Question about 1994 Honda Civic

1 Answer

The SRS light will go off. Tell how to turn it off.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 100 Answers

Hi, you cannot turn it off rather you have to reset it by following the instruction below...

  1. Turn ignition switch off, remove service connector cover.
  2. Connect (jump) the MES (Memory Erase Signal) connector (this is 2 pin connector wrapped on yellow plugged in the front of the under dash fuse box).
  3. Turn ignition switch on.
  4. SRS light will come on for 6 secs then go out, remove the jumper within 4 secs after the light goes out..
  5. The SRS light will come on again, reconnect the jumper within 4 secs after the light has come on.
  6. The SRS light will go off, remove the jumper with in 4 secs after the light has gone off.
  7. The SRS light will blink 2 times indicating the memory is reset.
  8. Turn the ignition switch to off and wait for 10 seconds.

Posted on May 25, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i reset Air bag code for 2006 mercedes E350


Mercedes SRS Airbag Light MOT FAIL How To Fix - YouTube

? 3:48
https://www.youtube.com/watch?v=JVEuOzYaH1M
Oct 1, 2013 - Uploaded by OBD Diagnostics
Mercedes SRS Airbag Light MOT FAIL How To Fix ... SRS LightReset (cheap, easy) - Duration: 3:07. ... Autel AL619 Clear SRSAirbag Light Mercedes W211 E Class ... OBD2 Fault CodeDiagnostic Scanner/Readers @ Diagnostic World ... 2000Mercedes-Benz CLK-Class Start Up -- SRS Airbag Light On ...

Mercedes E W211 SRS Airbag Warning Light - How to turn it ...

? 1:00
https://www.youtube.com/watch?v=KZWAPGmf-Pk
Feb 12, 2013 - Uploaded by DominatorParts
Mercedes E W211 SRS Airbag Warning Light - How to turn it off ... AUX USB Ipod iPhone adapter E-Class 2003-2008 Mercedes Benz Dension ...

How To Reset The ESP Light On A Mercedes Benz

www.mademan.com/mm/how-reset-esp-light-mercedes-benz.html
Jul 11, 2010 - They will check to see if your Mercedes Benz shoots out any codes. They will check .... How To Reset Airbag Light On A Dodge. Need to know ...

Best tool to reset SRS light - MBWorld.org Forums




Jan 14, 2016 | Cars & Trucks

1 Answer

SRS ENGINE LIGHT on, no cold start


you can take a OBD2 code scanner to have a check, and it will tell you what problem causes the SRS light on.

Nov 04, 2012 | 1998 Volvo V70

2 Answers

Airbag and srs light stay on , on my ml270


Only a compatible scanner is going to turn this off.Don't try to do it yourself, as with any air bag/srs (supplemental restraint system), these units contain what amounts to an explosive charge, and if not handled properly, by trained folks, they can very easily cause death, ansd a nasty one at that.As long as the system detects a snag, it will continue to turn that light back on, even if you do get it turned off. The system does a circuit check soon after the car is started, on this system, and the only way to turn off that light is to fix it. Could be as simple as a clockspring, so have it checked. This is one of the only things that I'm not really willing to give much info on, due to the potential for disaster. Sorry, it's just the old grease monkey looking out for your safety. If you get it diagnosed, and have any questions about what you have been told, or anything like that, please feel free to contact me. Good luck!

Feb 11, 2012 | Cars & Trucks

1 Answer

Srs light stays on when car is turned on/mitsubisi galant 2001


Have the car ever been in an accident? Bumped even a little? Even though an air bag was not deployed, crash data may be stored and a new module may need be installed.
Also see if all the seat belts work. If one does not pull out or retracts properly that may be it.
A shop scanner should also be able to tell you the reason for the SRS (Supplimental Restraint System) light

Oct 07, 2011 | 2001 Mitsubishi Galant

1 Answer

SRS Light Honda civic 1997 5 Door Can Anyone please tell me how do i Reset the srs light or will the car have to go in for a Diagnostic


Hello! when the light comes on it means the air beg system has a fsult and, in an accident, the bags will not deploy...very unsafe situation...Typically, one or more of these DTCs will be set: SRS DTC 15-1 (faulty OPDS unit or OPDS not initialized)... SRS DTC 15-2 (faulty side airbag indicator circuit)... SRS DTC 15-3 (faulty OPDS sensor)...To ensure continued reliability with the OPDS: American Honda is extending the warranty on the OPDS unit and the OPDS sensor to 10 years or150,000 miles, whichever occurs first.you will need to take the car to the dealer to have it checked to see if this is the problem that is causing the light to come on, there should not be a charge to check it if it is the condition that is covered by the extended warranty. It takes about 3 minutes to determine if the light is on for the OPDS or if it is some other cause. If it is caused by something else then the dealer will want to charge you for further diagnosis. At that point you can say 'no' if you don't want to go any further....my guess is it will be covered under the extended warranty.. Also, it is not a fuse and the airbags will not go off when the light SRS light is on; whenever the SRS light is on the airbag system is disabled. Unless you have the special tool, you can't just turn the light off; even if you did, it would come back on the next time you drove the car...Guru....saailer

Sep 28, 2011 | 1997 Honda Civic

1 Answer

I got a 2003 S430 SRS keep coming on. How much will that cost me to get it fix.


This is hard to quote without knowing the problem. the srs computer will need to be scannned for codes, the code or codes will tell you what part of the system is not working within specs and then with some testing the problem is found, the computers are always testing all components when a compuetr sees a problem it turns on the light of the system thats failing , in your case the srs light, a scan tool is needed to connect to the cars computer inorder to scan for codes, this problem may be as simple as a bad seatbelt buckle , but scanning is needed first, good day

Sep 03, 2011 | 2000 Mercedes-Benz S-Class

1 Answer

Battery was low and put in new battery,problem SRC Light stays on how can I reset the SRC light?


I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Jan 13, 2010 | 1997 Honda Civic

1 Answer

Srs light permanently on. 2003 ml350. I know the air bag computer needs fixing or replacing. i just want to turn light off until i do.


the light will only go off if you fix the system or tell the vehicle you dont have a srs module but the dealers would have to do that.

Jun 26, 2009 | 2002 Mercedes-Benz C-Class

1 Answer

Srs light is blinking


you have a bad srs relay, take it to autozone and tell them you want a trouble code done, it is free, it will tell them what it needs.

Nov 26, 2008 | 1999 Toyota Avalon

3 Answers

HOw do you reset the SRS display


The light is on to indicate a fault in the airbag system, the light will remain on until the fault is repaired, also understand as long as the SRS waring indicator is on the airbag system is disabled

Oct 12, 2008 | 2001 Honda CR-V

Not finding what you are looking for?
1994 Honda Civic Logo

878 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...