Question about Ford Mustang

1 Answer

The 86 ford mustang that I purchased has had the hood replaced and does not have the correct VECI. I need to somg the vech and have it inspecterd by the DMV. were can I gvet the correct lable

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Dealer item only

Posted on May 22, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Vacumn line routing for 97 dodge 5.9ltr Cummins diesel 4X4


By law, each vehicle is equipped with a Vehicle Emission Control Information (VECI) label which is permanently affixed. On the models covered in this guide, the label will be found in the engine compartment with typical locations being on the underside of the hood, the top of the radiator, the alternator bracket and the air cleaner box.
The VECI label provides a vacuum schematic for the vehicle in question. Because vacuum circuits will vary based on year, various engine and vehicle options, always refer first to the vehicle emission control information label.
VECI labels are designed to be permanently attached to the vehicle and cannot be removed without being destroyed. Absence of the label in your vehicle may indicate undocumented repair work has been performed.
If you wish to obtain a replacement emissions label, most manufacturers make the labels available for purchase.

Feb 14, 2016 | Dodge Cars & Trucks

1 Answer

Vacuum line diagram for 98 4 X 4 Ford Expedition

Look on the VECI label (Vehicle Emissions Control Information) under the hood, likely on the radiator support. The vacuum diagram should be shown there.

Aug 05, 2014 | 1998 Ford Expedition

1 Answer

Where does the timing mark on the timing cover line up on a 1997 Buick lesabre 3.8 liter?

Look on your VECI label under the hood (Vehicle Emission Control Information) for the base timing spec. When you shine a timing light down there on it with engine running at idle, the mark should be on the correct position on the scale-whether at 8 degrees Before Top Dead Center, or 10 degrees BTDC, whatever the VECI label says.

Apr 11, 2013 | Cars & Trucks

1 Answer

Where can i find engine number of ford excursion 2005 model

The 8th digit of the VIN is the engine ID. Also it can be found usually under the hood on the engine cover or the radiator core support/fan shroud. The VECI label on the bottom side of the hood will also have the engine info.

Mar 27, 2013 | Ford Excursion Cars & Trucks

1 Answer

Vacaum lines ford crown V digarim

It's under the hood of your car. It's known as the VECI label or Vehicle Emmission Control Information. That's where the vacuum hose doagram is for all cars. It's usually on the bottom side of the hood.

Jun 24, 2010 | Ford Crown Victoria Cars & Trucks

1 Answer

My 86 gt mustang will prime but won't stop priming

The pressure regulator is bad,it is allowing the fuel to pass threw to the cylinders,replace the regulator,and a new set of goos spark plugs.This is the fuel pressure regulator.

Oct 27, 2009 | 1986 Ford Mustang

2 Answers

Where is the relay for the fan motor for a 2001 Ford Mustang?

In the fuse box under the hood. At least if I remember correctly.

Jun 04, 2009 | 1995 Ford Escort

1 Answer

86 2.3l mustang pops and backfires once warmed up

If your car works fine when you push the gas but bogs in normal conditions it may be your timing is off.

Jan 08, 2009 | 1986 Ford Mustang

1 Answer

86 mustang 5.0

sounds likee you need to reprogram your computer or there is not enough fuel pressure to keep car running

Nov 12, 2008 | 1986 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides