Question about Jeep Wrangler

Open Question

The Horn in my 1991 YJ Jeep Wrangler doesn't work. I was trying to find out where the Fuse and Relay is located with no luck. I found two electrical boxes. One is underneath the Dashboard and the other one is close to the Battery. One of the Lids is not there and the other (engine compartment) has not readable any type of fuses/Relay locations. How can I see a detailed Horn electric diagram and a picture of the inside side of the Lids?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...

I think I have found the problem. When I wiggle the ignition switch the turn signals and radio go on and off so I feel the issue is in the ignition switch. From what I understand the actual electronics for the switch are at the base of the sterring column behind the lower dash panel and is connected by a rod that may need adjusting.

Posted on Jan 04, 2009

  • 4 Answers

SOURCE: Jeep wrangler Fuse box

i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck

Posted on Jun 30, 2008

SOURCE: 1991 JEEP YJ WRANGLER CLUTCH

Check clutch fluid. Also check for clutch fluid leaks. I just found out that I had the same problem.

It is a leak of clutch fluid (brake fluid) under the dashboard. My mechanic says it's a simple fix.

Posted on Aug 06, 2008

Mikey108
  • 475 Answers

SOURCE: 1989 Jeep Cherokee - Electrical Problem - horn, brake lights, blinkers, radio/cd...

There could be a fusible link under the hood off the starter relay that is burnt out.

Posted on Oct 13, 2008

  • 5 Answers

SOURCE: 4wd problem jeep wrangler yj 1995

i just bought a used 97 CHEROKEE but i had the same problem, when i got to looking at it i found out the front driveshaft was shot, look at that, if its not it i would say its probably the transfer case especially with an older vehicle like that which is a very expenxive repair

Posted on Dec 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my horn relay located?


in most cars, if it even has one. is in the fuse box.
1993. first real chrysler car. and real engine controls by same with OBD1, good best older year car.
RTM read the manual yet?
the FSM
?
chapter 8G is HORN, and horn options.
page 2 covers the relay test.
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

chapter 8w-11 show the fuse box. and relay , clear as day
YJ is pdf page 90 (wiring)
XJ is pdf 165, dual horns.



Sep 17, 2014 | 1993 Jeep Cherokee Country

1 Answer

Free belt diagrams


http://serpentinebelthq.com/1991-jeep-wrangler-yj-4-0l-serpentine-belt-diagram/ her is a link for you to a diagram. I hope this helps

Jul 08, 2014 | 1991 Jeep Wrangler

1 Answer

Horn doest work


the horn have fuse and relay in engine fuse compartment.inspect all the fuses. in your owners manual is the location of the fuse and relay. if OK, one person push the horn and other check power to the horn.if no power swap the relay with other one for test.if you SRS light is ON and the horn does't work suspect the clock spring(soft connection below the steering wheel to column)
good luck

Apr 12, 2014 | 2012 Jeep Wrangler Sport Convertible SUV...

1 Answer

Horn does not work


Guessing it's an SE. If 20A fuse 20 in the power distribution center is OK, pressing the horn switch closes the horn relay and the horn(s) should blow. If not, the horn(s), horn relay or horn switch could be defective. There's not much else that go go wrong

Sep 30, 2012 | 1997 Jeep Wrangler

1 Answer

I just bought a 1993 jeep wrangler 4wd. The only thing is the horn isn't working. How can I fix this?


First check that the fuse for the horn is good and if it is you will need to replace the horn relay that is found in the under hood high amp fuse box.

Feb 22, 2011 | 1993 Jeep Wrangler

3 Answers

Looking for Service Repair Manual Jeep Wrangler YJ


i have a 1988 jeep wrangler 6cyl with 5 speed transmission. I was shifting the jeep and it got stuck in third gear. We opened it up and saw that the linkage is aligned and everything is in place. I dont know what is wrong and what to do next. please help ....

Jul 10, 2009 | 1992 Jeep Wrangler

1 Answer

Jeep wrangler Fuse box


You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.

Jan 10, 2009 | 1997 Jeep Wrangler

1 Answer

Where does the 2 wires from the horn connect to on a 1994 Jeep YJ


You should really have the service manual at hand; they will contain color coding of all of the wiring. Either Haynes or Chilton will have all the electrical diagrams and the most serivce work you can do at home on the mechanical stuff. They cost between 20-30 dollars US and can be had at auto parts stores. 

Many horns are not directly controlled by the horn button but by a relay on which the horn button works. 

Dec 11, 2008 | 1995 Jeep Wrangler

1 Answer

YJ Blinker Relay


Hi there,

Both the hazard and the blinker flashers are located on the fuse panel. They pull straight out.

When both turn signals fail, the cause may be a blown fuse, a faulty flasher, a broken turn signal switch or a bad connection.

When you try the turn signals, do they light up and not blink?
-If so, probably the flasher unit.

When you try the turn signals, does nothing happen?
-Check the fuse

Let me know if the problem continues after replacing the flasher.

Mike

Aug 30, 2008 | 1988 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

449 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...