it back up and it would not start just pours gas out. is it possible i pinched the return line
as i put the tank back up would that cause the problem ?

Posted by on

  • d0980y
    d0980y Aug 18, 2008

    that did the trick now i have to change my pulgs as they were old
    as it was and are now all fouled out thank you Pierre


  • d0980y
    d0980y Aug 18, 2008

    and take a spelling class ;-)

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 2,039 Answers

Yes sir the return line could be pinched that would make the pressure go up like crazy that would be a good reason check it out pierre

Posted on Aug 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fuel lines are clogged


flush them and replace filter

Apr 04, 2014 | 1986 Nissan Pickup 4WD 1986

2 Answers

Were is the fuel filter and is the fuel pump in the gas tank


the fuel pump is in the gas tank and the fule filter runs along the bottom of the Driver side..if your looking at the gas tank follow the gas lines that go toward Eng. you will see the Fuel filter

Dec 30, 2010 | 1996 Dodge Caravan

1 Answer

Where is the fule filter located


Hello! a combination fuel filter and fuel pressure regulator is used...It is located at the top of the fuel pump module...It contains a diaphragm, calibrated springs. and a fuel return valve...The filter is part of the assembly...

The tank must be dropped to gain access...

Guru...................Saailer

Jul 03, 2010 | 2004 Dodge Intrepid

1 Answer

Need help to drain fule tank in grand prix


I had luck by removing the fuel filter under the car (located on the drivers side midway of the car) I needed to do this and when i unplugged the filter, gas started coming out, i started to put a cup but the cup started to get full so i just plugged up the line instead. This is just a thought, it might be dangerous, ( i dont know) but i would remove the fuel filter and connect the gas line to a tank or bottle or something, maybe run an extension away from the car and start to crank the car, forcing the fuel to leave the tank, that's just me thou. YOU DO WHAT YOU NEED TO DO, dont hold me responsible.

Jun 06, 2010 | 1999 Pontiac Grand Prix

2 Answers

Need to change fuel pump for 99 chevy blazer how do i do it and where is the fuel pump located


first you need to relive the fule system of pressure. do this by finding your fule pump relay disconecting it and start the car. it will sputer, this is reliveing fule pressure.once it stops sputering your ready to get the fule pump out. it is located in the fule tank. the tank is held on by 2 straps your going to have to take off. once you do that drop the tank and the pump will be on top of it.

Feb 20, 2010 | 1999 Chevrolet Blazer

1 Answer

Been siting for awhile,can't get gas to engine


This is going to sound strange but sometimes when a vehicle sits the gas drains back into the tank. This happens when there is an air leak in fuel system (lines, fuel filter, fittings in the system, etc). Place a short length of hose into the gas tank filler opening. Prepare to blow into the hose while sealing the opening around the hose and the filler neck. You can seal it with tape or just by holding a plastic bag tightly over the opening and around the hose. Blow in slowly and steadly. You want to pressurize the system and then hold the pressure to force the gas thru the fuel lines, fuel filter, etc. You want to inhale thru your nose and exhale into the hose just enough to pressurize the system. You can then exhale thru your nose as long as you hold the pressure in the hose (stick your tongue over the hose end to seal it). Don't breathe in from your mouth or you will be hating things. When releasing pressure from the hose do so gently or the gas will slosh back on you. You can have someone crank the engine while you are pressurizing the fuel system. You are just trying to move the fule that much closer to the carbs so you can get her running. Another option is to pour some gas down the car and try starting the vehicle. It will run for a short time and allow the fuel pump to pressurize the system. .

Feb 15, 2010 | 1989 Ford Bronco II

1 Answer

Fule pump and fule filter,s


The fuel pump is located in the fuel tank and is accessible once the rear seat cushion is removed and, the filter is located Under vehicle, driver side, below seating area, driver side of fuel tank, mounted on frame in fuel line.

Please rate and have a great day:)

May 16, 2009 | 1992 BMW 3 Series

1 Answer

Stalled out?..no start,fule pump running constantly when key is in start poss.


ck fuel rail, for fuel pressure. if no pressure replace pump and sock.

Apr 12, 2009 | Ford Explorer Cars & Trucks

1 Answer

Fuel pouring out


you probably connect the pressure line to the return line did you change the pipe plesae tell me what hapen thanks pierre

Aug 16, 2008 | 1990 Oldsmobile Cutlass Supreme Conv

Not finding what you are looking for?
1990 Oldsmobile Cutlass Supreme Conv Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...