Question about 1997 Chrysler Town & Country

1 Answer

1997 town & country stalls intermittently. ... my chrysler town & country lxi dashboard cluster ligths go out

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had the same problem in the past with the lights. I repaired it by removing the the dash panel and re-soldering the pins where the harness plugs into. I am currently having the stall issue. in my research it seems to be the crank shaft sensor. I was told that the crank shaft sensor and the cam sensor work together and have decided to change them both along with the gas filter.

Posted on Jul 01, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the fuel filter on a Chrysler 1997 town and country 3.8 lxi


  • Relieve the fuel system pressure by removing the fuel pump relay from the power distribution center. Start the engine and allow it to run until it stalls. Try to start it again and let it run until it stalls. Repeat this procedure until it no longer will start. Turn the ignition off.
  • Disconnect the negative battery cable and raise the vehicle. Support the fuel tank with a transmission jack. Locate the fuel filter on the top of your Chrysler Town & Country fuel tank.
  • Remove the fuel line from the front of the tank and then the ground strap. Next, remove the inboard side of the fuel tank straps and front T-strap fastener. Lower the tank about 6 inches.
  • Detach the fuel lines from the fuel pump module and then remove the fuel filter. Put the new filter in its place. Tighten the fuel filter bolts to 40 inch pounds.
  • Reconnect the fuel lines to the fuel pump module and reposition the tank. Replace the front T strap fastener and tighten it to 250 inch pounds. Put the inboard fuel tank straps back and tighten them to 40 foot pounds.
  • Put on the ground strap and connect the fuel line in the front of the tank. Start the engine of your Town & Country and check for leaks.


  • Read more :

    Nov 09, 2015 | Chrysler Cars & Trucks

    1 Answer

    Why is brake & ABS ligths are on in town & country 2008?


    See my other answer to your IDENTICAL QUESTION.
    It is only necessary to post your question ONCE.

    Jul 23, 2014 | 2008 Chrysler Town & Country

    1 Answer

    Where is the cluster panel for a 1997 chrysler town & country van


    the cluster is the speedometer,and the odometer,and gauges and lights,there is no panel to access the cluster,it will have to be removed.

    May 05, 2010 | 1997 Chrysler Town & Country

    2 Answers

    Firing order for 1997 town and country LXI 3.8 engine


    1997 Chrysler Town & Country 2WD 3.8 liter V-6 VIN "L"

    8a4bc03.gif


    Hope this help; remember rated this post.

    Apr 09, 2010 | 1997 Chrysler Town & Country

    1 Answer

    Describe your 1997 Chrysler Town &


    You need to replace the whole assembly. It comes as a motor/regulator.

    Jul 28, 2009 | 1997 Chrysler Town & Country

    1 Answer

    Trans. filter and gasket change


    Its probably best to have a shop flush your trans fluid rather than replacing those parts, unless its already leaking because you open yourself up to creating a leak.

    Jun 04, 2009 | 1997 Chrysler Town & Country

    1 Answer

    Test code TC-153A on a 1997 Chrysler Town and Country LXi


    Dont be worried at all. The battery temp sensor isnt very important, most cars dont even have them. The only thing is you will have that light on. Good luck!!

    May 15, 2008 | 1987 Chrysler LeBaron Town & Country

    Not finding what you are looking for?
    1997 Chrysler Town & Country Logo

    524 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    76848 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8582 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...