Question about 2006 Chevrolet Trailblazer

1 Answer

My power window and locks are not working,would this be caused by a blown fuse and which one(the #)

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 339 Answers

{: ) Check the DDM fuse10amp at the rear fuseblock. If okay, you need to pry and remove the driver door switch, but dont remove the connectors. Using a test light, backprobe on the two thick orange wires for presence of voltage. The testlamp should light, otherwise it is a wiring problem. Also check the black wire if its giving a good ground.
If everything seemed okay, it could be that the driver door switch is not communicating and need to be reprogrammed. If this doesn't work, then your driver switch has a problem.

Posted on Jun 17, 2011


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: Power windows inop

a brake in ur wires in the door,on a 04 grand i had the same problem,in the wire harness were the junction box is rust had broken one of the male prongs

Posted on May 05, 2009

  • 115 Answers

SOURCE: could a blown fuse cause the AC not to work? If

yea there r several fuses for the a/c system... not a likely cause but possible

Posted on Jul 14, 2009

  • 8 Answers

SOURCE: My power windows do not work in my vehicle. Could

It could be a fuse, but Id be more inclined to belive it to be the drIver side switch, it controls power to all the other windows in the car and if none are working, after checking the fuses, I would replace the switch in the drivers door.

Posted on Aug 01, 2009

  • 1810 Answers

SOURCE: Power windows and power door locks won't work

sounds like a bad conection also check under hood for accessory fuse pannel

Posted on Jan 10, 2010

  • 1297 Answers

SOURCE: Power windows and locks dont work, lights on the

yes and yes

fuses could be a problem but the door lock fuse is #12 under the hood

window fuse is #12 under the dash

the dimming of the dash lights sounds like a ground issue that ground 200 at the center of the dash behind the air bag module

let me ask...did all these problems start at the same time?

Posted on Apr 06, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does fuse keep blown when I deadlock my car / Central locking and power windows run off this fuse

Simple answer - you have a short in the wiring or a bad lock/window activation motor. The solution - not so simple, just a lot of work tracing down the cause.

Apr 01, 2016 | Cars & Trucks

2 Answers

My power windows quit working all at once,no warning there was a problem. I have a 2001 Ford Explorer XLS

Have a look at the fuse first The fuse must be in the main fuse box. The position and function of the fuses is normally marked on the inside of the fuse box cover and also in the owner's handbook. If you don't come right with these, work your way through the fuses looking for a blown one. To ease your search for the window fuse, it should be around 30 amps.

Mar 17, 2011 | 2001 Ford Explorer Sport

2 Answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere

First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

Mar 15, 2011 | 2005 Ford F-150

1 Answer

Power windows wrx. None of them work. Where is the relay or fuse?

The windows are fed through a 30amp fuse in the engine compartment fuse & relay box. It is a fuse-link type with a see throuh top, square pink fuse. This fuse feeds the windows and central door locking. If it is blown I would suspect another issue has caused it, Have seen worn front door wiring create this issue.

Aug 19, 2010 | 2002 Subaru Impreza

1 Answer

What could cause my power locks and windows to not work replaced master control window switch Thanks

You may have blown the Power lock & window fuses when you replaced the master control window switch. Go to fuse box and check for blown fuses. Be sure to replace with same value of fuse.

Mar 26, 2010 | 1992 Toyota Camry V6

1 Answer

Power window on passenger wont allow me to put the window down and the power lock wont work as well can it be a fuse blown?

No fuse would cause all windows and locks to fail. Check relay at door for broken pin in switch

Mar 05, 2010 | 2003 Honda Accord

2 Answers

My power window interior door lights quit lighting up could the bulbs be blown

If the power window itself still work fine, and the illumination on the driver's side door lock still work, then the LEDs behind the switch are the issue ( usually bad solder joints ).
If you are talking about all doors other than the driver's side, do you have the window lock on ? The lights on the switch turn off when the driver's side window lock is enabled.

Feb 01, 2010 | 2004 Ford F150

1 Answer

Power windows and power locks wont work

Check your fuses first. Then check for power at the switches, and power from the switches to the respective solenoid and motor. Most likely it's fuses. Also check where the wiring runs through the door into the car for bare spots in the wiring that might have blown the fuses.

Jan 21, 2010 | 2004 Mitsubishi Endeavor

2 Answers

Door panel got wet on 97 blazer, now power windows dont work?

fuse blown check fuse and if fuse ok then dry switch with hair drayer. hope this helps?

Aug 25, 2009 | Chevrolet Celebrity Cars & Trucks

1 Answer

Power windows power locks and sunroof are not working

Ok, first thing is to do a fuse check. check all fuses in the fuse box area for blown circuits. replace any fuse that is blown. there will be a fuse layout on the back side of the fuse panel door. this layout will show a readable diagram of where the fuses you Will need to check are located.

May 29, 2009 | 1998 Toyota Camry

Not finding what you are looking for?
2006 Chevrolet Trailblazer Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides