Question about Jeep Liberty
DTC PRESENT IN THE TRANSMISSION CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 9 - ENGINE - DIAGNOSIS AND TESTING).
Diagnostic Test1. DTC PRESENT IN EATX CONTROLLER
This is an informational DTC letting you know that a DTC(s) is stored in the Transmission Control Module.
Erase this DTC from the PCM after all Transmission DTC(s) have been repaired.
Using a scan tool, read the Transmission Controller DTC and refer to the Transmission Category and perform the appropriate symptom.
PCM Diagnostic Information complete.
Posted on May 25, 2011
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 jeep liberty auto trans
p0700 is pretty much the generic code for saying the computer that controls your transmission has a problem, it may not be the actual computer its self, but one of its sensores, or a bad wire, i would recomend taking it to a reputable transmission shop
Posted on Apr 03, 2011
SOURCE: i have a code on
For the p0700 code you would need to have another scanner (DRBIII) connected to the Transmission Controller. The code you just retrieve indicates that there was an error detected by the transmission system.
You may need to raise the car or go underneath with a flashlight to view the places where there leaks can occur.
1. Underneath on the line where fuel is pumped into. There should be hoses attached to it. 2. Check the canister connected to the firewall inside the engine bay. Check if there are loose connections. Trace the vacuum lines that go from the canister underneath the car to the tank.
here is a link to see what this canister may look like:
3. Leak Detection Pump found at the driver side inner fender which has 3 wires connected to it. One wire is colored orange. Check the vacuum hoses connected to it.
4. Fuel cap. Worn out fuel caps may cause leaks in the system.
The best way to check the leaks are to pump smoke into the lines and check where in the car the smoke comes out.
Posted on May 14, 2011
Tips for a great answer:
Jan 12, 2016 | 2005 Jeep Liberty
Dec 08, 2015 | 2005 Jeep Liberty
Feb 14, 2013 | 2005 Jeep Liberty
Aug 10, 2011 | 2002 Jeep Liberty
Jul 13, 2011 | 2005 Jeep Liberty
Apr 03, 2011 | 2002 Jeep Liberty
Jul 11, 2009 | 2002 Jeep Liberty
872 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: