Question about 2003 Mitsubishi Eclipse Spyder

1 Answer

Door panel remove

Putting on a new mirror on my 2001 eclipse how do you get the door panel off?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 298 Answers

Here is an on line manual
i hope this helps you
don't forget to rate....thanks ;-)

Posted on Aug 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace drivers side mirror 2001 chevy tahoe,mirror only


To just replace the mirror glass there are a few different styles, but they all pull off. I suggest you wear gloves and glasses. Get a grip behing the glass and pull out. You should see a round circular bracket in the center. The new mirror just snaps into the bracket. Center new mirror and push evenly in the center of glass until it snaps into place. Dont push in by holding the edges, you'll break it. If you don't see the circle or it comes off with the glass it was too damaged for just glass. Power or manual mirros differ inside, but the mirror replacement is the same. If you mean the entire mirror only, remove door panel. Lower window, remove electrical connector if power, remove 3 bolts attaching mirror to door. Remove.

Jan 27, 2011 | 2001 Chevrolet Tahoe

1 Answer

How to remove the door panel of my 2001 Galant to replace the power window master switch?


how about placing the panel back on to the door ledge when placing the door back on, I am having a problem tith this. do i have to remove that little triangle cover by the side view mirror to put it back on the ledge?

Dec 25, 2009 | 2001 Mitsubishi Galant

1 Answer

Remove/replacing side view mirror on a jeep grand cherokee


    Remove the Old Mirror
  1. Step 1 Disconnect the negative battery cable before you take off the grand Cherokee front door trim panel. Remove all screws and clips.
  2. Step 2 Detachthe window trim cover screw, and control lever screw beforedisconnecting the entire mirror trim cover. Remove the rubber coverinside the mirror cover, and disconnect the electrical wire.
  3. Step 3 Remove three nuts from the power mirror using a Torx® star-shaped screwdriver.
  4. Step 4 Pull out the outside rear view mirror. Guide the power wire through the hole in the door.
  5. Install the New Mirror
  6. Step 1 Replace the old mirror. Put the new power mirror in place. Push the new wiring through the hole in the door.
  7. Step 2 Install and tighten the three retaining screws you took off when removing the old mirror.
  8. Step 3 Connect the power mirror wiring to the connection located on the door panel. Replace the rubber cover and interior mirror cover.
  9. Step 4 Put the front door trim panel back in place by securing all clips and tightening all screws.
  10. Step 5 Connect the Subaru Outback's battery cable to restore the power.

i will recommend i site where you will get all the information you need to remove and replace your side mirror
http://www.wjjeeps.com/mirrors.htm

Sep 10, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Need to replace Mirror Assembly, 03 suburban


Your going to have to remove the inside door panel to get to the three bolts that hold the out side mirror assembly. Once you have the door panel off you'll see the three bolts that hold the mirror assembly, just un-bolt and un-clip the wire harness to the electric/heated mirror. To install the new mirror assembly, just do everything in reveres. Go to Auto Zone and by extra door panel clips, there is a good chance of breaking some of the retainer clips and Auto Zone will have the step by step instructions to replacing the mirror assembly and the removal to the door panel. Good luck and keep me posted. Be glad to help.

Jun 22, 2009 | 2001 Chevrolet Suburban

1 Answer

Rear view mirror housing


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Jun 07, 2009 | 2006 Mitsubishi Eclipse

1 Answer

How to replace 1996 eclipse driver side view mirror


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Apr 26, 2009 | 1996 Mitsubishi Eclipse

1 Answer

Replace driver side mirror on 2001 Nissan Quest


SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal
  1. Remove the front door trim panel. For additional information, refer to Section 501-05 .
  1. Remove the upper speaker.
    1. Disconnect the electrical connector.
    1. Remove the bolts.
    1. Remove the speaker.
  1. Position the watershield aside.
  1. Remove the exterior rear view mirror access panel.
  1. Disconnect the exterior rear view mirror electrical connectors.
    • Release the wiring harness locator.
  1. Remove the exterior rear view mirror.
    • Remove the bolts.
    • Feed the wiring harness through the door opening.

Mar 31, 2009 | 2001 Nissan Quest

2 Answers

2001 camry replacing driver side mirror


Pull off the triangular trim panel that is right behind the mirror. It is held on by 2 clips. This will allow you to see all three 10 mm bolts to remove the mirror.

Mar 22, 2009 | 2001 Toyota Camry

1 Answer

Putting new mirror on passenger side door?


Behind the passenger-side front-door at the bottom of the window
you will find a molded triangular panel with a tweeter [audio speaker].
To access the nuts that affix the side-view mirror to the door you will
remove the panel. Gently pry on the top of the panel to remove it but be careful as speaker wires will be attached. Quick way to replace the mirror assembly is to support the panel and don't put stress on the wires. Open the door and find the nuts that hold the mirror onto the door. If you have electric powered mirrors you will need to separate the connector that sends current to the mirror for the remote function. Remove the nuts and be very careful not to drop the nuts into the door cavity. Good luck!

Jan 10, 2009 | 2003 Oldsmobile Alero

1 Answer

Replacing a drivers side mirror


There is a panel on the inside of the door where the mirror is.
That has to come off.
In some cases the door panel has to come off also.
Under the mirror panel there are nuts that hold the mirror on. Remove the nuts unplug the harness and install the new one.

Oct 07, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Mitsubishi Eclipse Spyder Logo

1,199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...