Where is a crank sensor located on a 2001 jeep

Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .

If you know the location and it's already removed, then just reinstall the new one and reconnect it. Do you have any specific problem?

i changed the crank position sesor but still doing the same wont fire over.

If all the fuses are good,replace the crank shaft sensor,this is the problem.

check your crank sensor located on the side of the transmission

easy trouble shoot easy fix ! check to see if its getting fire if not replace the crank sensor it will fire right up common problem with the jeeps . Hope this helps you out !!!

wall5552: there were two engines used in 1992 Jeep Wranglers.
A 2.5 liter and a 4.0 liter. HOWEVER>>>> The location for the crank angle sensor is the same for both.
It is located on the bell housing up near the front at about the 10:00 PM position.
The Cam position sensor is located in the Distributor on both engines as well.

Without actually looking at the jeep, this is a shot in the dark. Replace the crank sensor (if it's bad, you will get no spark or fuel pulse). It is located on the tranny bell housing on the left side.

Check the cylinders Commpression. over 115 psi is good, 120 psi is normal.

The crank sensor is a well known cause of no spark condition, it is most likely the real problem, the crankshaft sensor for a Jeep 2001 is located behind the starter, you have to remove the starter to gain access, even then it is hard to get at.