Question about 1998 Toyota Camry

2 Answers

My toyota camry 1998 has the following deffects: 1. the horn is not working, I tried Pepboys to repair, but failed. 2. the door lock is not working and the side door glass won't go down. 3. the inside light are shutdown, not working Where can I have these repaired? and how much budget do I need. My location is in San Bernardino CA..

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 88 Answers

This could be something as simple as a blown fuse or multiple fuses. Some fuses are shared by multiple circuits. You can check those yourself to see if that's the problem. If the fuses are good, it seems like you will need to have an electrical diagnosis done. Did all of these components stop working at the same time? If so, there could be a bad junction connector somewhere in the wiring harness that is common to each of these circuits. You should take it to a dealer to have that diagnosed. If they all failed at separate times you may have three separate unrelated issues. Again, the dealer would be able to diagnose that.

Good Luck!
~Brandon

Posted on May 28, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,056 Answers

I wish you lived closer. There has not been a single electrical problem I have not been able to fix. Even electrical problems that has been turned down by several different shops. If you have a digital multimeter I will do my best to guide you, and hope to save you on labor. One good thing about electrical problem is almost all the time you don't need expensive parts unless it is electronic in nature. The bad thing about it is that there is not many mechanic who is good at electrical system. Electrical problem is more of understanding electricity rather than based on experience.

Posted on May 28, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What should I do my 1998 toyota Camry would not start and when I tried to open the door the horn started blowing


I'm pretty sure you triggered your vehicle alarm / immobilizer. Surely you know how to reset it, right? Is there a button on your key fob that does that?

Jul 30, 2014 | 1998 Toyota Camry

2 Answers

Toyota Camry 1999 model horn does not work


new horn or relay gone most likely but make sure it is grounded good or wont work either hook battery booster cable from negative battery terminal to horn bracket if it works then clean mounting area under horn ground is bad

Dec 11, 2012 | 1998 Toyota Camry

1 Answer

Central locking does not work on 98 camry


you need replace the door lock module or relearn the security system.

Nov 20, 2012 | 1998 Toyota Camry

1 Answer

1998 Toyota camry.. Is having problems to get heat through the car. Changed the cars thermostat and add coolant. Still no heat.


still getting overheat...
check the water pump, must see water flowing if not pump's deffective.
if it still gets overheat,cylinder head gasket is the problem.

Feb 28, 2012 | 1998 Toyota Camry

1 Answer

I unhooked the battery now i cant stop the horn and it wont start the remote key does not work it got washed in clothes help please.97 camry


Lock then unlock the doors with the power lock button, with all doors closed (key not in ignition). If this doesnt work, try again using the key to lock and unlock from the driver door, with all doors closed.

May 12, 2010 | 1996 Toyota Camry

1 Answer

How do i program a remote control for a 1998 toyota vienta


1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

Aug 04, 2009 | 1998 Toyota Camry

1 Answer

How can I re active the wireless remote control system ?


sit in car all doors closed put key in ignition and turn from OFF to ACC 3 times as fast as you can leaving it in ACC on the last cycle then press your remote button. your blinkers should flash to tell you this has worked.... may take you a couple of tries to get it!!

Jun 30, 2009 | 2002 Toyota Camry Solara

1 Answer

'87 Camry door lock doesn't work


Try putting a little graphite lock lube in the lock to see if it is just stuck first. Does your key work on the other locks? Do you have a spare key that you haven't tried? If you need to pull the lock, use a trim removal tool to pull the door panel off, starting at the bottom removing the clips on the outer edge of the panel. Unscrew the fasteners holding the armrest on and be careful of the door handle to avoid bending the linkages. Door locks don't fail too often.

Jan 24, 2009 | 1987 Toyota Camry

1 Answer

Camry central door locking not working after alarm going off.


there is a sensor on the door lock in the door if it goes bad or falls off it will do that take the door panel off window up and look at the back side of the lock a small snap ring holds it on some even come unplugged

Jun 12, 2008 | 1998 Toyota Camry

Not finding what you are looking for?
1998 Toyota Camry Logo

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...