Question about 2006 Scion tC

1 Answer

Lights on power window is blinking and passenger window will not lower from the drivers seat window panel. I have a Scion TC 2006.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 20 answers of more than 400 characters.


    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

First check to ensure the window locks are not on. If they are on simply turn them off and that should resolve your problem. However, I know there are situations in which if you had the battery disconnect it will cause this. Consequently disconnecting the battery can also fix the situation and then follow the below instructions. Or try the passenger side window switch first.

  1. Reconnect the battery terminal or fuse.

  2. Turn ON the ignition switch.

  3. Lower the window of each door halfway or more with the power window switch.

  4. Then close the window fully with the power window switch.

  5. Do not release the switch for at least 2 seconds after the window is fully closed.


Posted on May 26, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Diagnose 2006 Scion tc SRS code B1826 lh circuit

there is a TSB available if you're under 60,000 miles take it the dealer.

light occurs when:The center airbag sensor assembly receives an open circuit signal in the side squib (front passenger side) circuit for 2 seconds.

possible trouble areas include:Front seat airbag assembly RH (side squib (front passenger side)), Center airbag sensor assembly, & No. 2 floor wire.

Jan 21, 2017 | 2006 Scion tC

1 Answer

How to replace a 2006 scion blower motor

cab heater a/c blower?
did you apply 12vdc to it directly and its dead>?
scion not corolla (corolla is easy)
tc,xa or xb>>>> no clue, so will look at tc.

but no matter what, i hot wire the blower, first. everyone does.
and the FSm too, it tells you step by step how to do the test.
sorry if all this is old hat, most here dont know this.....
if the blower works hot wired, its good.

ok the FSM covers this job, getone.
or, login in to and read how.
that is what we do, so we can plan our time.

. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. 2. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY UPPER
  • Remove the instrument panel sub-assembly upper
  • Remove the instrument panel sub-assembly lower

it looks like the blower just drops out the bottom, did you look?
it has 3 screws hold the motor assy to the main casing.
and the plug is there pin 2 is hot, pin 1 is ground
hot wire pin 2.
facing motor, with conn, at 12pm, pin 2 is LEFT.
the FSM shows a photo of that. and the full steps.

Feb 09, 2014 | 2006 Toyota Corolla

1 Answer

2006 scion tc -antenna removal

replaced mine 07 tc, you have to remove back panel on the side of the car where it is, i found that mine screwed out so all i had to do was remove the broken part
after that was accomplished i screwed a new one in

Apr 21, 2013 | 2006 Scion tC

1 Answer

The passenger seat does not go forward or backward when pulling up on the latch.

latch may be broken, or that you have lots of junk under seat that will not let it work

Jan 17, 2011 | 2006 Scion tC

1 Answer

Which fuse number is the passenger side power window

both windows use fuse # 32 located under dash, so if drivers side works, then you might need to check on motor to passenger side, if it works from drivers side check on switch to see if the plug is in the switch

Dec 20, 2010 | 2005 Scion tC

1 Answer

My scion tc 06 seat belt is stock ,does't move

the seat belt retracter is jammed need to be replaced unles you dropped something into it and it jammed, like change? give me a shout back. wish you the best.

Oct 24, 2009 | 2006 Scion tC

1 Answer

How do you install a side mirror on a 2006 scion tc

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. You can then remove the bolts holding the mirror down and disconnect the wires

Aug 25, 2009 | 2006 Scion tC

3 Answers

My driver side window switch stop working scion xb 08

my xb scion 2005 back window wont work cod it be the fuse where is it.

Jul 09, 2009 | 2008 Scion Xb

2 Answers

07 scion tc passenger window wont roll down when lock by driver..

thats cause that what the lock is for so it wont go down

Jun 06, 2009 | 2007 Scion tC Coupe

1 Answer

Back Seat Speakers not working

bad speakers in rear, if you put the settings to the front of the car you will not get any sound out of the rear

Apr 05, 2009 | 2006 Scion tC

Not finding what you are looking for?
2006 Scion tC Logo

477 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Brad Brown

Level 3 Expert

15950 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides