Question about Chevrolet Silverado

1 Answer

How many qts of gear oil go in a 84 chevy c10

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Gear oil in the rear differential? 2 quarts

Posted on May 30, 2011

Testimonial: "The answer I got was super helpful thxs a lot will diffenetly tell all my friends about the sit"


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How many qts oil for 84 c10 pickup

Should be 5 quarts with the filter. Could be 6 quarts if it is using a deep oil pan.

Feb 18, 2015 | Cars & Trucks

1 Answer

What will happin if i delete the egr from my 84 chevy c10 305 v8?

you will run foul of the emission inspectors . If there is a problem with it then it is best to get it fixed as it could be less expensive in the long run

Sep 28, 2014 | Cars & Trucks

1 Answer

How do I replace a power steering gear box in 1971 chevy c10

In general terms, its fairly easy.
You need to disconnect the pitman arm, the steering coupler to the column, the ps hoses, and unbolt it from the frame.
The tricky part is getting the steering wheel and pitman arm aligned so the steering wheel is centered when you put it back together.
Some are notched so you have to put it back one way, some are not.

Dec 12, 2012 | Chevrolet Chevy Cars & Trucks

1 Answer

I changed my Tranmission fluid on my 1984 Chevy c10 and gasket,filter now I'm trying to figure how many Qts of transmission fluid do I put back in.

It depends on which transmission you have in the truck but between 3.5 litres and 4.7 litres. Pick up 4 or 5 litres, add 3 and check the fluid level. Go from there. Before you check the level run the truck through all the gears slowly down to 1 and back to Park. Leave it in each gear a few seconds. Top it up and repeat until it's full. Hope this helps.

Sep 28, 2011 | 1983 Chevrolet Silverado

1 Answer

How many quarts needed for 2004 toyota automatic

Transmission 2.1qts

Front diff 1.2qts takes 75w-90 Hypoid gear oil
Rear diff 3.9 qts of 75w-90 synthetic oil

Transfer case 1.3 qts of a Hypoid gear oil API GL-4 or GL-5

Jul 02, 2010 | 2003 Toyota Sequoia

1 Answer

I have an 87 chevy S10 that will not go over 40mph. The filter and transmission fluid has been changed. The rear seal was changed at the same time. There is no loss of power, just will not shift in to 4th...

I am not sure but I think you have the 4L30-E tranny, fairly common and fairly read about with problems not shifting. I have the same problem. Not shifting, I changed the solenoids in the valve body, I haven't gotten it back together yet, just did it last week, put 5 qts of oil back in, I am still a couple qts low. But the tranny light is not on any more but I have no go, goes backwards ok, but only has 2nd gear forward. I will let you know what happens when I put in the other 2 qts. I don't feel like taking that thing out again. Yours being stuck in 3rd gear, it is in safe mode, will allow you to limp home but that is it. Or it is low on oil, check the oil when it is hot and in park, running, you just did the filter, it might be low.

May 24, 2010 | 1991 Chevrolet Cavalier

1 Answer

Where to plug in the wiper/cruise wire from the switch on 84 chev

i think its part of that long connector that goes to the ignition switch

Apr 25, 2010 | 1984 Chevrolet Chevy

2 Answers

Knock in right front when turning my 84 chevy c10 truck

this may be a strut or spring or a bearing plate that went bad. if you have 4 wheel drive it may be an front axle shaft.

Mar 30, 2010 | 1984 Chevrolet Chevy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides