Question about 2006 Chevrolet Impala

1 Answer

When I push the air conditioning on button it will not stay on, it blinks & then goes off. The fan is working,

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Charge more 134A to the system or check the pressure of the low side if out side temperature is 80f pressure should be 40 to 55 psi if pressure is lower check hi side if pressure is over 200 psi the expancion valve is damage or got a problem in the evaporator the hi side work with a pressure from 140 to 180psi

Posted on Jun 20, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blinking AC button of Honda Civic 2003


HEATING AND AIR CONDITIONING
HONDA CIVIC 2001 - 2005
How to retrieve DTC:
The heater control panel has self-diagnosis function. To run the self-diagnosis function, do the following:
1.Turn the blower fan OFF.
2.Press and hold the recirculation control switch and the rear window defogger switch down.
3.Turn the ignition switch ON (ll).
4.Release both switches. The recirculation indicator and the rear window defogger indicators come on. The recirculation indicator goes off 3 seconds later and the A/C indicator comes on, then the self-diagnosis will begin. About 10 seconds later, the self-diagnosis will finish and the A/C indicator goes off.
- If any trouble is found, the recirculation indicator blinks the diagnostic trouble code (DTC) to indicate a faulty circuit or component.
- If the system is ok, the recirculation indicator stays off.

DTC TROUBLESHOOTING INDEX
DTC (Recirculation indication blinks) Detection Item Page
7An open in the air mix control motor circuit.21 - 16
8A short in the air mix control motor circuit.21 - 16
9A problem in the air mix control linkage, door, or motor.21 - 17
10An open or short in the mode control motor circuit.21 - 18
11A problem in the mode control linkage, doors, or motor.21 -19
12A problem in the blower motor circuit.21 - 20
13A problem in the EEPROM in the heater control panel;
(THE CONTROL PANEL MUST BE REPLACED).21 - 38
14An open in the evaporator temperature sensor circuit.21 - 23
15A short in the evaporator temperature sensor circuit.21 - 24
- In case of multiple problems, the recirculation indicator will indicate only the DTC with the least number of blinks.
- In case of an intermittent failure, the heater control panel will store the DTC until the ignition is turned off.

Mar 17, 2013 | 2003 Honda Civic

1 Answer

2000 Jeep Grand Cherokee Blower on A/C Goes On & Off.


sounds like system is low on freon,? safety switch turns system off when too low on freon to prevent burning itself (the compressor) up...

Jul 07, 2010 | 2001 Jeep Grand Cherokee

2 Answers

My 1998 ford taurus overheats when idling but cools down when you drive what should I do?


Check your your radiator cooling fan should come on at about 220 deg. and off at about 210 deg. at idle with a/c off, if it stats to over heat turn a/c on, fan should come on right away, if it dont check voltage at fan motor, if you do have voltage, you have a bad radiator fan motor, more then likely the reason it don't over heat while driving is air is being push through radiator where it cool's the coolant before it goes back into the engine, at stop's no air running through and never cool's coolant .

Jun 26, 2010 | 1998 Ford Taurus

1 Answer

I have a 1992 mercedes 200 E WDB 021 Saloon, it has 8 button air condition and I dont know how to use it. Control wheel on blue position but When I push the button (leftmost)which has a glass figure on it,...


The pulley on the air condition has to turn it has a belt on it. The Compressor engages to pre cool the evaporator. Most likely you have a blend door pod leak or leak in the hose or the sampler valve is bad. I would replace the sampling valve behind the glove box/air bag. As that reads the cabin temp and if it thinks the car is cold the heat will stay on because everything is automatic. All vents will blow cold when it thinks its hot and in addition to floor and corner dash center vents will blow cold when it works. If the direction of air is correct then the A/C system may have a leak or need a charge of freon.

May 05, 2010 | 1992 Mercedes-Benz E-Class

1 Answer

2003 MALIBU AIR CONDITIONER


Love mine too. I had the same prob with the a/c...found a fix online where you take the switch panel out, take it apart, clean the contacts with alcohol and then write on them with a #2 pencil (coat them with the lead) and then reassemble and it worked like a charm for me. Mine started to do it again this year, but it at the end of summer and I didn't get around to doing it again, but will before I need the a/c again. And time again for front brakes and rotors for me! 85k and going strong!

Jul 31, 2009 | 2003 Chevrolet Malibu

1 Answer

Air conditioning switch goes off and on while recirculating air


If I understand correctly the A/C light goes on and off. If so, try to gently push the switch to the side(Not in) while the A/C is on. If this keeps the system working, you need a new control assy(Complete control head)

Jun 19, 2009 | 1998 Chevrolet Malibu

3 Answers

Air conditioning blower stays on at all times.


Per your description, I believe you may have a blower fan relay that is stuck closed.
Remove the relay from the under-hood fuse center and see if the fan stops.
If it does stop, put the relay in slowly and see if you here the relay "click" and the fan come back on.
Let me know.
Regards,

May 07, 2009 | 2003 GMC Sierra

Not finding what you are looking for?
2006 Chevrolet Impala Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...