Question about 2003 Nissan Frontier Crew Cab

1 Answer

Truck turns over but no fire to the spark plugs.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 672 Answers

Possible camshaft sensor failure or computer failure. Check if all coils aren't firing, do not mix them up!! Camshaft position sensor sends signals to the computer, in return send an electrical pulse to each coil. If the sensor fails, a "NO SPARK" or "RANDOM NO SPARK" may occur!!

Posted on May 24, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My crown vic turning over but wont crank never did this before


The most likely cause is a bad ignition coil, remove the coil wire from the distributor and attach an old spark plug to it, have a helper crank the engine, and see if the spark plug fires. If the plug does not fire then the coil is bad. If the plug fires, remove a plug wire from a spark plug and repeat the process. If no spark then the distributor cap may be bad? Also have you ruled out no gas???

Jan 11, 2015 | 1992 Ford Crown Victoria

1 Answer

Truck wont start engine turns but wont fire


If the trucks turns over and does not seem like the battery is dead I would assume it is spark or fuel. Check spark plugs to make sure they spark. Pull one plug at a time hold it against side of engine and have someone turn the truck over for you. You should see bright spark from all spark plugs. If you do see spark then check your Fuel Pump to make sure it is getting power and is opperating correctly also check your fuel filter to make sure it is not plugged. Good luck, Hope this helps.

Sep 05, 2012 | 2005 Chevrolet Colorado

2 Answers

Wont start no spark on spark plug


For spark plug problem, click the help links provided below: ---
Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

------------
How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

-------------
Car cranks, has spark but will not start?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

------------------------
The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

----------
How to gap spark plug ? http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------
Spark plug Replacing for?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

-----------
How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

---------
How does the spark plug wire go on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

---------
Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

-----------

This will help.

Thanks.

May 24, 2012 | 1990 BMW 525i

1 Answer

How do you check if you spark plug is firing


Take out the spark plug, place wire back on plug. Hold wire/plug by wire's boot, so firing end of plug is close to (1/4" away from) a ground like the engine block, exhaust manifold, etc.

Have some one turn the key so engine turns over.

If you have good spark you will have a bright blue spark from plug to exhaust manifold. you better use well insulated pliars to hold plug or a piece of wood to hold it to a ground to see if it sparks. good-day !

Mar 27, 2012 | Cars & Trucks

1 Answer

I have a 92 camry 4cyl. Won't fire at the sparkplug. Replaced plug wires and plugs, distributor, igniter and still won't fire. Any suggestions?


Take out a spark plug, lay the plug (with the spark plug wire attached)on the engine and turn the motor over, if it sparks, your getting fire, Try each plug, works best a night so you can see the spark.

Sep 11, 2010 | 1992 Toyota Camry V6

1 Answer

It turns over just doesnt fire up


WELL IF IT TURNS OVER BUT DOESN'T RUN YOU MAY HAVE A NO FIRE CONDITION, NO FUEL CONDITION, OR A FUEL/AIR METERING ISSUE. IN ORDER TO CHECK TO SEE IF YOU HAVE SPARK, TAKE A SPARK PLUG OUT AND CONNECT IT BACK TO THE PLUG WIRE AND HAVE SOMEONE TURN IT OVER IF YOU ARE GETTING A SPARK THEN IT MOST LIKELY IS A NO FUEL ISSUE.

May 10, 2010 | 1999 Dodge Ram

1 Answer

Change spark plugs on 2007 Toyota Camry


In servicing the spark plug . If the owner will be the one to change the spark plug then. the owner should locate the spark plugs . then prepare the equipments that is going to be used to change spark plug .First disconnect the spark plug cable to the spark pug . Then use the equipment to take the spark plug off to the engine. The spark plug should be twisted counter clock wise using the equipment to remove the spark plug.Then replace the spark plug.In returning the spark plug ,using the equipment you have to twist the spark plug clock wise . Then set the distributor shaft turn it according to the proper firing order that will be set to the spark plug if it is 1,3,4,2. Then the distributor shaft mark will be on 1.If 2,3,4,1 then the distributor shaft mark will be on 2. Then connect the spark plug cable , after connecting the owner have to test start the car so that to if it back fires .If it back fires then the owner have to repeat again the setting of the firing order of the spark plug until it will not back fires.If the owner don't have time to do the job in servicing or changing spark plug then the owner have to go to a car mechanic and let them change the spark plug.

Sep 26, 2009 | 2007 Toyota Camry

1 Answer

1981 bmw 320i- motor turns over and briefly fires and then dies


make sure you have the right firing order for the spark plug wires from the disbutor to the spark plugs. thats the most common for motor turns over and briefly fires and then dies. try looking up the firing order for the spark plug wires.

Jul 22, 2008 | BMW 323 Cars & Trucks

Not finding what you are looking for?
2003 Nissan Frontier Crew Cab Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...