Question about 1995 Nissan Pickup
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.
Posted on Jul 25, 2008
It appears we have an Air lock scenario and you will need to perform a system Bleed.
Park the vehicle on level ground, when cold remove coolant filler cap, start engine and leave to idle, turn heater on full and blower to max. When engine reaches operating temperature watch and listen near coolant filler, keep clear as gurgling and hopefully a boil over should occur. Top up with very warm coolant and wait as it may do it again.
Check for heat inside vehicle if warm replace coolant cap but keep an eye on temperature gauge as the ~Air lock may have moved on from heater matrix/core so proceedure needs to be carried out again from COLD.
Please press the Blue button to appraise my FREE Efforts, Thank You!
Paul 'W' U.K
Posted on Feb 24, 2009
simply "adding a can"is a good way to end up with non-functional A/C. the typical system has high/low pressure switches that enable/disable the system. you need to be at the correct volume of refrigerant as specified on the sticker under the hood. i recommend using the proper equipment, evacuating, pulling a vacuum, and then refilling the system with the appropriate amount.
Posted on Jun 23, 2009
On that model,it will cycle on and off while you add freon.If it does not ,then the ac system might have a problem.The low side pressure switch is located on,or near the accumulator .Unplug the switch and take the wire end plug and connect the two plug in`s together(cross it out on the wire).This will make the ac compressor engage and you can charge the system,do not leave the wire connected,plug it back up to switch.If the ac compressor does not come on ,then have the system checked out.
Posted on Jul 23, 2009
SOURCE: heater blowing cold air
My 05 sentra with 79k miles heat will warm up and then get cold after a mile of driving, we have tried to get the air pocket out, the mechanic stated he thought it could be a blown head gasket, another mechanic said it was a bad heater core. Any advice would be appreciated.
Posted on Dec 05, 2009
Tips for a great answer:
Jul 29, 2011 | 1994 Chevrolet S-10 Blazer
Jun 21, 2010 | 2002 Dodge Stratus
Sep 02, 2009 | 2007 Ford Five Hundred Limited Sedan
Feb 24, 2009 | 2002 Nissan Altima
Aug 02, 2008 | 1987 Dodge Pickup 2WD
Jul 21, 2008 | 2001 Jeep Grand Cherokee
190 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: