Question about 1987 Jeep Wrangler

Open Question

1987 jeep wrangler starter relay wiring diagram the jeep cranks over but when connected to the accessories is does nothing. Originally the new starter fowled up and we put another brand new one on and it must have damaged something else or some other wire.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Caesarfix
  • 141 Answers

SOURCE: 1991 JEEP WRANGLER WONT START

Take the distributor cap have someone crank the car and look if rotor turns, look at rotor conditions, I am sure that you have replaced it, hot wire from positive on the battery to positive on the coil, if car starts after you have a problem on the key, Is it fuel getting to the injectors? after You replaced so many things,if your rotor is not turning when You crank the engine, your timing chain must be defective or timing gear,

Posted on Jan 21, 2009

  • 2 Answers

SOURCE: need to rewire my 1987 jeep wrangler

I have a book with the whole electrical, haynes repair manual has the diagrams . 1987 thru 2003.I have 1987 wrangler with some issues. How would I get you infobook 50030


l

Posted on Mar 20, 2009

  • 1 Answer

SOURCE: 1987 jeep wrangler

I have the Haynes repair manual 1987-2003 Jeep Wrangler with all of the schematics. Which wiring scematics do you need and maybe I can scan/email the pages, if this legal? Or can maybe answer questions you may have, keeping in mind I am NOT a mechanic but I can read plans/schematics

Posted on Apr 06, 2009

emissionwiz
  • 75197 Answers

SOURCE: Stock 1995 Jeep Wrangler stereo wiring harness missing/cut off.

1995 Jeep Wrangler Car Stereo Radio Wiring Diagram.
Car Radio Constant 12V+ Wire: Red/White
Car Radio Switched 12V+ Wire: Purple/White
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Blue/Red
Car Radio Dimmer Wire: Red/Black
Car Radio Antenna Trigger Wire: N/A
Car Radio Amp Trigger Wire: N/A
Front Speakers Size: 4′ x 6′
Front Speakers Location: Dash
Left Front Speaker Wire (+): Gray
Left Front Speaker Wire (-): Yellow
Right Front Speaker Wire (+): White/Red
Right Front Speaker Wire (-): Brown/Red
Rear Speakers Size: 4′
Rear Speakers Location: Rear Roof
Left Rear Speaker Wire (+): Gray/White
Left Rear Speaker Wire (-): Brown/White
Right Rear Speaker Wire (+): White/Black
Right Rear Speaker Wire (-): Brown

Posted on Apr 09, 2009

  • 6982 Answers

SOURCE: location/testing of crank sensor 1995 jeep wrangler

Should be on the bellhousing on the drivers side just where you need rubber arms to reach it.Should have no continuity between b&c terminals (check with ohmeter) Harness plug is usually on the drivers side between the master cyl and the back of the engine (unless someone moved it)

Posted on Apr 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 jeep wrangler, no power to ignition or accessories, after replacing starter.


Take it to a shop. U fu--ed up royally doing the swap. If you had done the job correctly you would not be having this problem. Decent thing to do at this juncture is help your buddy pay for the correct repairs.

Apr 15, 2017 | Jeep Cars & Trucks

1 Answer

Clutch switch bad


Clutch switch keeps it from cranking.
You can bypass the cluctch switch. Make double sure transmission is in neutral. On many jeeps, under the hood is fuse/relay box. One of the relays is the starter motor. Pull the relay. With a pair of pliers, take a paper clip and short the pins that go to starter. They wire can get hot. If the starter cranks, you might be right (see ignition switch and any interlocks - like clutch switch), if the starter doesn't crank, get a new starter.

Jul 07, 2014 | 2005 Jeep Wrangler

1 Answer

My jeep wrangler won't start periodically I just replaced the alternator and the battery is only a few months old I had to jump it last night and while driving the lights were flickering and the radio...


The most common cause of a non-starting car is the battery. It is either weak, (low voltage) dead, (zero voltage) or has bad connections. (corroded or loose) I will assume you have a fully charged battery with good connections. (both to battery and starter relay)
If you remove the starter switch lead (small wire) from the starter relay and apply +12v from the battery to its respective prong or lead on the relay, and your starter cranks, your starter switch is faulty. (not to be confused with your key switch). If you jump the two large wires together on the relay and it cranks, then the relay is faulty. If you jump the two large wires together and nothing happens, then starter is faulty, or wires to starter are loose or broken. Picture of starter switch prong on the relay is pictured. NOTE: sparks are to be expected, so don't be too scared.

Dec 18, 2013 | Cars & Trucks

1 Answer

Distribtor cap wiring diagram


1987 Jeep Wrangler 2.5 liter L4 VIN "H"

zjlimited_35.gif



1987 Jeep Wrangler 4.2 liter L6 VIN "C" 2-bbl

zjlimited_36.gif


Hope this helps (remember to rate this).

Nov 23, 2010 | 1987 Jeep Wrangler

1 Answer

Wiring diagram for a remote starter


run a wire from an accessory fuse to a toggle switch and another wire from the other post of the toggle switch to the small wire on the starter.

Mar 20, 2010 | 1987 Jeep Wrangler

1 Answer

Hello i have a 1987 jeep wrangler and it won't


The wire should go into the same harness as do the remainder of the wires from the switch. If you tell me which pin the wire attaches to in the harness plug I can tell you what it does/ The two center ones opposite the clip are for the starter.(Plug facing you, clip at the top, two center pins in lower row) Likely the wire you are looking at is to the starter relay But, if the reverse lights are on, make sure the neutral switch is adjusted properly before doing anything else...if it is, a contact inside the switch may be broken and bridging the reverse contacts.

Sep 12, 2009 | 1987 Jeep Wrangler

1 Answer

I just replaced the flywheel, starter in my 1987


think you have put the flywheel on the wrong way round. the teeth have a leading edge.only go on one way

Aug 07, 2009 | 1987 Jeep Wrangler

1 Answer

Need to rewire my 1987 jeep wrangler


I have a book with the whole electrical, haynes repair manual has the diagrams . 1987 thru 2003.I have 1987 wrangler with some issues. How would I get you infobook 50030


l

Dec 18, 2008 | 1987 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

663 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...