Question about Nissan Maxima

1 Answer

How mush will A valve adjustment coast me? - Maxima Nissan Cars & Trucks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 104 Answers

Roughly it would be be 2-6 hrs at 85-125$ hr depending on what kind of vehicle

Posted on May 25, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Subaru impreza ts 2.5 when driving down the road and let off the gas and coast then get back into it it smoke bad for a few minutes then clears up until you coast again. Is it the head gasket


no
when you are coasting , the inlet manifold vacuum can exceed 25 " mercury and that puts extra strain on the valve stem seals and rings
if they are failed or the valve stems guides are worn then the vacuum sucks oil past the seals and down the valve stems into the combustion chambers , resulting in the smoke when the system again fires up on acceleration
find an accrdited service center with experience on the make of car, have them do a compression test (wet and dry) to determine engine condition and if the rings prove a good compression , then they will be able to change the valve stem seals with out removing he head/s
get quotes first

May 19, 2017 | Subaru Cars & Trucks

2 Answers

1998 r1200c hesitating intermittently when opening throttle after coasting in gear. Dealer says to use injector cleaner every other tank full….??


Could be he's hoping the injector cleaner will clean the throttle body and/or Mass Airflow.
You can remove these and clean them yourself...

Possible that coasting in gear is sucking something into the intake that takes a bit to clear when you open the throttle, too. Think worn rings and PCV valve or worn valve seats. Do you get a puff of smoke when you open the throttle after coasting in gear?

Jun 03, 2015 | Cars & Trucks

1 Answer

How do i adjust the brake pedal on my 2007 Toyota Prius


your rear brakes are shot as they are the tightest
the fronts should grab hard when you press very hard
if they are mushy you need brakes bad
you should fell very comfortable that you have great brakes.
when you press the pedal it should feel strong after 1inch of play
mush means your gonna die or kills someone.
have your brakes bled as a service this will allow them to test them for you at same time . thats the limit you can adjust brakes.

Aug 03, 2014 | 2007 Toyota Prius

1 Answer

What is a sonnex kit and how mush does it cost and do you have to pull the trans to install?


A sonnex kit is a reprogram for the transmissions valve body . no just remove pan and valve body to install if the the 2-4 servo needs to come out for different springs then it can be done in the car but a tight work area. Transtar industries carries sonnex kits.

May 13, 2014 | 1995 Chevrolet Camaro

1 Answer

In drive if i mash on the gas my car spits,sputter,stalls, and jumps.. as i let off the gas it coasts fine until i try to accelerate again then my speed decreases.. i've replaced tps sensor and iac...


Is the service engine light on or did you check for any codes? Was your TPS adjustable and if so did you adjust it properly? How about the last time you did a tune up and replaced the fuel filter? Maybe an ignition wire is burned by the exhaust.

Aug 26, 2011 | 1991 Ford LTD Crown Victoria

1 Answer

How do you check fuel pressure at the injection?


on fuel line/rail will be a valve looks like tire valve.very high pressure mush have proper equipment to check

Feb 11, 2011 | 1995 Toyota Camry

1 Answer

Why does my 1999 buick regal continue to stall


is it at idle or while coasting or while your foot is on the gas if at idle or coast probably idle air valve should be a check eng light on

Feb 09, 2011 | 1999 Buick Regal

1 Answer

I have one problem with valve body, becose missing parts and I nkow how rebuild.


chilton manuel is the best bet ior AAMCO for coast to coast work with a warenty too

Jan 22, 2010 | 2007 Mercedes-Benz R350

1 Answer

Automatic vehicle stalls at low rpm


This is proplem with the IAC valve , try clean the valve and if that doesnt work replace it.

An IAC (idle air control) motor is designed to adjust the engine idle RPM speed by opening and closing an air bypass passage inside the throttle body

Thanks
Kindly rate the answer
Smith

Jul 09, 2009 | 2002 Land Rover Freelander

2 Answers

Vibration while idling


Your engine needs tune up if you havent done this for a long time, also be alert of overheating check your temp gauge next time it happens again on a stop light. be free to comment,

Nov 21, 2008 | 2005 Suzuki Forenza

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...