Question about 2002 Mazda 626

1 Answer

I have a madza 626 2002 the air conditon was on recently but now the light is off and the knob that controls the heat and the air condtion doesnt go on, is it the fuse and where is it located at. i dont have a manual for the car

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 17 Answers

Madza 626 2002,s fuse box is next to the suspension inside the bonet, towards the left suspension

Posted on Aug 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

For about 5 months, my air condition would only work as long as I was driving. For the past two days I've notice: 1.)orange leakage 2.)burning smell 3.)over heating 4.)car shutting off when I stop with...


The vehicle has overheated that coolant that leak out that is why the air condtion doesnt get cold. The vehicle is trying to communicate to you you have a coolant leak going on

Apr 21, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

My air conditoner on my 200 cadillac el dorado wont go off


Will run with defrost or blend selected on the heat control,to help dry the air,shoudn't run when floor heat is selected.

Mar 06, 2011 | 2000 Cadillac Eldorado

1 Answer

My heat and air condition system are not lighting up


You need to set the fan control knob to #2 position and pull the knob off. Get a pair of needle nose pliers and extract the bulb. Take to the auto store and get a replacement.

May 20, 2010 | 2004 Volkswagen Jetta

2 Answers

My 1998 honda civic air condtion is blowing hot air


The system may be low on freon. I would see about an A/C service from a qualified shop.

May 02, 2010 | 1998 Honda Civic

2 Answers

A/C will suddenly send out heat. Fiddling with knobs seems to help. What's wrong?


You have a broken wire connection between the temperature control knob and the circuit board behind the center dash console. Vibration causes the failure and once the control knob gets loose the solder connection fails.

For someone that knows how to remove the dash unit and can re-solder a couple of new wires this fix should take no more than 1 hour. Make sure that you apply loctite to the heat control knob spindle nut when you re-assemble it.

The dealer quoted me 750 dollars to fix this issue and I found out that it's a common failure for this year. I fixed mine virtually for free but it took some tools and about an hour of my time.

Jun 02, 2009 | 2005 Toyota Highlander

1 Answer

Air conditon and heater control will not move


the fuse box is located at the left suspension c ase at the fron the control is not working -- it could be the wiring please check with the fuse and then wiring you have a fuse case next to the left suspension at the front

Aug 15, 2008 | 2002 Mazda 626

2 Answers

2004 RX8 electric system


The radio screws holding the radio are not tight enough. to eliminate this problem remove the radio and adjust the pressure screw in the rear of the radio so it comes out farther>. if the radio is not far enough in the compartment to push in that button the radio controls will not work

Jun 12, 2008 | 2004 Mazda RX-8

Not finding what you are looking for?
2002 Mazda 626 Logo

Related Topics:

371 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...