Question about 2007 Chrysler Pacifica FWD New Cars

Open Question

Esp light, abs, traction & all wheel drive light has come on . No one knows what wrong. Any idea?

Posted by on

  • yadayada
    yadayada May 24, 2011

    What system fault codes are present in the control module?

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ABS, ESP, Level warning lights (2004 Allroad TDI)

I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.

Posted on Oct 15, 2008

warlock61
  • 659 Answers

SOURCE: ABS light and traction control light come on together and go off

check the rear axles for a broken sensor ring

Posted on Nov 22, 2008

Hentie
  • 18 Answers

SOURCE: after replacing the left front wheel bearing on a 2003 ford focus, the abs and traction warning light stay on

The bearings on the wheels has to be installed one way only, the rotor ring is built into the bearing and if installed the wrong way round the sensor cant pick up the wheel speed causing the ligt to be switched on in the cluster. The diagnostic equipment should pick this up as a fault once the car has been driven, it will see the sensor when you do the diagnostic if the car is standing still but once the car is moving and no signal is send from that wheel it would register a fault into the memory of the PCM that you would be able to retrieve later.
There is a way for you to test the sensor yourself by using a multimeter set on volts, you jack the vehicle up at that wheel, install a vehicle stand to support the vehicle to be safe, disconect the wheel speed sensor and probe the two wires into the sensor, spin the wheel by hand and a small amount of current will be produced meaning the the sensor is working and the wheel bearing is installed the correct way, you can also do a continuaty test on the sensor by switching the multimeter onto ohms, but be very carefull, if this sensor has three wires you cant do the continuaty test because of the integrated circuit in the sensor, the three wire sensors opperate on a voltage from 5Volt and it would be destroyed by the multimeter opperating on 9Volt.
If the continuaty test passes and the bearing is installed the correct way, the most comon fault would be a break in the wiring leading to the PCM
Hope this will be helpfull.

Posted on May 04, 2009

  • 1 Answer

SOURCE: 2001 300M - the ABS & Traction Control Lights

You computer is not functioning correctly and is going to cost you over 700 dollars to replace. :) Have a nice day

Posted on Jul 22, 2009

  • 1 Answer

SOURCE: 03 Yukon Denali Traction Control/ ABS Problems

my 2000 yukon has the traction control light on and the abs light on any anwsers?

Posted on Nov 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does a red circle with a red triangle an ! Inside triangle mean on a 2004 audi


Electronic Stabilization Program (ESP)

The light will flash if you are driving and the traction control system is activated (it detects wheel slip on ice, water, etc.). This just tells you it is actively working. You should adjust your driving to the current road conditions to prevent loss of control.

If it stays on continuously, the traction control system (ESP) is off, or there is a problem with the ESP system. Usually, the ABS light will also illuminate if the ESP light is on due to a fault.

Apr 06, 2016 | Audi Cars & Trucks

2 Answers

Traction control light is coming on going around bend at only 50 mph


VWVortex.com - Traction control light flashing, losing power?

forums.vwvortex.com > ... > VW Model-Specific Forums > Golf IV R32

May 20, 2011 - 25 posts - ‎14 authors
So last night I was driving home, went around a pretty sharp turn and my traction control light started flashing for about 5 seconds, then went ... Traction control and ABS light issues
15 posts
Feb 22, 2010
E-Brake warning light stays on -- help
22 posts
Sep 27, 2004
More results from forums.vwvortex.com

Abs and Esp Lights on!? - TDIClub Forums

https://forums.tdiclub.com/showthread.php?t=333091
Oct 18, 2011 - VW MKV-A5 Golf/Jettas. ... Suddenly i noticed that the ABS and the ESP light on the dashboard was on. ... Fuel Economy: 47+ Avg (Passat DSG) 50 Avg (SE Manual) Warm Weather. ... I might suggest that your ABS and traction controlpick up their information ... A bent ring or bad sensor will set both errors. On-and off grinding on hard left and traction control light ...
Nov 3, 2015
ABS brakes activating when slowing down - wheel speed indications ...
Jan 20, 2012
More results from forums.tdiclub.com

Electronic Stability Control - Auto Diagnosis Repair Help


Dec 17, 2015 | Cars & Trucks

1 Answer

2004 LINCOLN LS TRACTION CONTROL LIGHT FLASHING & ABS LIGHT ON & BRAKE LIGHT ON. DTC CODES B1342, C1730, C1998.


first check brake fluid level then you will have to test the wheel speed sensors that the codes refer to. when there is a sensor problem it will activate both the abs and traction control lights. the red brake light comes on when there is low fluid condition(leak),worn brakes that need servicing. also if there is a abs module problem it can set codes. you need to know what the codes mean this is a starting place to diagnoise.

Mar 06, 2014 | 2002 Lincoln LS

1 Answer

Abs & traction control lights are on


You will need scanned the ABS Module to know exacvtly what fault code is stored there; with this copde number we could send you othyer details to solve it. Generally is the Speed Wheel sensor go to bad or loss connections.

Keep in touch.

Jan 25, 2012 | 2006 Buick LaCrosse

1 Answer

I have an Audi a4 2001 1.8t and the asr light its flashing, thanks for your help my name is Marcos Aguilar


ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.

For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.
tdisline_338.jpg


ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.

The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.


Check & replace if necessary the brake pedal switch placed above pedals on the support.
If the problem still occurs you might access the ABS ECU (Electronic Control Unit) using diagnostic equipment (VAS, VAG-Com, or similar) connected to the data link connector of the car, in order to pull out all DTC's (Diagnostic Trouble Code) memored. Then you will be able to replace bad piece(s) and fix the problem by erasing all DTC's stocked inside ABS ECU & reset it.


Good Luck!

Sep 07, 2011 | 2001 Audi A4

1 Answer

ABS light came on with a triangle and a circle around it with an arrow on the end. what does that mean?


ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.

For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.

tdisline_644.jpg


ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Jun 08, 2011 | 2004 Volkswagen Passat

2 Answers

2008 wrangler. abs, esp and traction control light staying on. checked brake fluid and fuses


Check first the third eye brake light. does it work? okay the problem reside in a ABS sensor make sure it is hook up or if you recently did a brake job it didnt get contaminated. When the ABS signal is interfered with ESP,Traction is disabled. One or some of the wheel speed sensor is disconnected or is being interfered with. This is common for a recent brake job if any occured

Apr 23, 2011 | 2008 Jeep Wrangler

1 Answer

The signals and symbols when a light turns on your car for example a light to change your oil, but i need to know what is a triangle with a circle around it. on a 2002 volkswagon jetta


ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.


tdisline_302.jpg


For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.

ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.

The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

Feb 23, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

Rumbly groan with turns at low speeds esp just beginning to move car Dealer just repalced entire rack and pinion and sway bar. no noise first day- today heard noise again


My esp light, all wheel drive light, traction light and abs lights have come on & won't go off. Tried everything I could think of. Tires are new, brakes are a little over 2 years old. Recently tires rotated. Maintenance done regularly . Whats wrong?

Mar 26, 2010 | 2007 Chrysler Pacifica FWD New Cars

1 Answer

2003 vw jetta 1.8 ESP light stays on, no traction control


The problem is almost certainly NOT the MAF sensor.
This problem can be caused by any one of the following
A faulty or dirty ABS wheel sensor...situated at each one of the 4 hubs
although the ABS light would usually illuminate if one of these sensors is faulty.....but NOT always

A faulty ESP switch The switch may be stuck in the open position, which WILL illuminate the ESP light and turn OFF your traction control.

Some models are also fitted with a YAW sensor, which detects side slip while driving. If this goes faulty it will also Illuminate the ESP light.
This sensor is bolted to the center of the floor panel..under the rear seat.
So as to save time and money..You should have the OBD codes scanned. This will pin-point the problem in minutes.

All the best
John


Nov 29, 2009 | 2003 Volkswagen Jetta TDI

Not finding what you are looking for?
2007 Chrysler Pacifica FWD New Cars Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...