Question about Honda Accord

1 Answer

Honda ascot 1990 sedan is pre-igniting over running i have degreased wiring boxes and i have looked at cam belt spark plugs distributor carb nothing seems to stop the over running from happening

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 2,431 Answers

Then its the fuel shut off or anti dieseling valve that you need to trouble shoot, it has a tendency for the o- ring to break off

Posted on May 29, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 964 wont spark


run the fault codes first as there are a number of reasons for no spark --the last being the coil. There is an ignition module ---position sensors --timing belt --shorts in the cap --bad coil lead to the distributor . The ignition module may be only have 7.5 volts to it from the coil in which case you may have burnt it out with the 12 volt application and you will not get any spark unless the coil is in the circuit as it is a transformer that generates the high voltage necessary for a spark at the plugs.

Mar 15, 2014 | 1990 Porsche 911 Carrera

Tip

If u drove your car over a puddle...


If you drove over a puddle, just before your vehicle died, the water could shorten the ignition wires. CAUTION: Never touch the ignition wires, coil or distributor when ignition is ON or the engine is running; and be careful, engine is probably very hot! ignition.jpg Switch the ignition off, open the hood and check the spark plugs wires (check the picture), distributor and spark plug caps. They shouldn't be wet. If they are wet, turn the ignition off. With the ignition off, dry the ignition wires, distributor and spark plug caps with a clean rag or tissue. Now try to start engine with fully pressed accelerator pedal because your engine may be flooded with gas.

on Jun 07, 2008 | 2007 Honda Accord Sedan

2 Answers

1990 nisan n13 motor 1.6, has no spark to coil i drove car to train station, when i got back the car would not start, replaced coil, distributor, ecu box, all fuesible links, plugs & plug leads, fuel...


Your car has both a crank and cam position sensor. First start with your crankshaft position sensor. It is located by the harmonic balancer on the front of the motor.

Nov 28, 2013 | 1990 Nissan Pulsar

1 Answer

1990 honda accord will turn overbut wont start


DO A SMALL TUNE UP REPLACE SPARK PLUGS AND WIRES, REPLACE DISTRIBUTOR CAP AND ROTOR, REPLACE FUEL FILTER AND AIR FILTER. IF YOU ARE GETTING FUEL AND SPARK. EITHER IGNITION OFF OR VALVE TIMING OFF YOU VECHICLE HAS A TIMING BELT AND TENSIONER IF TIMING BELT SLIP TIMING IT WILL THROW OFF VALVE TIMING MAKING IMPOSSIBLE TO START CAR.

Nov 01, 2011 | 1990 Honda Accord

1 Answer

My 1990 hond accord will turn over but wont start can you please help


MAKE SURE SPARK PLUGS AND WIRES IN GOOD CONDITION, REPLACE DISTRIBUTOR CAP AND ROTOR,CHECK FOR SPARK AT SPARK PLUGS,IF YOU DONT SEE SPARK CHECK TO SEE IF POWER GOING TO COIL IF NOT CHECK IGNITION FUSE.IF FUSE OKAY AND POWER GOING TO IGNITION COIL,COIL FAULTY OR IGNITER UNIT FAULTY. CHECK FOR FUEL PRESSURE MAKE SURE FUEL FILTER BEEN CHANGED.FUEL PRESSURE SHOULD BE 40 PSI. IF YOU GETTING SPARK AND FUEL. YOUR IGNITION TIMING OFF OR VALVE TIMING OFF DUE TO A WORN TIMING BELT.

Nov 01, 2011 | 1990 Honda Accord

2 Answers

What is a ignition output signal on a 1990 honda accord , recently replaced entire distributor thats the coil , sensors, cap, rotor, ignitor. etc. i have power at the distributor, power at the coil , but...


Most of the time these distributor come with the ignition module did your, if it did and it has not been that long and is still under warranty, have it replace, if it did not come with one replace module.

Jun 11, 2010 | 1990 Honda Accord

2 Answers

1990 Isuzu 2.6 L 5 spd. No start.. Fuel pressure is ok, not getting spark. Checked coil, ignition module, distributor, computer and coil wire. No power coming from the coil. Small voltage going into...


assuming you the coil, plugs, cap, rotor and wires are good. check the cam sensor, If you have 12 volts to the coil using a 12v light tester. The cam sensor responsible for sending info to the computer telling it that the cam is turning, then the computer tell the coil to dispurse the charge/sparks to the distributor as distributor distribute the sparks to each plugs from the rotor of the distributor. Replace the cam sensor, it tend to go bad over period of time.

Dec 23, 2009 | 1990 Isuzu Spacecab

2 Answers

93 honda del sol will turn over but wont start. It has a new time belt, distrib, and the main relay works.


Is it not getting spark or gas? It needs both to run. Both main source. If no spark in any cylinder, then ignition module or crank sensor is likely faulty. If no gas, then fuel pressure regulator or fuel pump or fuel pump relay is bad.

Nov 11, 2009 | 1990 Honda CRX

1 Answer

No fuel no spark 1990 honda accord


other than the timing belt being broken, it sounds like the crank sensor in the distributor. get a used distributor. but first pop cap off and see if it is turning with engine.

May 25, 2009 | 1990 Honda Accord

1 Answer

No spark on my 1990 honda accord ex.


Hello,
Could you possibly be looking on the wrong area? is the rotor turning when engine is cranked? I hate to possibly bring bad news but is the cam belt/chain intact? as if broken you'll never get a spark.
Hope this points you in the right direction? if it does please respond by pressing the Blue button for my FREE efforts.
Paul 'W' U.K.

Jan 29, 2009 | 1990 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...