Question about 1993 Nissan Sentra 4 Door

1 Answer

My car is liking the oil but i can't find the

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 662 Answers

I am not sure I understand the question...could you please relist your question ?????

Posted on May 27, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 GMC Sierra pickup. Driving and all of a sudden it shut off then turned back on; the doors unlocked then locked again. Now it won't do anything. Checked the oil and it was empty - no oil at


Running with no oil is death for the motor ( Seized). When the alternator stopped working because the engine stopped the door lock control opened the door locks as it said you were below the required speed to have them locked

Mar 31, 2013 | 2008 GMC Sierra 1500

2 Answers

Oil light reading "stop" car rattling when you press on gas


Check the oil level before driving it. It must be low on oil. Find out where the leak is. Look underneath the car at the oil pan's drain plug-maybe the service guys forgot to tighten it, or worse, cross threaded it. If they made a mistake, take it back to them to fix it.

Nov 22, 2012 | Volkswagen Cars & Trucks

1 Answer

I have a 2001 grand am se 2.4l ,and i made the mistake of putting transmission fluid in the oil. I want to know did do severe damage to my engine? I used about half a quart..


Nope your fine. Change the oil ASAP. Like tomorrow morning. Trans fluid depending on what is is can be a 20 or 30 weight oil similar to motor oil. The problem is it has an incredible amount of detergents in it. Those detergents will start to dissolve deposits in your engine wich isn't a bad thing but if it happens to fast you could plug the oil screen and loose oil pressure. If you can't get it changed tomorrow than limited mileage would be advisable until you can get it changed. 1/2 quart shouldn't be a big deal but you never know? Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 18, 2012 | 2001 Pontiac Grand Am SE

1 Answer

Sound like a lifter knocking took off vaule cover all were ok not too tight not too lose just had head gasket replaced never knocked before that any other ideas top of motor is apart heads are off too


Your problem could be a lifter that's either pumping up or leaking down which wouldn't be evident when you check the rocker arms for play with the engine off. You can use oil deflector clips and a mechanic's stethescope to run the engine with the valve cover removed and isolate the lifter in question. If you had a bad head gasket and had coolant leaking into the oil, it's also possible that you're mistaking the sound of a bad rod bearing for a lifter noise. Hopefully it is just a bad lifter.

Jun 26, 2011 | 1997 Chevrolet Blazer

1 Answer

I installed a engine in my 1998 Chevy S10 Blazer, but I made the mistake of not marking the distributor when I removed it because of damage to the electrical plug. Now, I can't seem to get the timing...


TDC, make sure both valves are closed. (Rotate the engine as it turns running, TDC is after the compression stroke, Number one piston up.)
Note that the distributor gear has a twist to it, and you need to compensate that when aligning the oil pump slot.

Jun 21, 2011 | 2000 Chevrolet Blazer

1 Answer

On a 4 ring grove piston, does the 3 piece oil scraper rings go o the 3rd or 4th grove?


Oil ring assembly always goes on the bottom. You really can't make a mistake there. Oil groove is always much wider than any other ring groove. Stock pistons with 4 ring sets????

Jun 13, 2011 | 1989 Plymouth Acclaim

1 Answer

My 2006 rio started with a knocking sound while I was driving, now it makes an awful sound and won't start, it's a standard trans...any ideas on what may be wrong? Just got the oil changed.


You may want to check and make sure that they actually filled it up with oil. Just pull the dipstick and see if there is anything on the stick. People make mistakes and it can be easy to forget to fill a car if the person was working on multiple cars at the same time or if someone other than the mechanic doing the oil change was pulling the car out after the oil change.

Jun 09, 2011 | 2006 Kia Rio

1 Answer

I did an oil change on my subaru legacy 2000 and now it's starts but once it's in reverse or drive it wont move.murphy@hotmail.com


I would bet you drained the transmission oil and not the engine oil. It is a pretty common mistake.

How much oil did you add when you where done. is the oil level on the oil dipstick now reading overfilled? Is there any fluid on the transmission dipstick?

May 07, 2011 | 2000 Subaru Legacy

1 Answer

OIL LIFE AT 50%, SHOULD I HAVE AN OIL CHANGE? IT'S BEEN ABOUT 6000 MILES.


Yes, you should. While the oil life monitor is based on Hours run time, that seems like it was reset by mistake.

Jan 11, 2011 | 2008 Chevrolet Cobalt

1 Answer

This morning I pore in the motor oil from the head and then all of a sudden all the motor oil went into the transmission fluid....how is that possible?


Sounds like you made a mistake there buddy !!!! you may have poured the motor oil into the transmission spout . Just drain and do over !!!!!

Dec 04, 2010 | 1992 Toyota Pickup

Not finding what you are looking for?
1993 Nissan Sentra 4 Door Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...