Question about Chrysler Voyager

2 Answers

Hi,My engine light came on this afternoon while driving, Im not sure what is the problem, I've check over the internet and managed to get the fault code P1685... then done. Im using both original grey set of key from Voyager. Since I do not see other fault and it only shows one code,do I need to get it to Chrysler Main dealer and have it diagnose for 120? I experiencing 2 unrelated fault while driving: 1) One month ago, when I started the car, and Push to D,the automatic gear will not rev up,the car seem to pick up very slow even though with full acceleration on the gas pedal . After I switch off the engine and start again,its back to normal without any fault. 2)Today, While driving on a constant speed,the gear suddenly shift down on it own(automatic gear) and after a few second the engine light came on. Even with the engine light on,the car drive faultlessly like nothing ever happen. Please advice, It is really appreciated Regards, Joyce

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,841 Answers

Code PO1685 means invalid SKIM key (Sentry Key Immobilizer Module), and refers to a problem with the ignition key or the module itself. Take your vehicle to your local Chrysler dealer for repair.

Posted on May 23, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,252 Answers

Take it to a autozone parts store and they will put there computer on it for FREE. and let you know what the problem is....

Posted on May 23, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Obd2 code p0562


Low battery charge, Battery Defective(Could have a bad cell), Loose or missing alternator drive belt, Faulty Alternator, Open or short system voltage circuit

Apr 11, 2017 | Mazda RX8 Cars & Trucks

1 Answer

OBD2 CODE READER P0562


fully charge battery and make sure everything switched off i.e rear window demist etc and take it for a run to get it up to tempature then park up rev engine at fast idle approx 2750 rpm for 180 seconds then take foot off throttle and allow to idle for 30 seconds this will clear your catalyst and get it up to the 600 degrees needed for it to operate properly this should remove the engine warning light

Apr 21, 2013 | Mazda RX8 Cars & Trucks

1 Answer

OBD2 CODE READER P0562


Make sure your 12V grounds to engine and chassis are good.

Apr 11, 2017 | Mazda RX8 Cars & Trucks

1 Answer

Vito 2006 109cdi. fuse number 41 is blowing (engine fuse)


engine light stays on
the ecu will have fault codes stored to be read
that will point to the cause and a fix of the over load

my best information on a vito if diesel..says
10 amp fuse 41 . glow plugs


you must need the van on the road very badly
30 amp in a 10 amp fuse position can
melt the wiring even a fire


index-ldszvhuomwkbtubxskurqnxk-1-0.jpg

Apr 06, 2017 | Cars & Trucks

1 Answer

My '98 Nissan Altima is heating up.


did you check to see if the fan comes on at all

Aug 31, 2012 | 1998 Nissan Altima

1 Answer

2003 Mazda MPV - started the van up this afternoon and it was running very sluggish and jerky...especially when at a stop but not necessarily while in park idling.


Sounds like you are having random misfires of your plugs which could indicate a need for a tuneup (or if you've changed your plugs, you didn't use the OEM plugs). What's your mileage? Is your check engine light coming on?

Apr 22, 2011 | Mazda MPV Cars & Trucks

1 Answer

Check engine light on


The new sealed batteries fail without any warning, drive to the store, come back out the battery is dead, the other issues you have are caused by low system voltage, replace the battery and all should be well.

Sep 01, 2008 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

427 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...