Question about 2003 Nissan Xterra

1 Answer

My wifes 2003 nissan cranks over but wont start. i removed backseat cover and checked power at the wiring harness, i didnt get any power at all, i checked the fuse panel but nothing is marked that says fuel pump?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Nissan Master
  • 726 Answers

You need to check for power as soom as you turn the key. you loose power afterabout 7 seconds after turning the key to "ACC position". there is a relay in system that shuts off tha power to the pump after about 7 seconds or so. personally I think that you have an issue with the sending unit. xterra has a campaign for sending ubit replacement, because they corrode on the inside of the connection on top where tha connector plugs in under the seat that you took out. This is what you will do: have someone crank the vehicle as you move the 2 wire connector on top of the gas tank. it may start. If not, then take your vin number to the nissan dealer and see if it applies for the sending unit replacement. you may even need new gas tank which is covered under the campaign if its too rotted on top.

Posted on May 24, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do i replace the distributor rotor on a 1993 nissan pickup


there are only 2 kinds
pull off, and unscrew off.
you didnt look first?

is this a , i cant find it? question.
remove the cap, they have 3 kinds on all cars
screws, twistlocks, and tabs

watch like a zillion folks do this on youtube yet.
or read the sevice manuals
or login to alldata.com and see it? step by bitty step there

Dec 26, 2014 | 1993 Nissan Pickup

1 Answer

98 mitsubishi montero, trying to by pass security, now wont turn over, maybe the starter lockout, but cant find diagram to trace correct wires


With the connector halves close together can you tell which wire goes into the connector? Its probably the same color, but check anyway. Once you are sure you can follow that one back to where it comes from and check for power

How was the horn kit wiring harness installed? Was it patched in? Did it have its own wiring harness? Trying to figure out how that kit could have had any effect on the starter.

When the key is on do you have accessory power?

Nov 25, 2014 | 1998 Mitsubishi Montero

1 Answer

300zx won't start, no spark


I had 1 about 2 years ago that did the same thing, it turned out to be the timing belt , pull the small cover off the timing gear and see if it's turning the cam

Jan 04, 2014 | Nissan 300ZX Cars & Trucks

1 Answer

2003 nissan altima hesitates when I start to excelerate


I assume that you have a 4cyl engine, and that problem is from the engine. there are two places that you can check, remove all ignition coils and see if there is any sign of oil on it, if it does, replace valve cover gasket and clean that coil. The second place is, a little difficult to check, look for the crank sensor, it located on the right/rear/lower of the engine (if you are standing on the driver side, look toward the rear of the engine, it's on your right and on the bottom of the engine), look for the harness, you will find a plug with a green tab, push it in and then pull the plug out. Any sign of oil, replace the sensor and clean that plug. Good luck!

Nov 04, 2012 | 2003 Nissan Altima

2 Answers

Is wiring harness on 2003 nissan altima interchangable with any other nissan


As far as the crank sensor plug they are the same on those,altimas. and i think sentras too. i would take the old one or sensor with you and check other nissans,

Aug 03, 2012 | Cars & Trucks

1 Answer

No start. replaced cam and crank sensors with nissan parts and still no rpm signal. i have twelve volts on red and green wire a good ground on the black wire and the white wire checked out to be good. the...


hmm are you getting any codes???? I would recheck & see if the connector on the crank sensor didnt come unplugged.... they can be tricky think you have it plugged in good & it comes loose

Sep 15, 2010 | 2003 Nissan Altima

1 Answer

2003 mitsubishi outlander died at stop light. wont start. turns over and has a full tank of gas. is getting fuel to engine.


very poss it could be crank sensor ,broken wire ? timing belt? advise installing scan tool that reads live data check eng rpm on scan tool see if shows eng rpm while cranking , poss remove upper timing belt cover make sure is turning and not damaged, poss computer related problem or power to eng systems would have to check for power at fuel injs and check for ground pulse with logic probe or led test light if crank sensor ok also check for spark at plugs with special plug tester and check codes first

Sep 14, 2010 | 2003 Mitsubishi Outlander

1 Answer

Turn key wont start- it cranks


check plug for fuel pump in harness near gas tank for corrosion and it may also have seoerated wire where it comes out of connecter the seperation may be from pulling on wires when pump replaced insulation may look alright because it streaches.

Apr 21, 2010 | 2003 Pontiac Grand Am

2 Answers

2003 Pontiac Grandam wont start


if you are not hearing the pump turn on there's a good chance that its the fuel pump most gm's have a faulty wiring on the fuel pump harness id check the relay and wiring if theirs power to the pump but not crank that would be it id get a gm pump not a carter better to use oem

Sep 27, 2009 | 2003 Pontiac Grand Am

2 Answers

No pulse on fuel injectors


i had a friend that his nissan did the same thing he had to replace the wiring harness.

Aug 04, 2008 | 1994 Nissan Pickup

Not finding what you are looking for?
2003 Nissan Xterra Logo

245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...