Question about Dodge Pickup

1 Answer

Compressor will not engage. pressure is high on low pressor side. had freon checked and refilled to correct level. but still compressor will not come on.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 88 Answers

I would check the fuse first. If the fuse is good, you may have a bad pressure switch.

Good Luck!
~Brandon

Posted on May 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

F 250 XL aircon cycles to quickly


If you are talking about the clutch on the compressor engaging and then disengaging (on and off repeating), In most cases it is a symptom of your freon level being low. It could be a number of things such as to much pressure on either the low or high side, a cluth relay faulty and many other causes but as I said the most common is a freon level neing low. Hope this helps.....

Mar 09, 2013 | Cars & Trucks

1 Answer

New A/c compressor


low freon level will prevent clutch from engaging. or disconnected high or low pressure switch

Aug 11, 2012 | 1999 Chevrolet Tahoe

1 Answer

My daughter's 2000 Dodge Neon's air conditioner wasn't cooling very sell so she took it in to have freon added. The shop drained all the freon out and then tried to add new freon but none will go into the...


you need the compressor running to get freon into the system
using gauges on a manifold you allow the compressor to suck the gas in to the system until you get a pressure reading at the high side gauge
That is the correct amount of gas for the system
take it to an accredited ac specialist shop to have the job done properly

May 20, 2017 | 2000 Dodge Neon

1 Answer

A/c for honda 2000 blows cold but has erratic high pressure readings very high and very low readings on low side


evacuate system and refill to proper spec for r13a refridgent may not have proper levels. check cooling fan opperation with engine running cooling fan should be opperating while a/c compressor is engaged. if all theese check out good has blockage in system

Jul 31, 2009 | 2000 Honda Civic

1 Answer

Adding freon to the auto air conditioner, the


On that model,it will cycle on and off while you add freon.If it does not ,then the ac system might have a problem.The low side pressure switch is located on,or near the accumulator .Unplug the switch and take the wire end plug and connect the two plug in`s together(cross it out on the wire).This will make the ac compressor engage and you can charge the system,do not leave the wire connected,plug it back up to switch.If the ac compressor does not come on ,then have the system checked out.

Jul 23, 2009 | 1994 Chevrolet Camaro

1 Answer

A/c compressor engages intermittently


Check the connections on the plug going to the compressor clutch and on the pressure switch on the low side. Also check the gap on the clutch. It may be too wide after where to engage correctly. Good luck.

Jul 23, 2009 | 1996 Ford Contour

5 Answers

Where does the freon go for a 99 expedition


Hi .. I just ran into the same problem .. I have a 2000 Expedition with the 5.4L engine .. the low side port is located on the passenger side of engine compartment just below the black metal bracket that contains electrical connections right in front of the firewall... you have to reach under this and locate the low side (larger line) and feel for the connection .. it is right in front of the accumulator .. There are two heater hose that hide the port .. you have reach under these to unscrew the port cap which is black .. you'll have to do this by feel .. I have found that you can by R134A charge with dye and leak sealant helps with small leaks .. if the system takes more than two cans be usre to add refrig. oil .. hope this helps

Jul 19, 2009 | 1999 Ford Expedition

2 Answers

A/C wil not work


if your low on freon the unit will not work.low pressure switch cuts it off. or you have a bad a/c clutch asy.

Jun 12, 2009 | 2004 Hyundai Santa Fe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...