Question about Chevrolet Colorado

Open Question

After unhooking the battery with the drivers window down, the window and the locks quit working. I have tried the fix theory on the net and it didn't work on this one. A remote for my 07 Chevy Dually reset it last time the dealer caused this, but none of my remotes will do anything this time. I have power to the other 3 windows and a hot wire to the drivers window that doesn't work. The lock bell will sound when I ground the terminal, but the locks doen't work.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work

I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.

Posted on Dec 07, 2008

  • 2 Answers

SOURCE: power door locks and drivers window have failed on 2004 colorado

I had the same problem to the T. I look online for all the same solutions and I can only tell you what worked for me. Actually what I think worked, HAHA! I went out to my truck and unplugged both battery terminals from battery and placed them together to supposedly reset the electrical system, "so I was told." After this for about 20 min or so, I went back out and in this order; re-installed positive terminal followed by negative terminal to battery. After this I checked locks and windows and surprise they worked. I've seen a lot of people say that all they did was wait and they worked later, so maybe it was that and not what I did, but who cares, they work now. Give it a shot and if it works for you, GREAT let me know, I HATE CHEVY CAUSE OF THIS......they wanted me to pay for a stupid diagnostic before they would help me........well screw you I fixed myself. LATER

Posted on Mar 06, 2009

  • 1 Answer

SOURCE: Power locks and mirrors out. Driver power window out.

Your chevy uses two fuses for the system. The power lock actuators are on the 15 amp fuse inside the truck. The fuse for the switches (locks and mirrors) are under the hood. For 99 to 04 (I think those are the years) there is a TSB on replacing the 3 amp fuse under the hood with a 5 amp fuse because this is a well known problem of having these blow.

Your drivers side window is a different issue. If the rest are working your problem is in the motor or getting power to the motor. The wires that go from the body to the door often crack and break with the opening and closing of the door.

Posted on Mar 11, 2009

stevenhurc
  • 450 Answers

SOURCE: Camry 1996 automatic power lock doen't work, but windows work.

if you can here relays when unlocking/locking check for power at door lock actuators inside doors, if you have power on lock/unlock and good earth from connector actuators are faulty.
if no power on test light when operating check output from central door lock module while operating, none coming out of module then it might need replacing.
check 30Amp power fuse for main relay under bonnet (which goes to pin 8 white/blue on module)and 10Amp gauge fuse in cab(pin 1 blue/red on module),pin 15 is also power when relay is on(red/blue) with test light, and module/ actuators.
check outputs from module pin 3 & 4
blue/red
blue/black
that go to door locks

Posted on Jul 20, 2009

  • 5 Answers

SOURCE: drivers side window in 2005 chevy colorado isnt working but the r

hook your battery back up...

Posted on Dec 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1998 beetle. The locking mechanism on the driver's side quit working a while ago and I have been locking/unlocking the driver's door from the insideafter entering from the passenger side. It has...


Sounds like bad door latches. You may also need a drivers door lock cylinder.
You should be able to start the car by opening the trunk first. That should disable the alarm, disconnecting the battery will not help.

Feb 02, 2011 | 1998 Volkswagen Beetle

Tip

How to fix power window,mirror or door locks on jeeps


On jeeps there is a common problem with the windows,door locks and power mirrors not working. If one or none of these items work on your jeep here is a good tip and 90 percent of the time this is the fix. On jeeps there is a rubber housing inbetween the drivers side door and the fuse panel with wires in it. If you are having problems with all the windows not working unhook the battery then roll the rubber back and look for a broken wire or wires. If there is a broken wire or wires, and there will be, strip the wires and reconnect them with wire connectors. If it is only happening with one door lock or window there is a rubber housing on each door do the same steps on just that door. This will happen and cause either the widows to not work at all or just roll down and not up.

on Aug 25, 2010 | Jeep Grand Cherokee Cars & Trucks

1 Answer

I have a 92 Lexus ES300. I went to roll down the passenger window, accidentally hit both passenger window buttons at the same time on the driver door switch panel. Both windows rolled down about an inch,...


Hi

Thanks for using FixYa. First of all you’ll need to check battery voltage, recharge it if it is low or jump start with another battery charger. Inspect, clean and tight both ends of all battery cables. Also check, clean and tight wiring connections. Check for voltage at relay. If relay has voltage but there is no "click" when key is turned to start, replace relay. Remove starter and inspect drive gear and flywheel teeth, replace damaged parts if necessary. Check to see if voltage reaches starter relay/solenoid when turn to start. If not, check for open P/N switch and brake or clutch pedal switch. Please pry the interior panel and release the inside door locks. If still the issue is not resolved then you’ll need to drill a two inch hole into the latch to access the inside lock link through the interior panel. After removing the panel replaces the latch to resolve the issue. See the picture where to drill---

7988ac4.jpg
Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks
Rylee


Mar 10, 2010 | Lexus ES 300 Cars & Trucks

2 Answers

2005 Colorado drivers side window and remote locking system


Just figured it out and replicated it 3 times..

any type of power/voltage change seems to trigger this issue

The most common symptom is power locks fail and only the driver window quits, however that is on the extended cab.

Steps to fix and it works every time.

take door panel off driver's door
Disconnect the wiring attached to window and power lock control unit
disconnect battery cables
connect the negative to the positive cable(((NO BATTERY CONNECTED)))
This will act to short residual voltage in the system

5 minutes later
place the key in the ignition and turn to the run position
connect the wiring to the window/lock controller
connect the negative cable to the battery
then the positive
open drivers side door
turn key to the off position((do not remove yet)) you should get a series of dings through speakers telling you the key is still in the ignition
once it begins dinging pull the key out and you should hear the door lock solenoids trigger and the windows should work.

Three years and a very unhappy girlfriend who owns the truck. but she's happy now.

Feb 13, 2010 | 2005 Chevrolet Colorado

1 Answer

Power windows of RX 330 from driver side do not work


Did you change or unhook the battery? If so, the power windows can be reset. I believe this is in the manual as well.

reset passenger window by running it down all the way. then run it up and continue to hold the switch up for ~3 seconds after the window is all the way up. that should reset it so it works from the driver's side controls.

I was able to reset the rear windows the same way (I did flip the child lock on the door as well).

Feb 09, 2010 | 2004 Lexus RX 330

1 Answer

Driver side window isnt working but the rest


I believe you need a new switch in drivers door goto a wrecker , new GM ones are $$$$$, happened to me, i just unhooked battery to clear a CEL and had window open at the time ( won't do that again ) and door locks and drivers window won't work ,, checked fuses ,everything good then took door apart and put power to window motor was able to put it up, googled and found lots of people in same boat , hope it works for you ,,,,D

Nov 27, 2009 | 2005 Chevrolet Colorado

1 Answer

2001 silverado 2500 HD diesel. Key goes in, will


I believe that the vehicle antitheft is tied into the drivers door lock. Maybe try disconnecting the battery for 2 minutes.

Oct 24, 2009 | 2001 Chevrolet Silverado 1500

2 Answers

I just go locked out of my X5 BMW 2002 x5 and my


right i had this ***** of a problem 2nd week in jan 2010. a bmw mechanic told to jack car up at front and hook a jumper pack up to live on starter motor terminal and then earth, was quite hard to put croc clip on to starter but did manage it. this was supposed to back charge to battery to get enough power to open car with remote, in theory it should of worked but i gave up after 3 hours-no power. so i got my key put it in drivers door and mechanically turned to open position, then i got a cutlery knife from kitchen and wrapped some insulation tape around tip up 2-3 inches. then i pushed this down glass directly above door handle key end to pry a gap between glass and rubber just enough to slide coat hanger wire in with small hook on end then i manouvered wire hook until i hooked latch arm which i did within 1 minute pulled coathanger wire up and pulled door handle the door opened much to my delight. this was a major sigh of relief after trying for 2 days to get in, and many hours searching the net for a solution which i couldnt find. THIS WORKS 100 percent WITH ABSOLUTELY NO DAMAGE!!!!!!! any questions email me- jimanddiane@live.co.uk

Aug 10, 2009 | 2001 BMW 5 Series

1 Answer

Power windows and power doorlocks won't work


Try replacing your window switch on the drivers front door.

May 19, 2009 | 1992 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...