have a bmw m3 e36 3.0 which is sometmes difficult to start its like theres no fuel
Comments:
Sep 19, 2008
- had car diag no probs found! the car is only hard to start when hot. replaced fuel filter, fuel lines,fuel pressure regulator,and injector seals, still the same!
-   I had a e 28 M5 with the same problem, spent lots of time with it and found that the coolant temp sensor was reading wrong. also if your car has a hotmass air flow sensor in it and you using a k and n air filter the hotmass might have oil on it causing it to read wrong. had this problem with two m couple race cars I used to work on.
-   My e36 323 wont give me a first kick start I must a list try it 10 times before it start. I try changing my sensor no luck petrol pump, filter nothing no shore what to do know.
sounds like you have a faulty crank angle sensor or cam angle sensor or both. try replacing them one by one or take it to a workshop with a diagnosis tool to verify.
1999 M3 fob not setting alarm. Fob is working but not connecting hence the alarm is going off...
(More)
1999 M3 fob not setting alarm. Fob is working but not connecting hence the alarm is going off whenever key is turned in door or ignition, also alarm goes of whilst driving!
My '99 M3 will not start. I changed the battery and all the electronics work, but when I try to...
(More)
My '99 M3 will not start. I changed the battery and all the electronics work, but when I try to start it, the engine does not even turn over. Could it be the stock security system & if so, is the ignition cut-off computer controlled or accomplished mechanically through the ignition cylinder?
I have a 1999 m3 convertible. The top won't go down. The light does not come on. The motor was...
(More)
I have a 1999 m3 convertible. The top won't go down. The light does not come on. The motor was checked and its in perfect condition
This grub screw is located on the right handside of the block behind the exhaust maniflod. Was...
(More)
This grub screw is located on the right handside of the block behind the exhaust maniflod. Was wandering if there is anything behind it, as i need to remove it to seal it.
my power hood on my bmw 328 wont work??? it starts to but then stops!! also should i have a remote...
(More)
my power hood on my bmw 328 wont work??? it starts to but then stops!! also should i have a remote central locking key fob?