Question about Ford Aerostar

2 Answers

I NEED to put freon in my 1995 aerostar the only small port that I can see is in the freon tank is this the right place to put the freon

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

Service Access Gauge Port Valves The low pressure access gauge port valve is located on the side of the suction accumulator/drier (19C836) , used to measure pressure, and in the evaporator to compressor suction line (19867) near the accumulator. (The freon tank)

Use R134a

please rate, thanks

Posted on May 25, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,252 Answers

Yes, the black dryer, should have a blue or blake plastic cap you have to remove..

Posted on May 25, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove fuel tank on 95 Ford aerostar. It has a vapor leak we must repair a leak in vapor recovery system


Removal and Installation
  1. NOTE: Make sure fuel tank (9002) is properly supported during removal and installation procedures.
    Drain fuel from fuel tank .
  1. Loosen fuel tank filler pipe clamp.
  1. Remove fuel tank heat shield (9A032) from vehicle.
  1. Support fuel tank .
  1. Remove bolt from rear fuel tank support strap (9092) and remove rear fuel tank support strap .
  1. Remove bolt from front fuel tank support strap and remove front fuel tank support strap .
  1. Partially lower fuel tank to gain access and remove feed and return lines from sender ports. To disconnect push connect fittings, refer to Push Connect Fittings in this section.
  1. Remove electrical connector from sender unit.
  1. Remove fuel vapor hose from evaporative emission valve (9B593) .
  1. Lower fuel tank from vehicle.

Apr 04, 2017 | 1995 Ford Aerostar

1 Answer

The air cond compressor not engaging, checked it out and there is no voltaged going to it from the switch,i can activate manualy with 12 volts however but still no cold air. Is there a relay between the...


the switch protects compressor from turning on when freon is low. add a charge and leak detector to system, thats why its not blowing cold when turned on manually

Apr 09, 2011 | 1995 Ford Aerostar

1 Answer

How to change afuel pump on a 1993 Aerostar ford van


put the van up on ramps in the rear, unbolt gas tanks straps, hopefully u take gas out before, take clamps off filler neck and pull big and small hose off let tank down slow and disconnect wiring plug and fuel lines to pump then pull tank out from under van. very carefully unscrew big washer that holds pump in, put in new pump and reassemble the way you took it out, good luck, remember be gentle with fuel lines and wiring

Jan 05, 2011 | 1993 Ford Aerostar Extended

1 Answer

How do I replace a fuel pump on a 1995 ford aerostar


drain all the fuel you can from the tank, SAFELY using proper saftey equipment, place the vehicle on jack stands, disconnect the battery, place a jack under the tank, remove fuel cap, remove 3 screws holding filler neck to the inside of fuel filler door compartment, remove tank straps, remove driveshaft, lower tank slightly & remove fuel neck, wires, fuel couplings, lower tank & remove from vehicle. Carefully remove locking ring from the tank where it holds down the fuel pump asy, remove pump asy & replace components as needed, reassemble, check for leaks, road test vehcile

Nov 02, 2009 | 1995 Ford Aerostar

1 Answer

Low on freon on 1995 ford areostar


You charge the a-c on the low side. If you are hooking up to check high side reading it is located to the right of the air cleaner and radiator. Good luck.

Jul 10, 2009 | 1995 Ford Aerostar

1 Answer

A/C compressor off - how to restart it?


it is on the large ac line/hose ,it is the small service port the larger service port is on the small line/hose is the high side dont fool with it to reset ,,, disconnect the negative battery cable for 20 seconds and re connect

Jul 03, 2009 | 1995 Cadillac DeVille

1 Answer

Need the name of small hose on top of engine in front left corner spewing coolant. There are two hoses.


Are you talking about the overflow tank hose, or the radiator inlet or outlet hose?

May 10, 2009 | 1995 Ford Aerostar

1 Answer

Starving for gas


check fuel filter first. rate as fixed if this helps.

Steel Midship, Aerostar
Removal and Installation
  1. NOTE: Make sure fuel tank (9002) is properly supported during removal and installation procedures.
    Drain fuel from fuel tank .
  1. Loosen fuel tank filler pipe clamp.
  1. Remove fuel tank heat shield (9A032) from vehicle.
  1. Support fuel tank .
  1. Remove bolt from rear fuel tank support strap (9092) and remove rear fuel tank support strap .
  1. Remove bolt from front fuel tank support strap and remove front fuel tank support strap .
  1. Partially lower fuel tank to gain access and remove feed and return lines from sender ports. To disconnect push connect fittings, refer to Push Connect Fittings in this section.
  1. Remove electrical connector from sender unit.
  1. Remove fuel vapor hose from evaporative emission valve (9B593) .
  1. Lower fuel tank from vehicle.

Apr 28, 2009 | 1995 Ford Aerostar

1 Answer

Car key


You should be able to give you vin number to the dealer. they can cut you a new key. As for removing the lock... you need to turn the ignition to the on position then push an 1/8" rod into the small hole in the bottom of the steering colum right under the lock assembly. After placing it in the ingition lock will easly pull out. Insert the new one in reverse order.

Nov 07, 2008 | 1995 Ford Aerostar

1 Answer

1991 aerostar with blown head gasket, how do I drain the fuel tank


If you're going to junk it, just "ice pick" the gas tank and have plenty of proper containers to put the gasoline in. I saw that happen when I was in a scrap yard getting parts. The ppl who run the place just poked a hole in the tank and let it empty into a barrel.

Jun 01, 2008 | 1996 Ford Aerostar Extended

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...