A/c unit wont come on only if i hot wire the commpreser

Pull the pump out and see if just running 12 volts across it gets it to work. If that happens then it is not the pump at all but more likely fuse board or even the body computer.

Remove the wire from the temp sender unit an while someone is watching the gauge touch it to the engine. If the gauge goes up to hot immediately replace the sender unit.

First, charge your battery all the way, Is your check engine light on? How did you determine you have spark and fuel? Did you try starting fluid?

HOT WIRE COOLING FAN USING JUMPER WIRES TO BATTERY.IF FAN DONT RUN WHEN HOT WIRED FAN MOTOR BAD NEED REPLACING. IF FAN RUN WHEN HOT WIRED. CHECK COOLING FAN FUSE AND RELAY.IF ALL IS GOOD.YOUR ENGINE COOLANT TEMPERATURE SENSOR NOT WORKING.IT CONTROL COOLING FAN AT SET TEMPERATURE IF SENSOR OPEN OR FAULTY THE COOLING FAN WONT TURN ON.CHECK COOLING FAN WIRES FOR DAMAGE.IF ALL STILL CHECK OUT GOOD HAVE VECHICLE SCANNED FOR PCM FAULT.IF IT FAILS NO COOLING FAN WONT TURN ON.

The fans have a seperate temperature sensor either in the radiator or the block. Follow the fan wires to locate this sensor and unplug the sensor and with the key on touch the wires together. If the sending unit is bad the fans will come on. If the sending unit works the fan motor is bad.

Take your title to the dealer, they should be able to make you a key, also do you hot wire hot to ACC/ON hit Start, then release back to on when it turns over? It may not run if you have anti-theft.

Is it getting enough fuel ? If so, then check the timing

Pull the door panel and use the hot wire off the switch (You might need some wire for this) But connect the hot wire to the window motor it self!!! and it should roll up if not you got a bad window motor!!!

look up at the firewall from underneth the passanger side, there is a insullation panel that the drain opening is behind. pop the clips outa the bottom of it and put a peice of wire or commpresed air in to unblock. another way is to remove the blower motor and do the reach around to unblock its there youll find it

Unplug the wire to the horn and make sure you have the horn grounded really good. Take a hot wire and run it from the battery to the horn. touch the hot wire to the end of the horn and see if it works. If it does not work then you need to replace the horn. If the horn works then take a test light and hook it up to the horn wire and have someone push the horn down. you should have a hot wire. If you don't them check the horn fuse. Let me know if this works.