Question about 2011 Lincoln MKZ Hybrid

Open Question

I cannot find the hazard lights. the manual says between the air vents but that is where the nav screen is

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removal sat nav screen


disconnect battery. remove 1 gearshift surround held by clips. 2 centre glove box liner, 3 rear console air vent. 4 centre console held by screws. audio stack held by small bolts. make sure you remove gearshift from P before you disconnect battery,

Oct 19, 2013 | Jaguar S-Type Cars & Trucks

1 Answer

Hazard lights don't work


i have the same problem on my 02 malibu but if u kind of hit the hazard light button with your knuckle it will solve the problem or atleast it does on mine

Aug 31, 2013 | 2001 Chevrolet Malibu

1 Answer

Where on dashboard is hazard switch


The Hazard light switch is located in the middle of the center dash vent. The vent in the middle of the dash has two adjustable vents and the button that turns on the hazard lights is in between the two vents.

May 29, 2013 | 2002 Mitsubishi Galant

2 Answers

LOCATION HAZARD LIGHT SWITCH , CAN'T FIND WHERE TO TURN THEM ON


The Hazard light switch is located in the middle of the center dash vent. The vent in the middle of the dash has two adjustable vents and the button that turns on the hazard lights is in between the two vents.

Aug 01, 2010 | 2003 Mitsubishi Galant

1 Answer

2000 bmw x5 nav screen blank. radio works but no


I know this is an old thread, but my 2006 325i Nav screen went bank also, but the radio still played. I noticed the glove box light and trunk light did not turn on also. I was told from mechanics is was probably a CID module for $2200, even though I mentioned the glove box and trunk light light were out and specifically inquired about a fuse. The mechanics never checked the fuses, because I checked my fuses in the glove box and found the fuse 61 marked with a BMW symbol that looks like light bulb was blown. The Nav screen started back up once the fuse was changed.

Feb 03, 2010 | 2000 BMW 5 Series

1 Answer

A/C automatically switches from inside to outside air


Shut off the switches so that the auto and recirc lights are both out. If you use recirc in winter your car will remain fogged up.If you have NAV, go into the climate control touch screen and shut off the ac or auto mode there as well.

Jan 09, 2010 | 2004 Lexus RX 330

1 Answer

Where can i find a manual for the PCM Sat Nav on a Porsche (996)


If you don't have a Porsche dealer near you, check eBay for a Nav manual. Your car should have come with one though. Good luck!

Nov 29, 2009 | 1998 Porsche 911 Carrera

1 Answer

The turn on lights does not flash


Check out this recall below:
Bulletin No.: 04098A

SPECIAL POLICY
Subject:
04098 - Special Policy Adjustment - Turn Signal/Hazard Warning Flashers 

Condition
Some customers of 1999-2002 Chevrolet Malibu, Oldsmobile Alero, Pontiac Grand Am, and 1999 Oldsmobile Cutlass may have turn signal/hazard flashers that become inoperative.

Special Policy Adjustment
This special policy covers the condition described above for a period of 10 years or 150,000 miles (240,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership. The repairs will be made at no charge to the customer.

Good luck and hope this helps:
HAZARD WARNING SWITCH REPLACEMENT - ON VEHICLE 
REMOVAL PROCEDURE 

Remove the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent. 
Remove the instrument panel cluster. 
Remove the hazard warning switch bezel from the instrument panel using a small-flat bladed tool to release the retainers.
Remove the left side bolt from the hazard warning switch through the instrument panel cluster pocket Remove the right side and center lower bolts from the hazard warning switch through the center air louver deflector pocket.
Reposition the hazard warning switch from the instrument panel to access the electrical connector. 
Disconnect the electrical connectors from the hazard warning switch. 
Remove the hazard warning switch from instrument panel. 

INSTALLATION PROCEDURE
Connect the electrical connectors to the hazard warning switch.
Position the hazard warning switch to the mounting points in the instrument panel. NOTE: Refer to Fastener Notice in Service Precautions.
Install the left side bolt to the hazard warning switch through the instrument panel cluster pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the hazard warning switch bezel to the instrument panel pressing into place until fully seated. Install the instrument panel cluster. 
Install the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent.

May 24, 2009 | 2000 Oldsmobile Alero

3 Answers

How do you remove a dashboard off a 1996 grand am


tienes que kitarle los tornillos a todo la mayoria del tiempo son pequeños y de cruz y estan cerca del parabrisas

Aug 06, 2008 | 1996 Pontiac Grand Am

Not finding what you are looking for?
2011 Lincoln MKZ Hybrid Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...