SOURCE: 2002 jeep cherokee laredo
the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.
SOURCE: change a serpentine belt on 04 jeep grand cherokee laredo
Check this link & scroll down to your engine. Click on picture to expand.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004328a
SOURCE: How to replace cv boots front end of 1999 jeep
dont replace the boots the cv is junk relace the shafts the shafts rebuilt are 59 or 69 $
Testimonial: "Thanks very much.With the economy we can only afford what is neccesary."
SOURCE: 1998 Jeep Grand Cherokee Laredo 4.oL I got a code po113
Trouble Code: P0113 (4.0L L6 VIN S Auto)
IAT Sensor Circuit High Input
Print this code data
Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
Check with ignition on or engine running; battery voltage more than 10v; The PCM detected the IAT Sensor input was over 4.90v (exc. Dakota, Durango, Ram) or 4.98v (Dakota, Durango, Ram) for 3 seconds.
Possible Causes:
SOURCE: I have 2001 Jeep Grand Cherokee Laredo and it is leaking coolant
Front drivers side could be a bad cap, lower hose or the radiator itself. You need to look carefully and find the leak source. Steam travels and isn't a good indication of where the actual leak is coolant will run down and take any path it can to reach the ground. Therefore, you need to follow it back to where it is coming from, then deal with it. Your water pump can also leak and run down the lower hose. there is a small hole in the pump behind the pulley. If you see coolant coming from there the pump needs to be replaced. Sealers will not work on hoses or pump leaks so don't bother using them for that.
Good luck...don't forget this is free, so rate answers!
I will answer follow-up questions too!
100 views
Usually answered in minutes!
×