Question about 2005 Chevrolet Express

1 Answer

Door locks ,fuse.map where are located - 2005 Chevrolet Express

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,975 Answers

The fuse for the door locks is located in the fuse panel under the drivers seat. Below is a diagram of the layout of the fuses and the fuse you want to check will be the one in the number 15 position. This should be in your owners manual if you have one. If you don't and would like a copy. you can email me at csautomotivecars@att.net with your make, model and year and I will be happy to email you a copy. Don't worry, no cost to you. I hope this helps and good luck.


door locks ,fuse.map where are - clifford224_600.gif

Posted on May 28, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change door lock fuses where is door lock fuses


Power Distribution Center *PDC* Located under hood in upper driver corner, fuse box and relay box. There might be a fuse box by the battery also,

recomend disconnect negative to battery, so accidently dont short any thing out

Mar 08, 2017 | Mitsubishi Colt Cars & Trucks

1 Answer

What number fuse for brake lights for 2001 ford ranger edge?


When you open the fuse panel there should be a fuse location map on the backside of the cover. The map shows the location and what system(s) the fuse protects. Find the one for your brake lights. Pull the fuse and replace it with the *exact* same amperage rating as specified on the location map (just in case it was replaced with an incorrect amp rating). There are two fuse panels in most cars. One is inside the vehicle usually located under the dash. These fuses are typically low amperage fuses. The second fuse/relay panel is located in the engine compartment. These are high amp fuses for things like the A/C compressor clutch, Anti-Lock brakes, fuel pump and other high draw systems. Check both places.

Jun 24, 2014 | Ford Ranger Cars & Trucks

1 Answer

After jump starting trunk latch,sunroof,door locks and map lights won't work


when jump starting volvos turn the lights on this will stop the power surge from blowing fuses or relays that have stopped all your bits from working

Jul 31, 2012 | 2001 Volvo S60

1 Answer

The power windows will not go up. Which fuse controls the windows?? Rene


When you open the fuse box, there should be a fuse map on the cover. Usually there is a listing for "PW / PDL" or more obviously "Windows / Door locks" or even "Cabin electronics" ... it should be that one. If you cannot find anything on your fuse map that looks right, and nothing in the fuse box in the engine compartment looks burned out, you might be in the wrong fuse box. Many cars have a secondary fuse box inside the car. This can be located in one of 3 places (usually) -- 1. Under the driver's side dashboard (rarely, it is located under the driver's seat ... but this is unusual), 2. under the passenger side dashboard, 3. In the trunk. American cars usually put them under the driver's side or passenger's side of the dashboard if they have a secondary fuse box. If you cannot locate the fuse that is out, I recommend getting a Haynes manual from a local auto-parts store. This manual will have the wire diagrams, and fuse box locations for your car, as well as other fixes if it is not the fuse.

May 26, 2011 | 1984 Chevrolet Cavalier Type 10

1 Answer

Which fuse controls the map light .The manuel does not show it .Thanks


Without knowing the year, make, or madel, I can't be sure, but, If you remove the fuse box cover on the inside of the car, ( usually located on the driver's side, near the door, just under the dash.), most manufacturer's put a diagram of the fuses and what they're for on the inside of the cover.

This should also be the location for your map light fuse.

I hope this will help you.

Jan 29, 2011 | Ford F-150 Cars & Trucks

3 Answers

Toyota corolla verso 2007 . the central locking has stopped working


Toyota Corolla Verso - Central locking has just stopped responding


So you don't waste your time, here are some assumptions: -

1. When I press the key fob there is no sound of doors trying to lock/unlock and I know the key fob is fine.


Solution:


In this situation reset the alarm/locking system

Below is the procedure I followed to get the central locking working again: -

Open the passenger door, and look at the side of the dash board. There should be a triangular panel. Pull the panel off to reveal a small set of fuses(see the back of the panel for the fuse map). To power down the central locking you need to remove the Dome Light fuse, this is located top left. Second one down 7.5 amps. (if in doubt remove the top two 7.5 amp fuses I did)

When you remove the fuse(s) you will notice the interior light go out indicating you have powered down the system.

Now leave them out for at least 30 mins so any capacitors can discharge properly. (Be aware while the fuse is removed all central locking is disabled, so the other doors are open. I left the fuse(s) out over night with all the doors open but I don't recommend it, 30 mins should be fine)

After 30 mins replace the fuse(s) close all doors, and then try your key fob, hopefully you should here that satisfying locking sound.


2. When I press the key fob I hear the locking system trying to engage.

This could be a faulty door switch on any door including the boot, or there could be a dent in the inner door panel of any of the doors, usualy the rear doors due to the seat belt not retracting properly.

Solution:

Check all door switches for damage, and check inner panel for dents, just a small dent where the switch connects can be enough to not engage the switch. This will stop the central locking.

Use some kitchen roll wrapped in tape (as a makeshift pad) and tape to the inner door as a temp measure to engage the door switch. At least you can then lock the car.


Jan 04, 2011 | 2007 Toyota Corolla

2 Answers

2004 VW GOlf 4door windows wont open,doors wont lock,trunk wont lock, what can cause this to happen all at once?


All these components operate via the central locking control unit. Check fuses No.4, 37, 6, 3, 14. If these fuses are ok, the control unit may be faulty and need to be replaced. The control unit is located behind the right dash panel.[on right hand drive vehicle , may be else where on left hand drive vehicle.

Jun 05, 2010 | 2004 Volkswagen Golf

1 Answer

Replaced map/dome/door bulbs with vleds bulbs, bent map light socket and tried to fix with screwdriver, caused spark, now none of the mentioned lights work and dash clock reset to 1:00 Blown fuse? Fuse...


Blown fuse. Do you have your owner's handbook? The fuse should be labeled. The location will be inside the car. Look under the dash on the driver's side and you may have to pull fuses to make sure they are good, but it should be only 1 fuse.

May 13, 2010 | 2008 Toyota Tundra

1 Answer

Map light fuse on 2008 f 350????


The interior map lamps are powered buy the battery saver relay ( non serviceable relay ) Which is powered by Fuse #25 ( cab fuse panel ).
This is for the engine compartment and illuminated vanity lamps, as well as the map lights.

The FET ( Field-Effect Transistor ) shows the fuse #9 also on it. ( marked interior lighting ), which power the interior lamps ( door / switch ).

Could be a few things if both those fuses are OK.

1. The map / interior lamp combos are usually dual element bulbs, which means if the interior lamps ( door or dimer switch on headlamp panel ) are OK, it could still be a burn out bulb.

2. The FET is having an issue from a dead short ( blown bulb or dead short to ground ). Until the short is correct, the FET will not turn back on.

Start with checking Fuse #9 ( marked as Fuse #8 in the diagram, but that shows headlamp ), which is to the interior lamps, and drives 1 side of the FET.

Jan 07, 2010 | 2004 Ford F150

1 Answer

Map lights and power door locks stopped working -2001 Chvy Camaro


sounds like you fried a relay ,, and will have to see a tech. for this ,, someone you trust and is ASE cert. in Auto electrical specialist

Nov 20, 2009 | 2001 Chevrolet Camaro

Not finding what you are looking for?
2005 Chevrolet Express Logo

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...