Question about 1996 Buick LeSabre

1 Answer

Replaced fuel relay, still noy getting fuel - 1996 Buick LeSabre

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 31 Answers

If car has around 100000 , replace fuel pump. there is a jumper wire at the relay you can ground to make the pump come on . ground this wire and if the pump still don't run you know what to do... replace pump...

Posted on May 25, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of the fuel pump relay please!!


Noy able to tell what kind of car you are working in either.

Mar 15, 2015 | Cars & Trucks

1 Answer

Santa fe 2001- diagnos, P0190 fuel rail sensor malfunction. Car cranking only as if no gas coming in. At first we suspected the glowplug, we replaced new one but still noy working.


You have a fuel pressure or sensor problem.
1 The fuel pump is not working
2 The fuel filter is blocked
3 The pressure sensor has a electrical problem or failed

Feb 08, 2015 | Cars & Trucks

1 Answer

2002 s10 acts like its noy getting fuel


there is also the fuel pressure regulator

Dec 10, 2013 | 2002 Chevrolet S-10

1 Answer

Need to replace my 04 mustang fuel pump


Your fuel pump is in the gas tank on the vehuclie. You will need to lower the gas tank in order to gain access to it. If you are in need of something like instructions with some pictures, feel free to email me at csautomotivecars@att.net and I will be happy to make you up some instructions and maybe some tips as I have done to many of them. Have you checked your fuel pump cut off switch ? Also there is a fuel pump relay that should be checked befire going ahead with replacing the pump. If you do need instructions, I do need to know your engine size and remind me of the year and model of your vehicle. Yes the help would noy cost you anything, I don't mind helping.

Jan 10, 2012 | Cars & Trucks

2 Answers

96 nissan max, 5spd, hard starting. crank over, bu wont start, replace cam, crank.pos, ref sensors, fuel pump, inhibter relay, i seem to have no spark to plug , remove plugs and there al wet with gas,


Hello! First check fuse # 59 (7.5A)..If it is good the failure is a typical fault on your vehicle and is more than likely the cause...A defective ECCS relay (aka..EGI)...It is the ECM Module control...It is located in box 2 on the left side of the engine next to the battery....a common failure...The cost is under $20..see photo below...If the relay does not solve the problem...There is a Technical Service bulletin that addresses the issue...
EC97-018b NTB98-008b September 16, 1999
1995-99 MAXIMA EGI HARNESS WIRE BREAKAGE...Guru...saailer


1_14_2012_5_15_48_am.jpgSTANDARD MOTOR PRODUCTS Part # RY363

Jan 10, 2012 | 1995 Nissan Maxima

1 Answer

Has spark wont start


i would say either the timing is off or it s noy getting fuel

Nov 15, 2011 | 1988 GMC Suburban

2 Answers

94 dodge grand caravan no fuel in fuel rail


Dear Ron, you have replaced fuel pump and fuel filter. You have checked the fuel pump relay. Still no fuel in rail. Try bypassing fuel relay with jumper from batt to fuel pump. If o/k then check computer for ground to relay. This system uses a relay that is operated by the computer that supplies a ground for the relay to operate. The wire color is green,16 gage. If the ground is not available then "no fuel" Check this with a test light. Key on and crank apply test light to ground wire and other end of light to ground. You should hear relay click and get fuel. If this checks out you will need to replace computer or get creative with rewiring the relay so it works without computer input. Good luck Moe

Apr 24, 2009 | 1994 Dodge Grand Caravan

1 Answer

Want crank


you have a defective fuel pump relay

Feb 03, 2009 | 1997 Plymouth Neon

Not finding what you are looking for?
1996 Buick LeSabre Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...