Question about 1997 Jeep Grand Cherokee

1 Answer

How do I put the radio antena down to go through a car wash?

Posted by on

  • Tom Mooney May 24, 2011

    If you switch the radio "Off", does the antenna retract?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

If it's an electric antenna, it should retract when you turn the radio off. If not either the relay or the drive motor has failed. if its a "fixed" antenna, you don't do anything and just leave it in place.

Posted on May 24, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is radio antenae connected?


To the antenna itself. If you remove the antenna and pull it out you will see where it is connected.

Jan 20, 2013 | 1999 Ford Windstar

1 Answer

I need to reconnect the radio to the antenna how do you get access to the back of the radio to plug in the antenna?


To gain access to the antena plug on 98 and later models the intrument cluster bezel has to be removed and the radio mounting screws removed in order to get to the connectors for the radio and antena connectors.TO remove the bezel you want to first remove the negative cable so that you dont accedentully set off the airbag system.Then you want to put the steering wheel in the lowest position and remove the screws in the bezel.Then with a flat screwdriver carefully pry the bezel the bezel out of the clips.Once this is done you will have access to the radio mounting screws.I hope this helps .

Feb 03, 2011 | 2003 Kia Spectra

1 Answer

Power antena after markit how to make it work with radio


on the radio there is a cable that is for Power Antena you might have to set a cable out to the area you are instslling the antena if this car already had a power antena you only need to hook up the leds from the old if not then like i said you need to get positive cable out to the antena and ground it to chassis

Apr 01, 2010 | 2000 Mercury Sable

1 Answer

How do i put the radio code in my 96 grand cherokee jeep


Jeep grand cherokee ltd, 1996 The radio is not working, when I switch the power on the antena motor makes a noise although the antena is always up, there is no sound from the radio what so ever, it says WAIT 2 1/2 hours but nothing happens, no tape radio cd, switch the radio off the antena makes a noise then the radio switches off.

Mar 14, 2010 | 1996 Jeep Grand Cherokee

2 Answers

How do I remove and replace the stock radio in a 2008 Dodge Avenger?


I could type this all out but i found this link for you. Not from this site but is very detailed.

http://dodgeforum.com/forum/2008-dodge-avenger/127430-radio-console-removal-instructions.html

Feb 03, 2010 | 2008 Dodge Avenger

1 Answer

1985 ZX300 power antena problem. When the radio is turned on the antena goes down and when it is shut off the antena goes up. Al factory parts, radio, antena and all switches. Any ideas what would cause...


im guessing the antenna has been replaced and wires were mixed up. take the rear panel off in the trunk to give access to the antenna motor and look at the wiring there should be 2 small wires and one larger black wire. the black wire is the reception wire the other two are the power wires. switch the positions on the two power wires. say wire A is in plug 1 and wire B is in plug 2. final position should be A in 2 and B in 1. that should take care of it. good luck

Jul 08, 2009 | 1985 Nissan 300ZX

1 Answer

No sound on radio


The car also has amplifiers. Check all the fuses besides the radio. That might fix your issue.

Mar 12, 2009 | 1996 Eagle Vision

2 Answers

Radio wiring diagram


These are factory radio harness wire colors and there function.

1997 Chevrolet Cavalier Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Orange
Car Radio Switched 12v+ Wire: Yellow
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger: Pink
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

Nov 08, 2008 | 1997 Chevrolet Cavalier

1 Answer

Installing a after market stereo


most of time the antena power is blue coming from radio, locate the one in the car going to antena and conect the blue antena wire to it

Jun 19, 2008 | 1990 Mercedes-Benz 300 Diesel

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...