Question about 2005 Nissan Sentra

Open Question

Cant locate turn signal flasher 2005 sentra 1.8

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: How ro change Relay Flasher in Sentra 2004.

I have a 98 nissan sentra and the problem that i have is that the front passenger side front and back light will flash very low and fast .I was guessing it might be the realy flasher .Does it have 2 seperate relay flasher for the left and the right ? It would be greatful if somebody could answer my question.

Posted on Jan 09, 2009

Ad
  • 840 Answers

SOURCE: Location of Turn signal flasher for 95 Nissan 4wd 4cyl MT

the flasher is under the dash its about 1-2 inches round and about an 1 inch thick Please rate my response thank you very much

Posted on Jan 28, 2009

kd6rhd56
  • 400 Answers

SOURCE: Where is the turnsignal flasher located 1991 nissan sentra 4dr

In your fuse box should be a large 1-2" square box inside the fuse box. Or under the dash board .

Posted on Jul 09, 2009

  • 691 Answers

SOURCE: location of the signal flasher

under the dash, just forward of your right knee when you're sitting in the driver's seat. You first need to remove the 10mm bolts and 3 screws that secure the cover. There should be a black box that controls the stop/tail/turn signals. The harness has about 7 wires plugged into it. if need help finding location turn on your emergency flasher and listen to it and follow the sound.

Posted on Aug 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of signal flasher module in 2004 blazer


Hazard and Turn Signal Flasher Replacement
Open the glove box to expose the glove box retaining tab (1). Lift the retaining tab and allow the glove box to hang freely.
Using a suitable flat-bladed tool, release the plastic retainer that retains the hazard/ turn signal flasher (1) to the C203 body harness connector (2) . Remove the hazard/ turn signal flasher (1).

Jun 12, 2015 | 2004 Chevrolet Blazer

1 Answer

Flasher location relay


at the mean fusebox underhood

Jan 20, 2014 | Cars & Trucks

1 Answer

2001 nissan sentra neither one of my turn signal bulb are working tried replacing the bulbs that didn't work.also tried switching the pigtail that didn't work either any idea what the problem


I had this problem with my car. Is ur hazzard flasher working? if they are working and the turn signals are not working. Try replacing the hazzard light switch. If the hazzard are not working then the combination flasher unit is bad. its what controls the signals and flasher.

Nov 10, 2012 | 2001 Nissan Sentra

1 Answer

Flasher 2005 cavalier where is it


It should be located on the brake pedal bracket. It is a Hazzard/Turn Flasher Module with 1- 5 pin connector.

Mar 07, 2010 | 2005 Chevrolet Cavalier

1 Answer

2005 Malibu Classic Hazard Module replacement


The hardest part is finding it. With your key on give a left or right turn signal. Try to listen and pinpoint the clicking of the turn signal flasher. Once you locate the turn signal flasher, your hazard flasher will look just like this and should be mounted nearby, typically next to it. The flasher simply pulls out and the new one just pushes in.

Jun 12, 2009 | 2005 Chevrolet Malibu

1 Answer

Turn signals dont work at all


Try your hazard lights. If they work, then it's your turn signal flasher. With your hazards on, listen under the dash for the constant "clicking". Locate the flasher for your hazrads... the turn signal flasher should be near it. Once you find it, just pull it out and replace.

You can use your hazard flasher in place of your turn signal flasher, just swap the two. This will get you to the store to buy a replacement.

Jun 08, 2009 | 2005 Hyundai Accent

2 Answers

Signals work some of the time most times not . i changed the switch but same problem now io want to change the flasher but cant seem too locate it on the car please help thank you.


Hello, having same problem with my car hope this article helps there was a recall here's the information...

Recall Reason EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS:SWITCH
Recall Date
AUG 28, 2003
Model Affected
ALERO
Potential Units Affected
670740
Recall SummaryCERTAIN PASSENGER VEHICLES HAVE HAZARD WARNING SWITCHES THAT MAY EXPERIENCE SOLDER JOINT CRACKING CAUSED BY RAPID TEMPERATURE TRANSITIONS AND THE SOLDERING PROCESS. IF SOLDER JOINT CRACKING OCCURS AND RESULTS IN AN OPEN CIRCUIT, THE TURN SIGNALS/HAZARD LAMPS BECOME INTERMITTENT OR INOPERATIVE.

ConsequenceWHEN THE TURN SIGNALS ARE INOPERATIVE, THE DRIVER CANNOT USE THEM TO SIGNAL INTENT TO TURN THAT COULD RESULT IN A CRASH.

RemedyDEALERS WILL REPLACE THE HAZARD WARNING SWITCH. OWNER NOTIFICATION BEGAN ON FEBRUARY 5, 2004. OWNERS SHOULD CONTACT CHEVROLET AT 1-800-630-2438, PONTIAC AT 1-800-620-7668, OR OLDSMOBILE AT 1-800-630-6537.

May 31, 2009 | 2000 Oldsmobile Alero

2 Answers

Where is the flasher for the turn signals in a 1999 ford explorer


The 2 fuses are no 10 (7.5amp) and no 21(15amp) in the interior fuse panel.The flasher is located on the base of steering column under dash. See this this pic find connector c214 on bottom 3rd from right.
http://i253.photobucket.com/albums/hh43/chuck943/EXN15113.gif

Mar 14, 2009 | 1999 Ford Explorer

2 Answers

1997 sonoma turn signal flasher


it is inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher, pull it out and replace with new one (there are two flat prongs that plug in). It appears this is a well guarded secret!

Aug 26, 2008 | 1997 GMC Sonoma

Not finding what you are looking for?
2005 Nissan Sentra Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...