Question about 2003 Chevrolet TrailBlazer

1 Answer

When ignition turned to on a loud clicking coming from dash for about 30 seconds then stops all gauges working battery was just replaced then this started everything working fine before battery was does not matter if car is running or just in start the noise lasts 30-40 seconds then stops .if you turn off then start again it starts all over agail

Posted by on

  • jl_270 May 29, 2011

    thanks once again removed air con. fuses and problem solved .Put back one fuse starting with the 30 amp then 15 and problem came back when 10 amp installed so i will be going to part store to get a new actuator .plus tthis is the only vehicle i do not have a shop manual for so that is on the top of my list thanks again for info .John



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Sounds like a temp door actuator. Does the heater controls move to all positions and change from hot to cold.

Posted on May 29, 2011

Testimonial: "thank i puilled the air con. fuses and problem disappeared and when the 10 amp fuse was reinserted problem came back so i am going with the actuator a"


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my gauge cluster stop working?

they have an issue with the instrument panel connectors, my 05 2500 hd has an intermittent problem where it goes dead and if you smack the dash or hit a bump driving it will reset. It got much better when I put an extra twist in the cable before connecting it. I also got a replacement cluster due to bad lights etc and it does the same as the old one,I think it's a loose pin, probably ground but haven't gotten around to fixing it. my 95 c 1500 did the same

Jul 13, 2014 | 2003 Chevrolet Silverado 2500HD

1 Answer

Not starting dash lights dead

Wiring diagrams can be obtained on ErWin. Google will take you there.

Feb 04, 2014 | 2006 Volkswagen Caddy 1.6

2 Answers

Car starts fine then battery light comes on, after a minute or so the abs light comes on and lose all dash function......any help would be great

check your battery connections for corrosion, also see if the terminal wires to the battery are loose.

Dec 30, 2013 | 2002 Toyota Avalon

1 Answer

Engine starts but stops immediately

it could be the main ignition relay. do you hear a click when you turn the key coming from the dash area ?

Oct 26, 2013 | Toyota Land Cruiser Cars & Trucks

1 Answer

Heater stopped working. Blower comes on for about 30 seconds then turns off

On the passenger side of the dash thereis a fuse block. Find the HVAC blower fuse. Start the car, turn on the blower, and check for power at that fuse. If power disappears when the blower stops than you have a bad ignition switch.

Dec 13, 2012 | 2000 Chevrolet Malibu

1 Answer

2003 Pontiac Sunfire - When I turn the ignition on the dash buzzes, kind of like an alarm or a loud whirring noise. The gauges do not come up right away. If I leave it for a second or 2 it will sputter...

The problem could be a power supply module that supplies various voltages to the instrument panel (IPC). If it is acting up, it can make this buzzing noise. If that is it, it will eventually fail and the IPC gauges will stop working.

Apr 18, 2017 | 2003 Pontiac Sunfire

1 Answer

Maintenance Required light on after dead battery

No its easy . here are the steps turn ignition to acc/ first turn hold reset button located next to odometer rest button. Hold this button for 30 seconds. then turn ignition to next turn/click where lights come on on the dash ex brake air bag etc. hold for another 30 seconds. The maintenance light should flash and go out start vehicle and your maintenance is done. Good luck ad thanks for using FIX YA

Mar 13, 2009 | 2002 Honda CR-V

1 Answer

98 Durango security light on-engine off. No spark, no fuel,no gau

you might have left a ground wire off somewhere hope that helps

Feb 05, 2009 | 1998 Dodge Durango

Not finding what you are looking for?
2003 Chevrolet TrailBlazer Logo

374 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides