Question about 2002 Mazda 626

1 Answer

Air conditon and heater control will not move

The air and heater control button wont move to lower or higher,i thought maybe it might be a fuse but as a woman i used to work on cars,but i got a 2002 madza 626 recently and didnt have the manual in it, but as to helpful questions it would be great if you can tell me why you think that the reason the control to the air or heater wont work, it is a fuse i am almost positive but then i dont know where to look for it to remove and replace.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 17 Answers

The fuse box is located at the left suspension c ase at the fron the control is not working -- it could be the wiring please check with the fuse and then wiring you have a fuse case next to the left suspension at the front

Posted on Aug 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I was driving my 2000 Pontiac Montana with my heater on then all of a sudden it stop blowing hot air. Only cold air would come out of the vents.


ensure the coolent water level in your car system is full.
the heater radiator is set higher than the main system so when the water gets low there
is none in the heater.

as the fault came suddenly it also maybe the heater control switch or the thermostat has a problem
and has shut off the heat. check fuses to ensure there is not a problem there.

I hope this was helpful.

May 23, 2011 | Pontiac Montana Cars & Trucks

2 Answers

I have no heat replaced thermostat what else could it be?


Well if you are still getting air and it is just not hot it is most likely the heater core, but if it does nothing at all could be your blower motor, blower motor resistor, or blower motor relay, hope this helps! If you need instructions on how to change any of these parts let me know and I will send them!

Jan 12, 2011 | 1996 Buick Riviera

1 Answer

I am having problems with my heater in 2003 Malibu. Sometimes the air comes out cool even though I have heater control turned to hot. If I jiggle (twist the control back and forth many times) the air...


will try to assist you, lets start simple. with engine warm,, not hot,,remove radiator cap, check coolant level, if low, start engine with cap off, add coolant until full,you should see coolant in the radiator moving or bubbling, fill to top and replace the cap, careful not to burn yourself!! use a rag to put cap on if need be. if that works on heat, then it was only low on coolant, if not that, step#2 with motor off,, move engine fan by hand, checking for movement, will it turn?is it wobbly ,might have to pull it front of cat to back. meanibg back to front. any play? if good, no play, and no leaks diretly under the water pump, check black box under hood,main fuse box, under lid you should find fuse and relay positioning, check fuses and relays for GOOD all good? with engine running, make visual check for radiator fan to come on when engine reaches operating temperature. if all this is good, try 1 more thing just for good measure! replace radiator cap, sometimes, they look good, but are;nt. if this does not help, please repost your question and THANK YOU FOR CHOOSING FIXYA.COM!!

Nov 24, 2010 | 2003 Chevrolet Malibu

1 Answer

My 1999 ford windstar is only blowing cold air and no heat


possable problems:

1. coolant leak (level too low to fill heater core)
2. headgasket leak forcing the coolant out of the overflow.
3. stuck thermostat.
4. bad water pump. if the impelers are broken, coolant wont flow.
5. HVAC malfunction. system may think you selected cold or is unable to move diverter. maybe a fuse,solenoid or vaccum leak? (hvac controler uses vaccume controled soleniods)
6. airlock. if you have resently changed your coolant, you may need to repeatedly squeeze the heater core hose to help force out the air.

May 19, 2010 | 1999 Ford Windstar

2 Answers

Heater is blowing cold air is there a fuse? Or is there a cable that opens to switch it over from cold to hot?


There should be a heater control valve located under the hood in a hose. One hose goes into the firewall which flows through the heater core inside the rear of the dash and another hose coming out and back to the engine. It is probably a bad control valve or maybe the cable is stuck which opens and closes it when you move the knob on the dash. Have someone inside the car move the lever from hot to cold and see if the cable to the heater control valve moves. The rest depends on how handy you are. Should be an easy repair for your local shop.

Nov 30, 2009 | 1994 Oldsmobile Cutlass Supreme

3 Answers

My 2001 toyota tundra heater wont blow hot air. I checked to see if the heater core is cloged it seems fine the heater control valve is operating properly, and I changed the thermastat. and yet the heater...


If you've changed the coolant recently, it could be air locked in the heater core. To remove park the truck with the front higher than the back and remove the radiator cap. Start the engine and let it run while watching for a big air bubble burp coming out the radiator neck. Top off the coolant and continue.

Nov 12, 2009 | 2001 Toyota Tundra

1 Answer

'88 Camry AC buttons not working


fan speed controler could be bad, fan motor rellay could be bad.

Apr 14, 2009 | 1988 Cadillac Sedan DeVille

2 Answers

Air Conditioning doesn't work


Sounds like you are on the right track. Jump the pressure switch and see if the compressor comes on.

Aug 25, 2008 | 1999 Chevrolet Metro

2 Answers

2004 RX8 electric system


The radio screws holding the radio are not tight enough. to eliminate this problem remove the radio and adjust the pressure screw in the rear of the radio so it comes out farther>. if the radio is not far enough in the compartment to push in that button the radio controls will not work

Jun 12, 2008 | 2004 Mazda RX-8

Not finding what you are looking for?
2002 Mazda 626 Logo

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...