Question about Hyundai Veracruz

1 Answer

Is a special "powered" module

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 20 Answers

I would use a Curt 56024 T-Connector Kit. This lets you connect the wiring kit without needing to splice any wires.

Posted on May 24, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I disconnect starter in 2008 Hyundai Veracruz


Here is the procedure from Autozone.com
Removal & Installation Specific to:
Hyundai Santa Fe 2006-2008
Hyundai Veracruz 2007-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Negative battery cable and wait at least 3 minutes, Speedometer cable and shift cable from the transaxle, Starter motor wiring, Starter motor bolts, and the starter
To install:
Installation is the reverse of removal. Tighten starter motor bolts to 20-25 ft. lbs. (27-34 Nm).

Jul 24, 2017 | Hyundai Cars & Trucks

1 Answer

Do I require any special tools to replace the driver's side rear reflector on the bumper of a 2008 Hyundai Vera Cruz. It appears to snap in, but I don't want to break it. Thanks.


There's nothing in the manuals about special tools. I have the same problem. I think you'll have to remove the lower bumper in order to get good access to it. It appears that there is a black housing screwed into the bumper from the rear side and the lens would snap into that.

Apr 23, 2015 | 2008 Hyundai Veracruz

1 Answer

Wire up for trailer hitch


get kit on rock auto simple plug in or order from trailer store that sells reese hitches

Feb 10, 2015 | 2008 Toyota FJ Cruiser

1 Answer

Can factory foglights be installed in a 2008 Hyundia Veracruz? Knockouts are in the bumper and a knockout is in the dash. Is the existing wiring harness ready to just plug the fog lights in under the...


Not sure about Veracruz, but most of modern cars have the harness pre-installed to have additional factory things fitted, my Trajet had a plug behind the bumper, my Mazda had a plug for fog light just above the front wheel behind a cover. So I presume that your vehicle will have the same.

Feb 10, 2011 | 2008 Hyundai Veracruz

3 Answers

Need crossreference wiring on a 2008 dodge charger and aftermarket alarm


This link will get you 2007 which should be same. Good Luck.

http://www.the12volt.com/installbay/uploads/2007DodgeCharger.txt

Nov 03, 2010 | Dodge Charger Cars & Trucks

2 Answers

Install trailer hitch wiring kit


Sould be a simple plug in harness under rear of vehicle

Mar 05, 2010 | 2006 Chrysler Pacifica

1 Answer

No power to tow wiring harness


hello, if the vehicle came with factory towing, i has the relay already....sometimes they ship however without the fuse. the fuse should be behind knee panel on driver's side labed TOW or TRAILER good luck, marty

May 27, 2009 | 2008 Mercury Mariner

1 Answer

2008 subaru outback


Best to pop in to your local Subaru dealer and ask them what is required for wiring in a trailer plug, a lot of new vehicle require special equipment to prevent damage to the electronics that control the lighting on the vehicles, especially those that have LED style lights on them. Get a quote from them on cost of them doing the job, and for the parts only if you want to get someone else with a cheaper labour rate to do it.

Hope this helps,
Mark.

Nov 02, 2008 | 2008 Subaru Outback

6 Answers

Trailer wiring for 2005 Ford Escape without factory tow package


I had the sam problem with my '02 escape when I installed the hitch. I changed the turn signal relay under the dashboard on the drivers side of the dash with one from an escape that had a tow package(one was blue and the other was yellow...). worked fine for me after that. Don't know if it changed later...

Oct 17, 2008 | 2005 Ford Escape

1 Answer

Hyundai Veracruz GLS 2008 Tire Pressure problem


Keep taking it back to the dealer until the fix it or give you a new car. Not that it's an immediate safety issue, it's just something that's supposed to be functioning properly. They have to address it because cars are legally required to have TPMS systems for safety. If a safety mehanism fails in your car, you can claim it is a safety issue. If you keep having problems with the TPMS light, you'll eventually ignore it. Then one day you'll have a tire going flat and you wouldn't know it.

May 18, 2008 | 2007 Hyundai Veracruz SE

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...