Question about 2003 Mitsubishi Lancer

1 Answer

When my a/c is on, the temp is 70 degrees f. compressor has been replaced. It should be colder

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 4,977 Answers

You should get the a/c system pressure checked as it could be low on freon which won`t allow the system to get cold enough and to make sure the compressor is functioning as it should be.

Posted on May 25, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wont start below 65 degrees all summer runs fine as long as temp above 70 degrees


Cold start sensor is defective and not enriching the mixture for cold weather start. Its usually in the inlet manifold/water jacket and works the ECU until the air/water temp has reached a pre determined point.

Nov 01, 2015 | Cars & Trucks

1 Answer

2005 XG350 ac blows hot air not cold dealer installed new compresor, and belts blows 70 degree air at dash grills


A system will only drop temp about 20 degrees from outside temp. I would have then recheck the Freon level again. To much is as bad as to little when it come to Freon. Also the oil level can be to high causing the same thing. When they changed the compressor they should have also replaced the dryer and the orfice tube/screen. If that wasn't don't you could have a obstruction in line.

Aug 24, 2014 | Cars & Trucks

1 Answer

What temp should a/c be in 1995 chev on max


Hard to say.
Under normal conditions, vent temp should be about 20 or 25 degrees less than outside air temp.
So if outside air temp is 90 degrees and the engine is at idle speed, vent temp would be around 65 or 70. On the road the vent temp could be less than 60 degrees.
If outside air temp is 70 degrees vent temp will be around 40 - 50.

Jul 21, 2012 | 1996 Chevrolet K1500

1 Answer

Just put in a new compressor and dryer but it isnt blowing very cold about 70 degrees. the truck is a 2007 dodge megacab


Are you sure you put the correct amount of r1334a back in the system? Try running the garden hose over the condenser and see if it gets colder. You might have a weak fan clutch. If not the expansion block could be stuck. this happens sometimes when the system is evacuated and re-charged. Most of the time it will fix itself after a few cycles on and off.

Jun 06, 2011 | Dodge Ram 3500 Cars & Trucks

1 Answer

A/C quit blowing cold air after a loud squeeling noise stopped!


Look way down on the engine front area passenger side for the compressor.
Is the belt gone?
Check the belt tensioner pulley....can you turn it?....is it seized?
If it is OK then try and turn the compressor.......and the idler part of the compressor.
If the compressor is seized.....why?
Usually lack of oil in the system,or an overcharged system.

Once you have removed the 134a gas from the A/C system before removing the compressor and before installing the new compressor make sure you add the correct amount and type of oil into the system to prevent another seized compressor after you have flushed the system to remove contaminates such as old compressor grindings......if the compressor was seized.
You will also need a new receiver/dryer once you open the system to the moisture in the air.
Do not expose the new receiver/dryer to air....install last.
Vacuum the system well before refilling with the correct amount of 134a.
At 70 to 80 degrees outside temp........a vent temp at medium fan speed of 48 to 45 degrees should be a full charge .......use this reading if you do not have a electronic scale and/or A/C machine.
DO NOT OVERFILL THE SYSTEM.

Sep 08, 2009 | 2000 Chevrolet Silverado

2 Answers

Air conditioner in 1999 mercury tracer won't work. It's not the compressor nor does it have a leak. what could be the problem?


the tracer is the same as the ESCORT, right?? TRY THIS--I WORK ON PLENTY OF ESCORTS--LOOK UNDER THE AIR CLEANER/CONE ASSEMBLY--THERE WILL BE A BLACK METAL BOX(FULL OF RELAYS) ONE OF WHICH IS THE A/C RELAY--TRY TAPPING ON IT WITH A LONG SCREWDRIVER OR SOMETHING SIMILAR WHILE U HAVE THE A/C ON. IF THE A/C SUDDENLY STARTS WORKING U NEED TO GET A NEW RELAY BOX(I THINK ITS CALLED A GEM MODULE) i do have a question- does the blower motor work?? how do u know the compressor is good??do you have 12 volts going to it??? this relay box is pretty common to go bad--u have to remove the air cleaner in order to get to it.get back to me.

Sep 07, 2009 | 1999 Mercury Tracer

1 Answer

I have a 99 chevy suburban 2500 with rear a/c. i installed a new compressor and orfice and a rear expension valve with acumilator. Also recharged. it only cools at 60 degrees down the road. At idle its 70...


What is the ambient or outside temp? A drop of 30-40 degrees is considered normal. And did you evacuate the system to remove the air? This is a must to get 100% efficiency. Another cause is too much oil/stop leak/or leak detector can affect efficiency

Jul 29, 2009 | 1999 Chevrolet Suburban

1 Answer

My 2000 monte carlo isnt showing the temperature in the screen


Replace the ambient air temperature sensor.

Above the left side of the grille is where the sensor is located. You will have to remove the grille to replace the sensor.

Jul 22, 2009 | 2002 GMC Envoy

1 Answer

Air conditioner blows colder for the passenger side


It maybe low on refridgerent or your temp sensors need replacing. You could also have a flap problem.

Jun 13, 2009 | 2007 Chevrolet Tahoe

Not finding what you are looking for?
2003 Mitsubishi Lancer Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...