Question about Chrysler Sebring

1 Answer

Changed battery and now the engine light is on, the cruise control doesn't work and it idles at 3600 rpm!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 752 Answers

Disconnect the batttery for 5 minutes and reconnect.

Posted on May 28, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would make my engine shake rather , I have a 2004 Chrysler sebring coupe 2.4ltr 4cyl and my cruise control was working until someone was under the hood addressing another problem, now the light o


Sounds like thay unhooked your cruise control.and check your a.I.c sensor.Air idle control sensor.sometimes called map sensor.if all is good with the sensor.the problem could be deeper

Jul 25, 2014 | Chrysler Sebring Cars & Trucks

1 Answer

Acceleration won't go past 3000 PRM at idle


The car does have a maf, but it is rarely the cause of rough idle. Rough idle is usually caused by vacuum leak, pvc issues, or idle air control valve. What does it do, specifically, and is the engine light on?

Jul 23, 2017 | 2005 Chrysler Pacifica

1 Answer

After warming up, the rpm is normal range.


Engine stalls cold or RPM fluctuates at idle up and down or dies near idle.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control. If the above cleaning doesn't cure your issues you need to have the computer controlled automatic idle speed control system diagnosed and repaired by a dealer or electronic engine control repair shop.

Nov 07, 2012 | 1999 Mercedes-Benz E-Class

1 Answer

2011 cruise control and remote start do not work after EVAP problem.


the remote start and cruise control will not work if the codes are stored just because the light is off doesn't mean the codes are cleared

Jul 19, 2012 | 2011 Chevrolet Avalanche LT

1 Answer

My 2001 hyundai santa fe engine revs up and down constantly. It doesn't matter if its in park or while driving. The check engine light has always come on and off. I've had that checked several


Do you have cruise control,see if that cable somehow is giving slack,This is a problem with Hyundai where the cable affects TPS plausibility,There was a TSB bulletin by Hyundai Engine RPM fluctuation - cruise control cable adjustment procedure

Mar 20, 2012 | 2001 Hyundai Santa Fe

1 Answer

Vehicle unused with dead battery for 6 months will start but not maintain idle


The automatic idle speed control system has lost its adaptive idle learning due to the dead battery. To help to correct this in the short term run the engine at 2000 RPM until warm, then back down to 1500 RPM for 3 minutes, then 1000 RPM for 3 minutes, then let it idle for 5 minutes, this should get the system to a point in the idle learn that it doesn't stall out, then drive it for 20 miles under varied conditions of highway and stop and go and low speed operation, that should get all to work again. If you still have problems you will need to have the system scanned to see what is going on that is causing a stall. Also add fresh fuel, gas goes bad in about 3 months. Use the recommended grade of fuel.

Jan 20, 2012 | 2001 Mitsubishi Montero

1 Answer

My 1994 Camry idling problem.? It's a 1994 Camry V4, 2.2 L. After i changed the head gasket, my car idle became too slow. It seems like it doesn't have the cold engine starting idling anymore, i...


If it runs fine and the idle is the only problem you could try idling it up some with the idle set screw on the throttle body it sounds like it may be a little bit out of time those toyotas have a fine lins on the timing.

Jul 03, 2011 | 1994 Toyota Camry

7 Answers

I have 05 volvo vnl 670, isx cummins 450/500. keeps losing power, check engine ECU comes on knowbody seems to know what it is. they just keep replacing sensors.


I have a 2007 Volvo 670. The check vehicle ecu comes on. The fault code is MID 144 PID 191 FMI 5. THe truck won't go pass 1400 rpm, the speedometer doesn't work, the cruise doesn't work, the engine break doesn't work. I have to turn the truck off going down the road at highway speed for about 10 seconds and it'll go back to normal. Can anybody help?

Feb 16, 2010 | 2005 Volvo XC90

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...