Vehicle Dynamic Suspension
The vehicle dynamic suspension consists of the following components:
- Rear air suspension control (RAS) module (5A919)
- Snorkel
- Drier
- Air compressor (5319)
- Air suspension switch (5K761)
- Solenoid valve (5311)
- Air spring (5560)
- Air suspension height sensor (5359)
- Air line
------------------------------------------------
Visual Inspection Chart
Mechanical
Electrical
- Restricted suspension movement
- Excessive vehicle load
- Cut, severed, or crimped air line(s)
- Damaged air spring(s)
- Height sensor damage
- Height sensor mounted incorrectly, disconnected, or damaged
- Central junction box (CJB):
- Battery junction box (BJB):
- Loose or corroded connectors
- Air suspension switch OFF
The air suspension control module is diagnosed using Super Star II Tester 418-F045 (007-0041B) or equivalent.
The test connector used to communicate with the air suspension control module is located on the RH side of the luggage compartment.
When the tester is connected, the engine is started and the HOLD/TEST button is latched down, the air suspension control module will respond sending a code 10 to the Super Star II Tester which represents "Diagnostics mode entered." If diagnostic trouble code (DTC) 10 is not displayed, go to Pinpoint Test A.
Air Suspension Control Module Diagnostic Trouble Code (DTC) Index
Condition
Possible Sources
Action
- No communication with the air suspension control module
- CJB Fuse 5 (15A).
- BJB Fuse 8 (30A).
- Circuitry.
- Air suspension control module.
- Unable to enter auto test
- Air suspension control module.
- Circuitry.
- Rear air suspension does not respond to load changes
- Circuitry.
- Air compressor.
- Air compressor inlet tube.
- Air compressor drier.
- Air suspension height sensor.
- Air suspension control module.
- Circuitry.
- Air spring solenoid.
- Air suspension height sensor.
- Air suspension control module.
- Air suspension warning indicator ON
- Air suspension switch OFF.
- Place the air suspension switch in the ON position.
- Air suspension control module.
- Circuitry.
- Instrument cluster (conventional cluster) or lamp warning module (electronic cluster).
- REFER to Section 413-01A (conventional cluster) or REFER to Section 413-01B (electronic cluster), or REFER to Section 413-01C (natural gas cluster).
×